Question about 2002 Ford Mustang

2 Answers

2002 ford mustang gt map sensor enhancer connection? (for HHO)

I have a HHO generator which boosts my mileage until computer learns and then it dumps tons of fuel, so I ordered a MAP enhancer which is from what I know of electronics just a 10 ohm pot. inline with a signal to/from (not sure) the map (or MAF) sensor. My question is which wire is which under hood or can i connect below dash, etc.?

Thanks for your help in advance.

Erik

Posted by on

  • paul erickson
    paul erickson May 11, 2010

    A water-fuelled car is a automobile that is claimed to use water as its fuel or produces fuel from water onboard,
    with no other energy input. Water-fuelled cars have been mentioned in
    newspapers, popular science magazines, local news coverage, and the internet
    (YouTube); at least some of the claims were found to be tied to investment frauds. This
    article focuses on vehicles which purport to extract their energy directly from
    water, a process which would violate the first and/or second law of thermodynamics

    In addition to claims of cars that run exclusively on water, there have also
    been claims that burning hydrogen or oxyhydrogen in addition to petrol or diesel
    fuel increases mileage. Around 1970, Yull Brown developed
    technology which allegedly allows cars to burn fuel more efficiently while
    improving emissions. In
    Brown's design, a hydrogen oxygen mixture (so-called "Brown's Gas") is generated
    by the electrolysis of water, and then fed into the engine through the air
    intake system. Whether the system actually improves emissions or fuel efficiency
    is debated. Similarly, Hydrogen Technology
    Applications claims to be able increase fuel efficiency by bubbling "Aquyen"
    into the fuel tank.

    A number of websites exist promoting the use of oxyhydrogen (often called
    "HHO"), selling plans for do-it-yourself electrolysers or entire kits with the
    promise of large improvements in fuel efficiency. According to a spokesman for
    the American Automobile
    Association, "All of these devices look like they could probably work for
    you, but let me tell you they don't."

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hello
iwant apictur for my engine air tub coneection and map sensor
thanks

Posted on Apr 16, 2009

MAP enhancers usually wont do the trick for long - the computer will learn the adjustment to the MAF and overide within a day or so usually less than a few minutes.

The computer is best altered using an EFIE to adjust the O2 sensor(s), usually adding between .2 and .3 volts to the O2 sensor signals does the trick - each combo of the HHO and car is slightly different - you have to play with it to find your best setting. You only need to alter the signal on the O2 sensors ahead of the cats as they are the ones the computer uses to adjust the fuel.

Posted on Sep 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 mustang GT serpentine routing


Hope this helps ya.. Cobra... :-)
f9fd01b.gif

Item Part Number Description 1 10344 Generator pulley 2 8620 Drive belt 3 8A528 Water pump pulley 4 3D673 Power steering pump pulley 5 63126 Crankshaft vibration damper 6 2E884 A/C clutch pulley 7 6B209 Drive belt tensioner 8 19A216 Belt idler pulley 9 19A216 Belt idler pulley

Jun 14, 2010 | 2002 Ford Mustang

1 Answer

P236 troub le code 2002 cummins in a dodge 1 ton


Computers and Control Systems: Diagnostic Trouble Code Tests and Associated Procedures
P0236
SYMPTOM
P0236-MAP SENSOR TOO HIGH TOO LONG
WHEN MONITORED
Engine running.
SET CONDITION
Boost pressure signal indicates boost pressure is high when other engine parameters (i.e. speed and load) indicate boost pressure should be low or
boost pressure is low when other engine parameters indicate it should be high.
POSSIBLE CAUSES
- Other codes
- Checking boost pressure sensor
- Checking the 5-volt supply circuit
- Sensor ground circuit open
- MAP sensor
- MAP signal circuit open
- MAP signal circuit STV
- MAP signal circuit STSG
- MAP signal circuit STG
- ECM

Sep 01, 2009 | 2002 Dodge Ram Maxi

1 Answer

I have a 2008 mustang gt with a Whipple HO supercharger, under boost the car is breaking up. the car has MSD coil pack, brisk spark plugs gapped at .030.


it could be something with mass airflow sensor make sure whomever installed the supercharger replaced or reflashed that appropriately

Aug 14, 2009 | 2008 Ford Mustang

3 Answers

Engine temperature sensor located on a 1998 Ford Mustang GT


Left hand side (if facing it), behind distributor, above oil fill.

Apr 22, 2009 | 1998 Ford Mustang

1 Answer

Lighting


Hey rhyeese,
Theres one more thing you can try.
Locate the gearbox, there should be a wire either hanging or not connected properly, connect that as it is the reverse sensor. This sends a signal to your lights as soon as you pop it into reverse.
Hope this helps.

Apr 08, 2009 | 2002 Ford Mustang

1 Answer

Got some problems with my hho


The HHO generator uses low DC voltage to produce Hydrogen and Oxygen from water.

Fresh water isn't the best conductor of electricity so an electrolyte of some sort is usually added to the water.

A safety tip: This was probably included with your unit, but it doesn't hurt to cover it again.
  • Wear safety glasses, good ones.
  • Dont smoke or have any ignition source while checking the unit. HHO is produced at the optimum ratio for combustion, and by that I mean COMBUSTION. This is the same fuel in the same ratio in that big orange tank the space shuttle rides on. The slightest leak can be dangerous. Be aware of this. Ok?
A side effect of these units is they produce heat. The water gets pretty hot, not boiling, but hot. That would be a way to see if its working.

You haven't described the unit, volume of water and electrolyte used. That would be helpful.

As a rule, if the plates are covered in water, if the electrolyte has been introduced, if it has power then it's working and you won't notice any difference at all.

Unless the unit you got is the super deluxe multi-cell model, the volume of HHO produced per minute is only a small percentage of what the engine is sucking in. It's not going to supercharge your engine. It will however enhance the combustion of the gasoline, making it burn more efficiently while adding some combustion of its own.

Hopefully you kept track of your mileage before instrallation. Keep keeping track of your mileage and compare notes. That's when you'll notice the difference.

That difference will depend on the volume of HHO produced. That depends on the electrolytic agent, volume and temperature of the water.

I hope this helped somewhat
Mike

Jan 24, 2009 | 1995 Ford Aerostar

1 Answer

HHO generator wiring


the hho generator power and ground does not go to the maf sensor. what you need is a maf /map regulator, but it has no connection with the generator. it is just helpfull by saving gas if a hho generator is installed. If you have o2 sensors in the exhaust pipe, you need a EFIE first!!! more questions, no problem, hydrotuning@gmail.com, greetings, ****

Oct 05, 2008 | 1995 Ford Aerostar

2 Answers

Map sensor


What car engine?

Sep 03, 2008 | 1988 Daihatsu Charade

Not finding what you are looking for?
2002 Ford Mustang Logo

Related Topics:

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...