Question about 1992 Ford Probe

1 Answer

Wipers My windshild wipper's stopped working. I looked at the fuse box ( inside car ) but didnt see a fuse for the wippers. Am I looking in the wrong place for the fuse? Or do I have other problems.

Posted by on

  • Gary Teaford
    Gary Teaford Aug 12, 2008

    if it is my wiper motor that is bad and thats the resond it's not working, where is it located and is it hard to install?

  • Gary Teaford
    Gary Teaford Aug 27, 2008

    Thanks for your feed back leetamara. Is there a way of testing the wiper motar before getting a new one? and you are also saying that there is "No Fuse" for the wiper.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 702 Answers

Most likely the wiper motor quit working on you. This is very common on the Escorts and Probes.

Posted on Aug 12, 2008

  • Lee Quiroz
    Lee Quiroz Aug 13, 2008

    The wiper motor is located next to the brake booster towards the center of the engine compartment on the upper part of the firewall. It has 2 plugs on it.

  • Lee Quiroz
    Lee Quiroz Aug 27, 2008

    Find the hot and ground wires, remove the plug to the motor and use jumper wires to ground and add power to it and see if it works.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windshild wipper nissan altima


Most probable cause is a nut which is right under the plastic cover at the base of the wiper arm. It may have come loose. It usually is a 12 or 14 mm. You can carefully lift from the bottom end of the wiper, the plastic cover and it will come off. There you will find the nut. Make sure the engine is off and the wiper switch was in the off position before you shut the motor off. Tighten the nut. You will see the base of the arm tilt a little downward as it seats. Snug it up tight (with one hand using a standard length wrench like Craftsman). Try the wiper. Odds are it will work. If it doesn't, the problem is with the wiper transmission which is below the grille you see at the base of the windshield. That repair should be left to a professional.

Apr 07, 2014 | 2009 Nissan Altima

1 Answer

Wiper relay


If u opend the cover where fuses are u will see its written wippers or take each relay and try to turn the wippers if it didnt that is mean its that one then switch it with other one and check

Feb 28, 2014 | 1997 Buick LeSabre

1 Answer

2009 pontiac g6 windshield wipers stopped working. I can move the wippers by hand and there is no resistance at all.. What could be wrong??


sounds like motors shot remove the cowling so you can see more
join a g6 forum find with google

Feb 07, 2013 | 2006 Pontiac G6

1 Answer

My wippers have become very slow and sometimes stops


Firstly check your wipper wheel boxes are nor seized,if they are free then the wiper motor bushes are worn out.Remove the wipers and the link bars and the check the wheel boxes are not seized.If you find they are then oil them with a thin oil and move them back and foth with a plyers untill free then replace.Hope that was usefull pippall.

Aug 24, 2011 | Audi A4 Cars & Trucks

1 Answer

We are trying to figure out wich fuze in the fuze box goes to the delay on the wipper blades.


the one in cavity 20 goes to the front windshild wipers.it is on the left hand side of the fuse panel. for the rear it is the fuse in slot 1 at the top of the fuse panel.

Aug 10, 2010 | 1995 Jeep Cherokee

1 Answer

Golf 2000 Directionals lights, AC and wippers stopped


would look 4 secondary grownd loos are alternator low volt out put look around battery 4 corroded or loose wire

Mar 17, 2010 | Cars & Trucks

1 Answer

Wippers stopped working out of the blue. It is not the fuse. Wippers move when physically moved with hand and do not stop where they are suppose to. There is very little or no friction when doing this. to...


You probably blew a motor, if you have acces to a voltage meter, remove the contacts, turn the wiper switch on and make sure you are getting voltage. If you are, then have the wiper motor checked.

Mar 01, 2010 | 2000 Kia Sephia

1 Answer

MY Fiat stilo windshield wippers front and back


try changing the wiper relay in the fues box, it might be u/s and sending wrong signal to motors hope this helps

Feb 08, 2010 | Fiat Strada Cars & Trucks

1 Answer

My front wipers washer and rear wipper wont work


change the motor ,its under the front wing

Jan 11, 2010 | 2000 Ford Focus

1 Answer

Windshield Wipper switch will not turn off, 2005 Trailblazer


There was a recall on the wiper circuit board cracking and causing the problems your having and at worst the wipers not working. For now you can pull the fuse to the wipers to save the wiper blades, but the problem is the circuit board where the wire harness clips on to the wiper motor cracks and will need to be re-soldered. You can check with the dealer to see if your wiper motor is still covered with the campaign a few years ago, if not you can buy the replacement circuit board at most larger auto parts store like Auto Zone and they can give you the step by step instructions to get the job done. A light tap to the electric motor where the wire harness will also fix this problem, but it really needs to be re-soldered or replaced. Good luck

Dec 10, 2009 | 2005 Chevrolet TrailBlazer

Not finding what you are looking for?
1992 Ford Probe Logo

Related Topics:

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...