Question about 1993 Isuzu Pickup

3 Answers

Oil leak Under the intake manifold there is a little white pipe that looks like somethingshould be attached but there isnt and when the truck rev's it spits out oil. what should be attached if anything or is thisan overflow of some kind?

Posted by on

  • dingo_707 Aug 26, 2008

    I have the same problem I believe. The line comes out under the starter I think and then just runs to the ground all the time . Cannot figure out where it is supposed to hook up. The person I bought it from said he disconnected it cuz it kept getting clogged and does not know where it went.

  • wwwyzzerdd Dec 05, 2008

    was wondering about this when i noticed it in my 92 isuzu pup, it was running but real sluggish and you would have to ease on the throttle and slowly raise the rpms in the engine, if you hit the throttle too fast it would choke and die, it did that for a while then it stopped running period, i thought it might be the float in the carb so replaced that and cleaned the carb out, didnt help, acted like it wasnt getting any gas, so i checked the fuel filter, blew it out and found rust, pulled out the gas tank cleaned it out with some pool cleaner got it real nice and shiny inside, replaced all the rubber fuel lines going to the tank, put 3 gallons of fresh gas in it, and tried to start it, big let down... anyways, got a friend of mine to try to start it while i looked under the hood, and i noticed that everytime the engine would turn over it would shoot oil out of a hose coming from the fuel pump onto the ground, well since i thought the fuel pump might be the problem here, i went ahead and pulled off the fuel pump, basically, im not getting any gas to the engine.. or to the carb, no fuel going through the lines at all, and no gas came out of the fuel filter when i blew it out, so its not sucking gas at all, and the pump is shooting oil out of that hose onto the ground, any thoughts on this? anyone?

    thanks

    -steve

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

This is a maddening problem if you don't know what's going on. If it's like my 92 isuzu pickup with 2.3 litre engine, it's a vent line coming out of the fuel pump which will spit oil out. I had a very hard time figuring out why but finally read that there is a galley in the block where oil runs back to the oil pan. If it gets clogged, oil will come out the vent line of the fuel pump. I even took my head off and tried blowing compressed air and sticking various wires through the block holes near where the fuel pump mounts. Nothing did any good and I was sick of the leaking oil and having to add oil so I bought several feet of oil resistant hose at autozone and routed it from the vent line, back over the engine, and into the dipstick tube. This worked like a champ. No more leaking oil. No more adding oil. Make sure you trim the outside of the hose where it goes into the dipstick with a razor knife or similar, so it will fit tightly. Make real sure you use oil resistant hose or it will break down and get into your oil. Not good. Then use a tie wrap to secure the hose to something else like the brake vacuum hose to keep it in place. I keep my dipstick behind the seat and make sure it's cleaned before and after checking my oil. This truck doesn't use any oil to speak of now and I wish I'd thought of this sooner. Short of removing the engine and having the block flushed and cleaned I don't know what else would have fixed this problem.

Someone else said to replace the fuel pump to fix this problem. I tried that. It did not work. It still spat oil out the vent tube to the tune of about one quart every 150 miles.

I also replaced all the engine seals and gaskets. Front and rear main seals too which were also leaking. So now my oil leaks are a thing of the past. Good luck!

Posted on Oct 12, 2008

Fuel Pump

Posted on Oct 12, 2008


Fuel

Posted on Oct 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

07 saturn outlook 3.6l fwd. leaking oil from under the intake manifold


Did you ever find the source of the oil leak from under the intake?

Nov 15, 2013 | 2000 Saturn SL

2 Answers

89 chevy s-10 blazer 4.3L uses anti freeze but nothing leaks i know its burning it cuz white smoke comes out the tail pipe im trying to decide whether its a intake or a head problem just need another...


If you have white smoke coming out your exhaust, it has to be a head gasket. The symptoms of an intake manifold leak are either and external leak (leaking on the ground) or water in the crank case (mixing with the oil and making it look like chocolate milk-shake) A leaking intake gasket will not cause the antifreeze to enter the combution chambers.

To diagnose which head is leaking, you can remove the valve covers and remove all the rocker arms then put compressed air into each spark plug hole and watch the radiator for bubbles. Looking at the spark plugs may also tell you without having to do this...The spark plug in the leaking cylinder will be very white on the electrode.

Jul 04, 2011 | 1989 Chevrolet S-10 Blazer

1 Answer

It turns over but it will not stay running unless foot is on gas padal. White smoke is coming from tail pipe


Hi,
White smoke usually indicates a blown manifold gasket or head gasket. First, check for coolant in oil. When you pull the dipstick, is the level too high or have a foamy appearance? If so, blown head gasket. If not, spray starting fluid around intake manifold outer mating surface with engine running. ( not near throttle body or air intake) If motor revs up during procedure, locate that area you are spraying and duplicate the motor rev up. If consistent, blown intake manifold gasket. Its always good to have codes checked first if you have a check engine light illuminated....Mike

Jun 24, 2011 | 2000 Toyota Corolla

1 Answer

I have a 1997 Chevy Blazer that is overheating and is leaking coolant. It is not the rad hose because I have already checked that. It is a part that is attached to the engine block, directly above the...


Ihave a 96 s10 lt blazer First of all the steering coloum is now where near the engine block and the bracket you mention is for the throttle cable and the cruise control cable and has no gasket for any kind of a seal with the intake manifold. The 4.3 and most chevy engines have a problem with the intake manifold gaskets if you are over heating then likely the intake manifold gasket is leaking you should check your engine oil for antifreeze that will look like a fomey white yellowey residue and also check the radiator for engine oil floating on the top under the radiator cap. This is a big problem with chevy you can't let espesecly the 4.3 ever over heat.There is olny 8 bolts that hold the manifold to the block and there all in the four corners nun in the middle Y ou can save the engine if you fix it now but it is the intake manifold gasket that is leaking

Dec 12, 2010 | 1997 Chevrolet Blazer

2 Answers

Smoking, ideling rough,


Hi: What Color is the Oil coming out of your Tail Pipe? I'm Assuming its Motor oil and not Transmission Oil.Since you found white looking substance in your oil It sounds like you have a Blown Head Gasket or both.And could be a Crank Block or Head ,Pull your Spark Plugs out, And Have someone Crank engine over and see if you are getting that white Substance Which i assume is Motor Oil.If you are getting ANY out of ANY Spark Plug hole then Is fair To Say you have a Blown Or Cracked Head Gasket.THERES only 1 Other Alternative On Older Vehicles than Yours is ,They Had what was Called a Vacum Modulator That Attached to the Auto Transmission, I worked off of Vacum From The Intake Manifold,And if the Diafram in It went Bad it would **** Transmission Fluid up Through the Intake Manifold and Burn It through your Intake and would come out tail Pipe as a WHITE SMOKE,But it normally would not be in the Enging Oil Or Radiator.So i Would 1st Check the 1st Advise i have Given You.Pull The Spark Plugs. Hope This Helps.Please REply by Voting if this Helped Youat All,Thanks From the WYOCWBOY

May 29, 2010 | 1999 Chevrolet Silverado 1500

3 Answers

Loosing antifreeze but no leaks


The loss of antifreeze with no apparent leaks could be the sign of many things including blown head gasket, cracked tank, or leaking water pump. I would lean toward a head gasket first. Have you checked the oil for signs of antifreeze? A head gasket won't leak until the system is under pressure and running at normal temperature. You could also have a cracked head although that is pretty rare. Check the oil and plugs for signs of anti freeze. Also check the tanks on the side of the radiator they could be cracked which only leak while under pressure. Check all hose connections and if so equipped tranny cooler lines to make sure they are all attached correctly.

May 14, 2010 | 1999 GMC Yukon

2 Answers

I have a 1998 Buick Lesabre that keeps losing antifreeze.


Buick 3.8's are notorious for intake manifold leaks. If you are sure you are not leaking externally (look under the alternator and on the top of the transmission), it could be an intake manifold leak. I've replaced mine...I didn't think it was too hard a job for an amateur.
It could also be a head gasket, but the intake leaks are much more common.

Nov 05, 2009 | 1989 Buick LeSabre

1 Answer

Coolant leak at exit pipe under intake manifold


Could be the water pump, find a pressure tester and hook it up

Jun 05, 2009 | 1993 Dodge Caravan

1 Answer

Oil in the antifreze over flow tank


hi there is there alot of oil in the plastic overflow tank ? what color is it ? when did you notice it ? does the engine run good is it shakey ? take a peek at all ur spark plugs you want them all to look the same slight brownish color is normal. lots of white on the plugs means coolant is getting on them under heat and pressure they get clean too white this is usually a head gasket damaged and leaking a little coolant into cylinder burning and being exausted through the muffler and you might see a white smoke from tail pipe, saying that coolant would not be going in oil that way . if its automatic trans there is a transmisson oil cooler built into the rad now tranny fluid runs through the rad cooling transmission oil coild get from transmission into rad in turn, getting into plastic over flow container. is there coolant in the engine oil ? the oil level will be a little higher than normal if there has been coolant getting into motor ? theres also another way that ive seen coolant enter the oil through the intake manifold gasket its tough to decide ehere the leak is , does it run and idle smooth ?
after a long ride in the hot daytime sun after you turn off let it sit for 20 min then pop the hood and with gloves on swueeze the upper rad hose and check if theres pressure in it dont open cap as im shure you know. if there is a coolant leak depending on how bad it is you will notice that there will be very little or no pressure in you upper rad hose need to pressurize the coolant in order to cool engine correctly. well i hope i havent said to much at once , take a close look at all questions and write me the answers maybe we can pinpoint the problem for you
1 rad transmission cooler
2 real bad head gasket or cracked head
3 intake manifold gasket how does it run and idle
anyhow i hope i helped you a little until next time
bye good luck get back to me please

Jul 07, 2008 | 1992 Ford Explorer

Not finding what you are looking for?
1993 Isuzu Pickup Logo

909 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...