Question about 1994 Chevrolet Suburban

2 Answers

I have a 96 Suburban. The daytime headlights come on, brake lights work, but I have no tail light. Turn signals work as well. I checked all fuses and changed all tail light bulbs.

Posted by on

  • meeder4 Sep 01, 2008

    94 Suburban, same problem....headlights, brake lights, turn signals work, but no tail lights.

  • Smitty509178 Sep 04, 2008

    I have the same problem I need a solution.


2 Answers

My problem was in the trailer hitch wiring. Someone had spliced the wires and the corrosion finally caused one of the wires to crack. I respliced and soldered the wires. All works fine now.

Posted on Oct 15, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

More than likely the circuit board on the taillight housing is bad. Very common. Check for melted plastic or corrosion near terminals on bulb in board. You can buy them at Napa for about twenty bucks per side.

Posted on Oct 15, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Tail light not working. Signal light, brake, and flasher works.

Double check the harness going to the tail lights for burned wires due to daytime running lights and check the bulb socket for signs of burned contacts. Clean the contacts with small flat file then try the new bulbs again. Also, check the eltrical flow to the bulbs (ground and positive flow). After elimating no issues with wires or contacts and and problem with flow test the fuse then check the actual headlight switch assembly. Hope all this info helps, sorry I am out of order on a lot of it.

Oct 01, 2015 | 2012 Acura TL

1 Answer

How do I fix the tail lights and headlights on my 2000 Chevrolet CavalierI have brake lights and turn signals

Did you check the fuses RT HDLP 15amp. LTHDLP 15amp in the instrument panel fuse block ? These are for the headlamps ! Also check EXTLAMP fuse 20amp in same fuse block. If those are good your going to need a Headlamp switch . I could tell you to check for battery + voltage at connector 1 pin D an F at the headlamp switch with park lamps on ! this is to see if voltage is going through the switch . You could do the same for the headlamps , Connector 2 pin C is low beams an pin B is high beams ! Connector 2 pins A an E are grounds , need to check those as well . But first you'll need to take plastic cover from around the upper steering column to get at the switch ! piece of cake ! good luck ....

Mar 07, 2015 | 2000 Chevrolet Cavalier

2 Answers

Dash and tail lights not workjng brake and turn signal on passanger side not working

The dash and tail lights are on two different circuits, and the brake and turn signals are on different circuits, so at least 4 circuits total.
I would start at the headlight switch and check for power on the first two issues.

Jan 18, 2014 | 1990 Buick Century

2 Answers

I have 89 bronco 2 my brake lights turn signals both work my tail lights don't work have check fuse n blubs what might be the problem

The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?

Feb 25, 2013 | 1987 Ford Bronco II

2 Answers

My lights wont come on ive changed fuses and bulbs what can problem be please n thanx

you may have a bad switch for the lights.if the fuses and the bulbs are good,you don`t say if your talking about the headlights tail lights,dash lights,signal lights brake lights,low beam lights high beam lights or both.i`m assuming headlights.if you have a daytime headlights,the relay in this car it could have gone bad as it is tied into the regular headlight system.

Apr 05, 2011 | 1996 Pontiac Sunfire

1 Answer

2001 Ford Focus... No park/tail/brake lights!

Headlights and brake lights will not come on with ign. switch off. The running lights should come on. Check fuses.

Sep 26, 2009 | 2001 Ford Focus

1 Answer

Brake lights dont work, Turn Signals all goofy

First thing i would do is chg. the break light switch, and make sure to chk. all grounds around tailights, sometimes if there is a ground problem it will travel back thru the hot wire to get a ground, witch in turn makes everything go wackey.

Mar 10, 2009 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
1994 Chevrolet Suburban Logo

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

71231 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7001 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides