Question about 2004 Honda Odyssey
Just had my a/c serviced and recharged and it quit again. The air flow would not change from to top to bottom to defrost, etc., when I pressed the mode button ( automatic air conditioning system). The temperature of the air didn't even get very hot when I turned the dial clear over to hot. WHAT IS GOING ON??
There is a switch that controls the air to move from def. to vent to floor find out if it is an elec. contrl or vacuum controled vacuum lines are comon for breaking if this is the case replace vacuum line this should fix the control problem also check all fuses and relays for problems
Posted on Jul 10, 2009
It sounds like a vacuum leak or blend door problem.
Posted on May 08, 2009
SOURCE: Honda Odyssey doors
I read about this issue while I was looking for a fix to mine. Try the following:
Remove fuse #13 for 30 seconds or more from the passenger side fusebox. This will reset the door and the clock.
1.) Disable the power door switch on the left dashboard.
2.) Remove the power door fuses located under the front passenger leg area.
3.) Manually open and close both sliding doors.
4.) Restore the power door fuses located under the front passenger leg area.
5.) Enable the power door switch on the left dashboard.
6.) Try opening the sliding doors.
Posted on Sep 03, 2008
you have to replace the resistor under the passenger side dash. the wires coming from the blower motor runs to it. if it is back the module wont let the a/c work. common problem. easy fix
Posted on Sep 06, 2009
Sorry for the delayed response. For future reference, the blower motor resistor in an 04' Honda Accord is located under the glove box and a little to the left if you are facing it (the glove box). You just need to pull out the plastic panel (yes, you can just pull it out by hand, no tools needed for that). It should be right on the fire wall with a plug going into it. If you reach in there and pull the plug (it has a little notch so it clips into the resistor more securely; make sure you push the clip in) it should have 4 flat prongs on it that go into the resistor. The resistor itself will have 2 phillips head screws that are holding it into the fire wall. Unscrew them and you have the resistor. If you can unscrew both screws before unplugging, it will be easier to see how it unplugs. I know this sounds complicated but once you get in there you will notice it's fairly easy to change out.
Posted on Apr 23, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Lets get started. Place the key in the ignition and turn as if to start your minivan - but do not actually start your Odyssey.
Jan 25, 2011 | 2005 Honda Odyssey
Welcome to FIxYa.com
First check the heater control valve install a piece of 10mm hose to top so cable will not come off ( see diagram)
Check coolant level, do you have heat at defrost?, if not --replace heater core and flush coolant.
Regards, Lee Davidian
Thank you for using FixYa,com.
Oct 23, 2010 | 2000 Honda Odyssey
Jul 09, 2010 | 2004 Honda Odyssey
Apr 08, 2010 | 2007 Honda Odyssey
Mar 03, 2010 | 2004 Honda Odyssey
Dec 20, 2009 | 2004 Honda Odyssey
Jul 18, 2009 | 2004 Honda Odyssey
Nov 28, 2008 | 2004 Honda Odyssey
804 people viewed this question
Usually answered in minutes!