Question about 1993 Jeep Grand Cherokee

1 Answer

Engine my jeep grand cher will rotate but will not turn over

Posted by on

  • Richard May 11, 2010

    Dude, you got to say a little more than this.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 25 Answers

How long do you hold the key? have you checked to see if it sparks? how long does it turn over before it stops (if it does?)

Posted on Aug 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 jeep cher key want turn ing


u might have to have someone push the car back and forth so that the key will pop lose. is the steering wheele locked too?

Dec 23, 2011 | 1999 Jeep Grand Cherokee

1 Answer

My coolant sensor is bad on 1998 Jeep Grand Cher Laredo TSI V8 5.2 4X4 is flashing in control panel.


Trace the upper radiator hose toward the Grand Cherokee's engine until you reach the metal component connecting the hose to the engine -- this is the thermostat housing. Find the coolant temperature sensor -- the electrical component on the thermostat housing. Press the locking button on the coolant temperature sensor wiring harness and pull the wiring harness from the sensor, then remove sensor it screws out. when putting in new sensor coat the threads with teflon pipe thread tape so there is no leaks.

Oct 27, 2011 | 1998 Jeep Grand Cherokee

1 Answer

I need the firing order for a 1994 Jeep Grand Cherokee Straight 6 engine


For 1994 Jeep Grand Cherokee:
2WD and 4WD have the same
4.0L In-Line 6-Cylinder:
Firing Order:

1-5-3-6-2-4
Cylinders:
(back)
...6
...5
...4
...3
...2
...1
(front)

Distributor:
....(back)
.....5....3..(+)-screw
1.............6
(+).4....2

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

May 20, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Where can the oil pressure sensor be found a 2001Jeep V8


The sensor is located on the left side of the engine,
below the exaust manifold. Hope this helps.

Feb 04, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Replace serpentine belt on a jeep grand cher w/4.7 liter engine


It's posted inside the hood. Lift hood, look on passenger side.

Nov 16, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Crankshaft sensor located 98 jeep grnd cher 4wd 6cy


it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps

Sep 23, 2009 | 1998 Jeep Grand Cherokee

1 Answer

1999 Jeep Grand Cher LTD. No brake lights when brake is applied. Brake lights come on when lights are turned on (should be tail lights)Help!


ok check fuses first then replace light in back allot the time one the light will short out the other lights happen on my jeep and honda civic
trash the light in back start fresh see if that works if not dont throw the other light away

Jul 12, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Cost to replace rear main seals on 2001 jeep gr. cher. ltd.


Actually yeah you are in luck that combination only requires dropping the oil pan. The seal is actually fairly easy to do it yourself, if your inclined. Parts about $20.00 and it's book rate is 5 hours. around here shops charge around $85/hour. About $500.00 out the door or under $50.00 if you want to get greasy. Here's a good picture guided step by step on a Jeep CJ with a 4.0 liter, yours is pretty much the same:

http://jeepin.com/features/rearmain/index.asp

May 22, 2009 | 2001 Jeep Grand Cherokee

1 Answer

How easy is it to replace the radiator a 02 jeep grand cher. 6 cy


I have tons of experience...for me, its about a 2. If you have little experience, about a 6 (on scale of 1-10) if you get a manual to give you some guidance, it should not be a terrible job, but may take a while. Always use flair nut wrenches on trans line fittings, Check fasteners before you start...some may be torks head and lots of people don't have them on hand (available wherever tools are sold)
Take care not to damage core of unit when removing or replacing.
Any technical questions along the way, just ask!!!

Apr 16, 2009 | 2002 Jeep Grand Cherokee

1 Answer

199 jeep grand cher 4.0 engine cut off while driving,sometime it will not start. some time it will start up right away some time it may not start untin the next day it turn over very well good battery and...


sounds fuel or electrical primary side related.... check fuel pressure...if ok then go to trigger and be sure it is firing when cranking...good luck

Dec 16, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...