Question about 1994 Jeep Grand Cherokee

1 Answer

94 Jeep Cherokee won't start

So, how do I test the ignition module? Thanks!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 372 Answers

Autozone can test the module for you easily. Just one suggestion for you ask them to test it more than once. I would test 4 or more times. Most modules fail under load when they get hot. Testing it will heat it up so testing will be more acurate. It could pass cold and then short out after it gets warm.

Posted on Aug 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ignition module in a 94 jeep cherokee


Change your ignition coil. Mine wouldn't start in the cold. I had to give it gas & it would backfire until it warmed up.

Apr 07, 2013 | 1994 Jeep Grand Cherokee

1 Answer

94 Jeep Grand Cherokee Limited not shifting in any gears


You need to have the transmission control module tested for fault codes, AAMCO does this testing for free.

Nov 04, 2012 | Cars & Trucks

1 Answer

1988 jeep won't start


Not sure if I read your post right, but you have to have a hot wire to the ignition switch from the battery, independent of anything else on the car, before the switch will work.
The CPS is a common problem on the jeeps, though. If bad, you may not get a coil signal.

Jun 10, 2012 | 1988 Jeep Cherokee

2 Answers

My 1998 jeep cheorkee engine turns but won't crank, could it be the computer or what?


it's highly unlikely, there are only two things that can make this happen, not getting fuel (fuel pump failure, fuel pump regulator) or not getting ignition (bad coils, ignition module failure, bad distributor, distributor cap, rotor)

Jun 24, 2011 | 1998 Jeep Cherokee

1 Answer

94 jeep cherokee ign switch problem.


it sounds like the power wire came off or broke from the ignition switch ,if you can test each wire with the column
cover off,you should be able to determine which one powers the fuse for turn signals

Nov 23, 2009 | 1994 Jeep Cherokee Country

2 Answers

94 Jeep Cherokee won't start


I believe the green wire is a pulse from the distributor and its a ground signal. I could be wrong since is been a while since i left the jeep dealer...I would take the coil out (2 bolts on most) and take it to autozone. They can test it in minutes for free. Either that or the ignition module but more common is coil.

Aug 06, 2008 | 1994 Jeep Grand Cherokee

1 Answer

94 Cherokee won't start


check the ecm and the crankshaft positioning sensor both will keep it from firing

Aug 05, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...