Question about 2007 Kia Sorento 4x4

1 Answer

Oil sump drain plug

Hi can anybody tell me the size of socket to remove sump oil drain plug;

cheers Tony.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 319 Answers

Most likely a 17MM

Posted on Feb 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change my oil


Hi Katie,
Run the engine for a few minutes to warm up the oil. Switch off engine Remove the oil filler cap which is on the top of the rocker box. Then. Unscrew and remove the oil drain plug which will be located on the underside of the sump. The plug is usually made of brass and measures about one inch across. NOTE a) the oil could be hot!, b) make sure that you have a bowl underneath the sump to catch the oil in.
Once the oil has drained out you should remove the old oil filter andreplace it with a fresh one.
Finally, replace the oil drain plug BEFORE refilling with fresh oil.

Aug 08, 2015 | 2010 Kia Forte

1 Answer

How do I access oil filter & drain plug


remove sump guard drian plug a little to the rear of sump .oil filter half way up engine block ,hope all goes well

Mar 24, 2014 | 2002 Land Rover Freelander

1 Answer

SUMP PLUG REMOVAL


Hi there
Well there is a few ways to remove a rounded sump plug and the best way will be to either drill a center hole [small] then let it drain out the oil, then drill out with a bigger one and use a easy out to un do it [ but when its out put some of the old oil back in to wash out any swarf ] replace new plug with new gasket washer but dont over tighten when replacing .
THE other way is to tap it with a screwdriver and hammer but only lightly and on the plug only. and do it after a run so the oil and sump plug are hot.

Mar 11, 2014 | 1993 Isuzu Amigo

1 Answer

2009 Saturn Vue; Any pictures of where the oild drain plug is?


hi Phil, The drain plug will always be at the lowest point on the bottom of the oil sump. can't send you a picture but I'm sure you can find it. you'll probably need to remove the plastic covers underneeath. Regards JohnJohn

Nov 27, 2011 | 2009 Saturn VUE

1 Answer

How do I remove the engine oil drain cap?


The engine oil drain plug is located directly underneath the engine on the sump. You will need a 15mm wrench or socket to remove it. I hope this helps.

Aug 03, 2011 | 2003 Land Rover Freelander

1 Answer

Where is the oil drain plug located on the 2002 saturn vue 2.2 litre 4 cylindr


the oil drain plug is on the engine sump,you will have to get under the vehicle to see it, it may be at the end of the sump or it could be on the side towards the rear.....hope this helps......cheers

Aug 10, 2010 | 2002 Saturn VUE

2 Answers

Where is the oil drain plug on a 99 Audi A4 1.8L Turbo?


Hi,
The standard drain plug is on the rear of the sump on the bottom edge slightly right of centre the bolt is a 17mm hex socket type, you have to remove the under shield first to see it,It is possible someone has changed the original bolt for a bigger one as they are prone for tearing the threads out of the aluminium sump ,

Jul 15, 2009 | 1999 Audi A4

1 Answer

1997 Mercedes Benz C280 - oil change


hello,sorry,i just read your comments,better to remove your sump guard,(be careful),to see the oil drain plug,

Apr 21, 2009 | 1994 Mercedes-Benz C-Class

1 Answer

1999 passat oil drain plug


get the correct size socket 19mm put it on the sump plug and strike it several times firmly to shock it.its stuck due to a steel/aliminium conflict

Jan 20, 2009 | 1999 Volkswagen Passat

1 Answer

Honda accord 1991 oil change


You are referring to the drain bolt on the oil pan? You can use a crescent wrench. I have a 92 and I can never remember what size the drain bolt is, so I always go under with my trusty adjustable crescent wrench. Let me know if u need more info.

Nov 11, 2008 | 1992 Honda Accord

Not finding what you are looking for?
2007 Kia Sorento 4x4 Logo

Related Topics:

339 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

yadayada
yadayada

Level 3 Expert

64034 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...