Key is stuck in ignition, wont turn all the way back to remove it...if it helps, the steering wheel wont lock either

Jeff provides the best answer.

• Jeff Armer Jun 03, 2022
• Does the key turn to the off position an to start an back to off again,gear shifter is in park ?
• 
  Jeff Armer Jun 03, 2022
  Ignition Key Cannot Be Removed from the Ignition Lock Cylinder
  
  Is the vehicle equipped with a manual transmission?
  
  Turn the ignition key to the OFF position.
  
  Can the key be turned to the OFF position and be removed?
  Go to Step 8
  Go to Step 5
  
  5
  Verify the adjustment of the automatic transmission shift cable. Refer to Range Selector Lever Cable Adjustment .
  
  Can the key be turned to the OFF position and be removed?
  System OK
  Go to Step 6
  
  6
  Inspect the Steering Wheel Theft Deterrent Lock.
  
  Does the Steering Wheel Theft Deterrent Lock exhibit damage or signs of wear?
  Go to Step 10
  Go to Step 7
  
  7
  Verify the electrical operation of the ignition lock cylinder solenoid. Refer to Ignition Can/Cannot Be Turned Off with Transmission in Any Gear .
  
  Can the key be turned to the OFF position and be removed?
  
  8
  Inspect for a faulty lock cylinder.
  
  Is the lock cylinder damaged?
  Go to Step 11
  Go to Step 9
  
  9
  Inspect the ignition lock cylinder case.
  
  Is the case worn, damaged or loose?
  Go to Step 12
  Go to Step 13
  
  10
  Replace the Steering Wheel Theft Deterrent Lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  
  Did you complete the repair?
  Go to Step 13
  --
  
  11
  Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  
  Did you complete the repair?
  Go to Step 13
  --
  
  12
  Replace the ignition lock cylinder case housing. Refer to Ignition Lock Cylinder Case Replacement .
  
  Did you complete the repair?
  Go to Step 13
  --
  
  13
  Operate the system to verify the repair.
  
  Did you correct the condition?
  

the ignition module (ignition switch on top of the steering column) normally doesn't get stuck.

things you can try:
steering wheel lock: (the pin gets a "burr" on it and locks everything up) wiggle steering wheel back and forth while trying to turn key.

transmission lock (parking on an incline will jam up the interlock)
push the shifter farther into park while trying to turn the key, or wiggle shifter

some of these electric interlocks require the brake pedal stepped on for releasing..have you tried that? along with shifting fully into park a few times?

Turn the steering wheel anticlockwise or to the left and turn the key.

The steering wheel was turned when the key was removed. So when you try to turn on the key, turn the wheel one way and the other way to release the pressure on the key. The key should turn ok.
Hope this helps.

It can be faulty ignition lock cylinder.I suggest to wiggle the steering wheel a bit and see if the key gets released out.If that is not helping then first turn steering wheel to right and try removing the key,or next turn steering wheel to left and see if you can remove the key.
----------
Spray wd-40 in the ignition key hole and let it remain there for few minutes,after that once again try to remove the key and see if that helps.
---------
But if that is not helping then ignition lock cylinder has to be removed out and key has to be manually removed.
-----------
For more troubleshooting on these types of issues,i suggest you to refer the help links mentioned below.Its the accurate solutions mentioned in it.that will help you to narrow the problem:-----
Click the link below:------

-----------

1999 Toyota Camry: Key Will Not Come Out Of Ignition?

http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-key-will-not-come-out.html
---------------

2001 Toyota Tacoma: Ignition Locked?

http://technoanswers.blogspot.in/2012/04/2001-toyota-tacoma-ignition-locked.html
------------

Ignition Switch Will Not Turn Off?

http://schematicsdiagram.blogspot.in/2012/04/ignition-switch-will-not-turn-off.html
-----------

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

-----------

Ignition Key OFF but engine still running?

http://howtobyme.blogspot.in/2012/03/ignition-key-off-but-engine-still.html
--------------

Chevrolet Malibu: Key Stuck in ON position?

http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html

2012 Dodge Ram: Ignition Key will not release?

http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html-----------

Ignition locked up on Mercury Villager?

http://technoanswers.blogspot.in/2012/01/ignition-locked-up-on-mercury-villager.html-------------

Key won't turn in the ignition on Toyota land cruiser?

http://technoanswers.blogspot.in/2012/02/key-wont-turn-in-ignition-on-toyota.html

-------------------

How to remove ignition switch on VW Car models?
http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html
-------------

How to Replace Ignition Switch on Chevrolet Caprice Classic?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html

-----------------

1995 Ford Taurus: Ignition switch not turning OFF?

http://repairhelpcenter.blogspot.in/2012/06/1995-ford-taurus-ignition-switch-not.html
-------------

Ignition Problem Troubleshooting

http://whoisbyme.blogspot.in/2012/07/ignition-problem-troubleshooting.html
------------------These will help.Thanks.

In the fuse block under the drivers side rear seat check the ignition 0 fuse. In the under hood fuse block check the B/U fuse and the BTSI fuse. If the b/u fuse is blown than you would not have back up lamps.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Try jacking up the front wheels off the ground & then turn steering wheel back & forth while turning ignition key.

The steering wheel lock is a metal prong that protrudes into the steering shaft from within the ignition lock assembly, that is held on by two security screws pointing upward underneath the plastic steering column covers. You can remove the 2 screws and check out the working of the mechanism. It's probably stuck. Most likely, when you put on the new steering wheel, you simply twisted the ignition assembly and it is now causing the steering lock to be wedged on in the lock channel. Try twisting it back the other direction with your hands and I'm pretty sure it will allow the spring loaded locking mechanism to release. This same problem happened to me and took me a while to troubleshoot what was going on in the mechanism and figure it out. If twisting it both directions and checking to see if it releases with the key turned doesn't fix it, just remove the ignition assembly and lubricate the locking mechanism bolt and that will fix it for sure.

This (plate) is held in place with a snap ring.You will need a special press to remove it and also a steering wheel puller to access the ignition lock cylinder.The actual switch is located on top of the steering column above the brake pedal. It is actuated with a rod from the ignition lock cylinder.