Not much access to the spark plugs - Astro Chevrolet Cars & Trucks

On what type of vehicle???

The spark plugs are located under the plastic trim on top of the head remove this and you will see the plug leads, pull them out and there are the spark plugs

Remove the cowling that the windshield wipers go through.
This piece is removable. On my ford the wiper motor comes off with the cowling.
This is the trick.

Here's a link that will help you. I've included the info that you need to locate the plugs below. Good luck!

http://www.ehow.com/how_4484637_replace-spark-plugs-oldsmobile-alero.html

To gain access to the spark plugs and spark plug wires do the following. In a 2.4 liter engine, remove the ignition coil and module assembly from the top of the engine to gain access. In this Alero model's engine, the spark plugs run down the center of the engine. In a 3.1 liter engine, remove the air cleaner to gain access. The spark plugs are located next to the engine oil reservoir. For a 3.4 liter engine, remove the windshield wiper module cover and rotate the engine for service access. For a 2.2 liter engine, the spark plug wires are located across the top of the engine and require no components to be removed for access to the spark plugs.

THE CHRYSLER SEBRING HAS 2.5 - 2.7 - 3.0 ENGINES THEY ALL HAVE 6 SPARK PLUGS. ON THE 2.5 AND 3.0L ENGINES TO GET TO SPARK PLUGS YOU HAVE TO REMOVE UPPER INTAKE MANIFOLD FOR ACCESS THE SPARK PLUGS IN THE REAR CYLINDER BANK.THE 2.7L ENGINE WITH COIL OVER PLUG DISCONNECT THE COIL CONNECTOR AND REMOVE THE BOLTS THEN LIFT THE COIL OFF FOR ACCESS TO THE SPARK PLUG.

Platinum (or more precisely-AC Delo Iridium) spark plugs. The six spark plugs are directly under each of the six coils on top of the camshaft cover. The air intake needs to be removed, then each of the 10mm bolts for the individual coils. The coils can then be removed and the spark plugs accessed.

Remove plastic cover over the engine ( three screws).
You then have access to the front three spark plugs (cylinders 1,3,5) remove the nut which holds down the independant coils and remove the spark plugs, fit new spark plugs and fit coils on the three front cylinders.
Now it gets a little tricky, you will only be able to access number 2 back cylinder so you have to remove the induction manifold (12 bolts I think) to access the back three cylinders (2,3,6,) properly.
Then proceed as with the front three spark plugs, refit manifold and plastic cover,

You didn't specify whether you have the (4) cylinder or the (6) cylinder engine..... I have a 2004 Hyundai Sonata 2.4L 4 cylinder and I just changed the spark plugs in it. I believe that the 2005 2.4L engine is the same. To locate and change the (4) spark plugs on a 2004 Hyundai 2.4L 4 cylinder engine: Remove the (4) 12mm bolts from the decorative plastic engine cover. Remove plastic cover from engine and place it off to the side out of your way. Standing in front of the car, the (4) spark plugs are located laterally (left to right) in the recessed area underneath where the plastic engine cover was removed. Note: This engine has (2) coils....They are located above spark plugs number (2) and (3) from left to right. Starting with the fist spark plug on the left: Remove the spark plug cable by pulling straight up on the insulated connector. Using a spark plug socket, remove the old spark plug and install a new one in it's place. To access the second spark plug from the left, remove the electrical connector and the spark plug cable wire from coil number (1) and then remove the (2) 12mm bolts that secure the coil to the engine. Spark plug number (2) is located directly under the coil. Lift the coil straight up removing the insulated connector from spark plug number (2). Using a spark plug socket, remove old spark and install a new one in it's place. Repeat same procedures for spark plugs number (3) and (4). Note: If you have the (6) cylinder engine, the front (3) sparks pluge are readilly accessible but in order to access the (3) rear spark plugs, you will have to remove the intake manifold

To locate and change the (4) spark plugs on a 2004 Hyundai 2.4L 4 cylinder engine:
Remove the (4) 12mm bolts from the decorative plastic engine cover. Remove plastic cover from engine and place it off to the side out of your way.
Standing in front of the car, the (4) spark plugs are located laterally (left to right) in the recessed area underneath where the plastic engine cover was removed.
Note: This engine has (2) coils....They are located above spark plugs number (2) and (3) from left to right.
Starting with the fist spark plug on the left: Remove the spark plug cable by pulling straight up on the insulated connector. Using a spark plug socket, remove the old spark plug and install a new one in it's place.
To access the second spark plug from the left, remove the electrical connector and the spark plug cable wire from coil number (1) and then remove the (2) 12mm bolts that secure the coil to the engine. Spark plug number (2) is located directly under the coil. Lift the coil straight up removing the insulated connector from spark plug number (2). Using a spark plug socket, remove old spark and install a new one in it's place.
Repeat same procedures for spark plugs number (3) and (4).
Note: If you have the (6) cylinder engine, the front (3) sparks pluge are readilly accessible but in order to access the (3) rear spark plugs, you will have to remove the intake manifold.


please rate!

The plugs are accessible from the top of the engine, there is an individual coil pack over top of each spark plug (they are kinda egg shaped and they have a little heat sink in them) just pull these out and below you will find the spark plug. you may have to remove the air intake to gain access to them.