Question about 1990 Toyota Corolla

Open Question

Wiring color code for ae92 retract mirror

I replace my manual mirror with a retractable one. unfortunately i got them without the connectors which is not correspond with the colors from relay wires and switch. is there anyone who could help me with my quest?

Posted by on

5 Suggested Answers

  • 8 Answers

SOURCE: retractable seat belt wont close

Is this a NEW seat belt?  Or a junkyard part... Per the Toyota 1988 Repair Manual - the belt is allowed to be pulled out at a tile of 15 degrees or less; and cannot be pulled out at over 45 degrees of tilt.

Your problem is the belt is not retracting.  The manual states to replace the assembly.  It also states: "Whenver installing a new belt assembly, verify proper operation before installation."

If a new part does not have proper operation; have it replaced. If this is a 'used'  new part - get a NEW seat belt.

Posted on Apr 18, 2009

  • 25 Answers

SOURCE: heated wing mirrors not working or retracting,also

this is controld bye the comfort unit ecu under the seat. you may have fault on te viring on the flor se left side if there are som green stuff on the viring

Posted on Dec 04, 2009

  • 30 Answers

SOURCE: the rear spoiler on my 1995 911 porsche carrera will not retract

There is a control computer for the wing under the passenger side dash. Check to make sure the connector to this computer did not come loose.

Posted on Feb 04, 2010

emissionwiz
  • 70374 Answers

SOURCE: Radio/CD player Wiring

Here are the correct factory radio wire colors with definitions.

Car Radio Battery Constant 12v+ Wire: Blue/Yellow
Car Radio Accessory Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: Black/Red
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 6 1/2′
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Purple
Right Front Speaker Positive Wire (+): Green
Right Front Speaker Negative Wire (-): Blue
Car Audio Rear Speakers Size: 6 1/2′
Car Audio Rear Speakers Location: Side Panels
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White
-->

Posted on Oct 17, 2008

  • 1 Answer

SOURCE: 1991 Toyota Camry Automatic seatbelt harness

http://www.toyotanation.com/forum/showthread.php?t=300887
Full version about Automatic Seatbelt troubleshooting for 87-91 Camry written by Professor Oleg Turkin

Posted on Jun 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to retract exterior mirrors


If power operated use mirror adjustment switch. Turn and point knob arrow down toward mirror icon. If not power pull them in by hand with a little force.

Mar 01, 2015 | 2014 Audi A4

1 Answer

Electic mirrors not retracting after one was knocked


More than likely the little plastic gears inside the mirror are broken or striped. I honestly wish the automobile industry would design a better electric mirror motor and gear adjustment system. Because it litterally doesn't take much at all to break of strip them. You will have to replace the motor and gear assembly inside the mirror, but it maybe easier to find a working mirror assembly in a savage yard. They are fairly easy to replace. Remove the inside door panel trim. Remove to two or three bolt the hold the mirror assembly to the door and unplug the wiring harness connector. Then reinstall everything in the opposite as removal. Hope this help.

Nov 28, 2012 | Cars & Trucks

1 Answer

I NEED A SIDE DOOR WIRING DIAGRAM FOR A2005 BUICK TERRAZA


I had to cut the retracting wire for opening the door as it got jammed could not close door without chime going all of the time . I removed the fuse which solved the noise problem except now my radio and clock will not work . I know the chime goes through the speakers . How can I disconnect the wire from the door and put the fuse back in the get my radio and clock working . I do not plan to replace the retraction wire for the automatic door

Jan 29, 2012 | Buick Terraza Cars & Trucks

1 Answer

05 gmc sierra power mirrors will not retract


first check for blown fuses, then for obstructions, then check the operation of the switch, hold switch in retract position and gently tap and wiggle mirror

Oct 02, 2011 | 2006 GMC Sierra

1 Answer

2003 gmc mirrors do not fold in


The power mirrors are controlled by a module (computer) DDM - drivers door module an the PDM - passenger door module .
Folding Mirror System
Folding Mirror System Controls
The folding mirror system requires signals from 2 separate switches. The mirror select switch must be in the neutral/fold position and the mirror direction switch must be activated to the left/extend or right/retract positions. Both switches are integrated into the DDM and provide direct signals.
Folding Mirror System Operation
Upon receipt of the required switch inputs the DDM will supply battery voltage and ground to the mirror fold motor control circuits to perform the requested extend or retract function. The DDM will also send a class 2 message to the PDM indicating the requested function. The PDM will supply battery voltage and ground to the mirror fold motor control circuits to perform the requested extend or retract function.

Power Mirror System
Power Mirror System Components
The power mirror system consists of the following components:
• The driver door module--Class 2 module with integrated switches and requires programming when replaced
• The passenger door module--Class 2 module with integrated switches, requires programming when replaced and also contains the RFA receiver
• The power mirror direction switch--Integrated into DDM and is a 4-position momentary switch that provides a signal input to the DDM for up, down, left/extend and right/retract with a mirror switch activation
• The mirror select switch--Integrated into DDM and is a 3-position switch that allows the operator to select the left or right mirror and also a neutral/fold position
• The left outside power mirror--Contains both the vertical and horizontal mirror motors and is serviced as a complete mirror assembly
• The right outside power mirror--Contains both the vertical and horizontal mirror motors and is serviced as a complete mirror assembly
• The body control module--Class 2 module that requires programming when replaced, serves as the power mode master and is the main message handler
• The DDM 10A fuse--Located in the I/P fuse block and is hot at all times
• The PDM 10A fuse--Located in the I/P fuse block and is hot at all times
• The memory switch, if equipped with memory mirrors--Supplied power by the DDM and provides a voltage signal to the DDM upon a switch activation
• The horizontal and vertical position sensors, if equipped with memory mirrors--Supplied a 5-volt and low reference by the DDM/PDM and provide a variable voltage signal to the DDM/PDM that is proportional to mirror position
• The park neutral position switch, if equipped with memory mirrors--Provides transmission gear selection information to the PCM and is used for memory recall and mirror tilt in reverse functions
• The powertrain control module, if equipped with memory mirrors--Class 2 module that requires programming when replaced and provides Class 2 message indicating transmission gear selection
• The driver information center (DIC), if equipped with memory mirrors--Part of the instrument cluster which is a Class 2 module that requires programming when replaced and is used to personalize the memory recall and mirror tilt in reverse functions
• Fold motor in each of the outside mirrors, if equipped with power fold mirrors--Provides extend and retract movements of the mirror and is serviced as a complete mirror assembly
Each of the outside power mirrors contains 2 reversible motors to provide horizontal and vertical movement of the mirror glass. The vertical motor operates the up and down directions and the horizontal motor operates the left and right directions. If equipped with power folding mirrors, each outside power mirror will contain a reversible fold motor to operate the extend and retract functions. Each of the mirror motors are circuit breaker protected.
DTC B1722
The driver door module (DDM) and passenger door module (PDM) switch the mirror fold motor control circuits to battery voltage and ground in response to mirror extend or retract command.

Apr 06, 2017 | 2003 GMC Yukon XL

1 Answer

Seat belt will not retract. how do i fix it?


The mechanism that allows it to retract is broken. Replace the seat belt.

Jul 15, 2009 | 2004 Dodge Grand Caravan

1 Answer

Color code 91 Buick Electra


Colors will be the same on both ends ( the switch and the mirrors . Unfortunately both left and right mirrors have the same wiring colors. Check electical flow through the mirror switch so as to know which wire controls left mirror and which wire controls right mirror, to insure you don't re-wire in error . Hope this helps

Apr 26, 2009 | 2004 GMC Yukon

1 Answer

SRS (air bag) warning light


hi from uk the air bag indicator light is also linked with the seat belt restraint system these will retract if involve in impact? the wires run under seatsand have plug connectors these sometimes become loosened with seat movements to+frow also inadvertant dislodge withh vac hose when cleaning carpets? try pulling connectors apart and reconnect then see if light goes off

Sep 09, 2008 | 1991 Saab 900

1 Answer

Right Hand mirror doesn't retract


i would check the switch first and also the passenger side door jamb wire harness also i know it sounds simple but ALWAYS check ALL of you fuses before beginning any electrical fault tracing, try removing the switch and identify which wire powers the mirror and manually jump power with a paper clip to the mirror in question there should only be three wires one will have power and the others will be left and right mirror retraction if this works your switch is bad if not go to the mirror and power that manually and if no dice you got a bad motor -jeff

Jul 14, 2008 | 2001 Honda Civic

Not finding what you are looking for?
1990 Toyota Corolla Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...