Question about 1992 Oldsmobile Cutlass Ciera

1 Answer

Blinker fuse box

My problem is that my blinkers will turn on a stay on and wont blink and we think it is the fuse but we cant find the box to change it, do you happen to know where it would be? or maybe if you think it could be something else.
thank you

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 5,568 Answers

You probably have found by now that it isn't a fuse problem.

Your car almost certainly uses a thermal blinker relay and it has failed.
Normally under the dashboard, they are typically a cylindrical aluminum can about 1 1/4" in diameter and ~ 2" tall.

They aren't expensive (<$10) and not tough to replace.


Posted on Aug 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinkers wont blink change the relay fuses ok


What about the turn signal switch on the steering column? Did you use a testlight and check voltage at the turn signal fuse? Goes hot when you turn on the key.

A lot of times, it's the turn switch or wiring in the steering column, but, It don't hurt to check the basics.

Feb 20, 2015 | 1999 Oldsmobile 88

1 Answer

Turn signals blin continually


There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike

Jan 16, 2012 | 1995 Cadillac DeVille

2 Answers

My blinker wont blink when i turn it on could it be a fuse and if so what fuse number would it be?


Do the blinkers don't turn on a all? or do they turn on and they don't blink, if then turn on but don't blink replace the turn signal flasher, will fit in the fuse box under the dash, round cylinder looking plugs into the fuse box.

Jun 30, 2010 | 1994 Mercury Sable

2 Answers

Help I don't know how to change a fuse for my blinkers..


Flasher you should find an round flasher in your fuse box. btn-view-details.png --> Application:
With 2 terminals
Notes: ( Autozone has this part # LL552)
Electronic
-->

Jun 04, 2010 | 1987 Jeep Cherokee

1 Answer

TURN SIGNAL, BRAKE &amp;amp; HAZARD LIGHTS


No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:
  • Turn the key to the on position (do not start engine)
  • Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  • When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
  • 1b7f814.jpg

Jul 09, 2009 | 1999 GMC Denali

1 Answer

Left blinker light stays on solid when headlights are on


I have had this happen and it is rare, but I have had a filiment burn out in a two filment buld and short to the other filiment. It does happen and I think this might be your problem, the only way to find it is a visual inspection of each bulb. I am sure many people will think this is crazy, but I have had the exact same problem, I had the schematics, tested the circuits,etc. and them by accident found a stop/blinker 1157 bulb that had done this exact thing. I hope this helps you, check the bulbs in your headlights also.

Dec 27, 2008 | 1999 Chrysler LHS

1 Answer

Blinkers


If you can turn the blinker on left or right and the light comes on but doesn't blink......Open the drivers door, there is a fuse box, On the side of the dash.. The relay willl be a small silver canister looking relay in with the fuses.. put your finger on it and turn the blinker on.. you should feel and hear a click...( With the key in the on position ).. That is what needed replaced if it doesn't keep clicking...Thats the turn signal relay... What makes it blink.......Hope this helps..
Please rate this solution if it helps... Thank You.....

Nov 04, 2008 | 1996 Pontiac Grand Am

Not finding what you are looking for?
1992 Oldsmobile Cutlass Ciera Logo

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...