They are located behind the right front headlights (passenger side). There is a bank of four relays mounted on a common holder. The four are for various purposes, one of which is to control the ac fan on the low settings. I got a bank of four used relays from and olds off of ebay. I plugged in the part number off the one I had into the search box to find it.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
many of the heater blowers use a resistor type switch to adjust the fan speeds, when the switch goes bad only the high speed will work. the resistor is usually located in the airflow in the heater box under the dash. find it , change it (it just plugs in) and it will work again
Yes it is the blower Motors Resistor board. It is up behind the blower motor, just under the glove box. You have to remove the black KICK panel with its two "Push Pins" that will break too. There are 3 screws holding that resistor board in, the back two are a bear to get to. Good luck.
Actually there are 2 fuses. One is for the lower speeds and one is for High speed. Might be a relay, too. Check the owner's manual for the location. I believe the high speed one is under the rear seat.
Fan will be under dash on passengers side , Removing glove box might be needed, Gm also uses a blower resister ro control fan speeds. First check your fuse and then check and make sure your getting 12 volts to the terminal at the blower, You could have a blown fuse, a bad switch, or a bad resister , if your getting voltage to blower motor then most likely it will be the motor. These are not to difficult to change. I hope this helps, please be aware I can only guess at what the problem is from my past experience.