Question about 1991 Chevrolet S-10

1 Answer

Truck wont start

I drove the truck 2 days ago it seemed to be running fine... i got home... changed my breaks and went to restart the truck and it wouldnt start. the engine turns over but wont start... im getting fuel to the throttle body but doesnt seem to be getting to the plugs.. so i changed the fuel pressure regulator in hope to be the fix to the problem but still nothing... what could be wrong?

Posted by on

  • Anonymous Oct 29, 2008

    the blazerjust turns over if I use starting fluid it starts and runs. what do I need to do?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Just a suggestion but you may want to try putting a bottle of dry gas or octane booster . You may bad gas or possibly water.

Posted on Nov 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't it start?


if it has a fob key battery then replace it
run the fault codes
It sounds like an immobilizer problem so a reset of the ECM using a scan tool may help

Aug 30, 2015 | Cars & Trucks

1 Answer

No Reverse and the fluid is dirty and smells funny.


Sounds like you blew out your reverse belt/gear in the transmission. Probably going to need a transmission rebuild/replacement.

Feb 08, 2014 | Dodge Ram 1500 Cars & Trucks

1 Answer

2008 Mercury Mountaineer electrical issues


This is a devious problem which could lie anywhere. So many things not functioning would perhaps be a ground problem. Maybe take some extra care in cleaning the battery terminals, check if the ground wire is connected to the chassis. Do you have rodents in your area? Maybe they nibbled some wire somewhere?

Jan 28, 2014 | Mercury Cars & Trucks

2 Answers

My truck wont go over 35


Could be a lot of things I would start here. If the engine is shaking at idle or not it maybe the spark plug wires. easy way to check start the truck take a spray bottle and spray a mist on the wires to see if the truck runs worst make sure you stand back while doing this so you don't get shocked.

Jan 16, 2013 | 1986 Chevrolet C1500

1 Answer

A few days ago my serptene belt flew off. I replaced the next day, then i had to replace the tensioner pulley. I started the truck and every thing seemed fine. Then i turned the truck off and inpected...


you could have an alternator problem, I am wandering if the serptene belt is on properly or tight. if the belt is slipping and not turning the alternator pulley then it will not charge you battery and if you drive it the new battery will go dead and the alternator is not charging it so it will not start.
i would charge the battery and start the car and watch the belt and the alternator and see if the pulley is turning, they will also make a squelling sound if loose.
hope this helps

Jan 28, 2011 | 1996 Ford F150 Regular Cab

1 Answer

3 days ago, i went to work no problem,had to move it after 6-7 hrs of time, would not turn on 2 try's, started like normal on 3rd. 2 days ago i drove it locally a couple of times, no problems. today...


I ran into the problem and it was corrosion on the battery terminals. on the inside against the battery. also check the the terminals for good connection.
Stay warm

Dec 26, 2010 | GMC Sierra 1500 Cars & Trucks

1 Answer

Engine cuts off


this is a hard one to fiqure out unless the vehicle does not starty at all because you have distinguish if it is gas or spark. The distributer has a module that may be breaking down. You have to remove the Dist cap and rotor to get to the module. It has two screws that hold in place using 1/4 inch nut driver to remove it. You can take it to oriellys and they can test it to see if it is good or bad. If you have a check engine light on you can take the truck to auto zone to see what codes are in the system. They will do this for no charge.

Jul 06, 2010 | 1996 Chevrolet K1500

2 Answers

My 1999 yukon wont start i changed master air flow


Fuel pumps are real common to go out on those vehicles

Mar 15, 2010 | 1999 GMC Yukon

2 Answers

2001 GMC Sonoma won't start


The battery may have went completely dead, even though it was just changed.

Feb 24, 2010 | 2001 GMC Sonoma Extended Cab

1 Answer

Truck ran fine monday and tuesday night...went to start it after we had dinner and it wont start turned over fine couldnt hear fuel pump....waited til weds night and it started just fine ..drove it today...


had a 2000 blazer 4.3 wouldnt start in really cold enviroment..... ended up being the FUEL PUMP RELAY.... it still running good... bout every ther day or so... but it acted like your truck

Dec 25, 2009 | 2002 Chevrolet Blazer

Not finding what you are looking for?
1991 Chevrolet S-10 Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...