Question about 2007 Ford Crown Victoria LX Sedan

1 Answer

Air conditioning On 2007 Crown Victoria Ford what should the high/low charge pressures be idiling?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 163 Answers

Rev it up to about 1500 RPMs. You should have about 35 or 40 on low side and about 65 to 75 on high side depending on the temp. They have some good A/C charts on the internet. All pressures will be the same no matter what kin of car. It depends on the ambient temp.

Posted on May 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 2007 Crown Victoria Police Interceptor vibrate when I get to 40 miles an hour and then die off back to normal by the time it reaches 50


Ford Crown Victoria Questions - what would cause a whole ...

www.cargurus.com > Questions > Ford > Crown Victoria
CarGuruswhat would cause a whole car vibration when going between 48 and 65 mph, even ... Asked by Dfranz Aug 29, 2013 at 11:53 AM about the 2001 Ford Crown Victoria Police Interceptor ... You have an open diff by turning one wheel the driveshaft should turn before the .... 2007 Ford Crown Victoria Police Interceptor For Sale.

Nov 03, 2015 | Cars & Trucks

1 Answer

I am not exactly sure which ac port, High or low side (or both), to put R134a refrigerant into my 1984 LTD Crown Victoria. The ac hasn't worked in about 6 years. Not sure if ac stays charged while...


If the compressor really has sat that long, the seals will be dry and you will not likely be able to keep R134 in it. Always fill on the low pressure side. The fittings are a different size, so your fill hose should not fit on the high pressure side. The low pressure side is along the return from the cooler.

Aug 24, 2010 | 1984 Ford Crown Victoria

2 Answers

A dealership fixed my cooling system. I was told it was an airpocket in the system. Now my ac only blows hot air. They keep putting me on hold and its hot outside. any ideas?


if the low side tube is cold while the compressor is working the problem will be on air door module, or one piece of hose from intake manifold go to recirculation door is dis connected, but if he compressor is not working, there is only two reason, even the refrigerant pressure is too high or too low, if low a leak on your system, if too high overcharge or clogged expansion valve or the condenser, if refrigrant is i the right pressure and compressor is not working, check the supply on main switch, ambient temperature sensor, refrigrant pressure sensor and the high pressure sensor, if all ok,. replace compressor

Aug 05, 2010 | 1989 Ford Crown Victoria

1 Answer

No oil pressure on my 03 crown victoria


KNOCKING NOISE IS NOT A GOOD SIGN.SOUND IF YOUR ENGINE OIL LEVEL IS CORRECT NOT LOW. SOUND LIKE OIL PUMP AND MAIN BEARING FAILURE.YOU NEED A REBUILT ENGINE OR OVER HAUL.

Oct 18, 2009 | 2003 Ford Crown Victoria

1 Answer

2007 crown vic 4.6 l idles high on startup


This sounds like a normal condition.What happens is the cold start emission reduction component monitor(software program in the computer) is running.
Cold Start Emission Reduction Component Monitor
The Cold Start Emission Reduction Component Monitor was introduced for the 2006 MY on vehicles that meet the
LEV-II emission standards. The monitor works by validating the operation of the components of the system
required to achieve the cold start emission reduction strategy, namely retarded spark timing and elevated idle
airflow.
When the CSER strategy is enabled, the idle air control system will request a higher idle rpm, elevating engine
airflow. While this CSER elevated airflow is requested, the low airflow test compares the measured idle airflow from
the MAF sensor to the commanded idle airflow from the idle air control strategy.


Apr 02, 2009 | 2007 Ford Crown Victoria LX Sedan

1 Answer

My 2000 ford crown victor air conditioning s.top


The Ford code P1460 (Wide Open Throttle A/C Cutout Circuit Malfunction). I would first try thr relay.

Mar 19, 2009 | 2000 Ford Crown Victoria

1 Answer

Check engine light comes on now the car idils so low that it makes a putt putt sound then cuts off any solutions?


Sounds like the fuel filter is clogged oe the fuel pump is on its last legs. Have you cheked the fuel pressure?

Jul 29, 2008 | 2003 Ford Crown Victoria

1 Answer

2004 Ford Crown Victoria no air flow through main air vents


Chances are the electronic/digital HVAC control unit is bad. This same problem happened to me and I had to replace the entire unit. The dealer wanted to charge $800 for just the part! After I freaked out on them, they found a used one for less than half. Sorry, but there's no easy fix here.

Jun 26, 2008 | 2004 Ford Crown Victoria

Not finding what you are looking for?
2007 Ford Crown Victoria LX Sedan Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...