Question about 1996 Jeep Grand Cherokee

2 Answers

Spark plug diagram

I need to know which plug is the number one

Posted by on

  • ms_shortstuf Aug 09, 2008

    Thank you, was needing to know to set timing.Have found that it was not the problem. The Jeep will run for a few minutes then starts chugging and when given more gas will start popping and backfire. Will shut it off and let sit for a few minutes then start it up again and it will run fine. What could this problem be? would greatly appreciate your help on this. Denise

  • ms_shortstuf Nov 04, 2008

    timing was not the problem. The problem wasthe Jeep chugging and shutting down as we're going down the road. Thank you but need to know what caused the chugging.

×

2 Answers

Need the wiring diagram for 1996 Jeep Grand Cherokee V8 from plugs to distributor

Posted on Nov 04, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Jeep Master
  • 1,779 Answers

The spark plug at the front of the engine (nearest the grill) is #1 on both the 4cylinder and 4.0 in line six cylinder.

Posted on Aug 09, 2008

4 Suggested Answers

old marine
  • 1456 Answers

SOURCE: need a diagram for spark plug wire placement

AutoZone has your answer here.

Posted on Feb 25, 2009

  • 194 Answers

SOURCE: help with spark plug diagram

4 8
3 7
2 6
1 5
front of motor

Posted on Feb 08, 2010

  • 1757 Answers

SOURCE: need a spark plug wire diagram to know where each

On the 1996 Oldsmobile Aurora 4.0L DOHC V8:
Firing Order:

1-2-7-3-4-5-6-8

Cylinders:
............(back)...........
|...1.....3.....5.....7...|
................................
|...2.....4.....6.....8...|
...........(front)

Coil Connections:
...................(back)
..|.6..7.|..|..4..1.|..|.8..3.|..|.2..5.|
....................(front)

Posted on Jun 25, 2010

ZJLimited
  • 17970 Answers

SOURCE: I need to know the spark plug number and position,

Check this diagram for 1997 Oldsmobile Eighty-Eight 3.8 liter V-6 VIN "K"

zjlimited_114.gif

Hope helps (remember to rate this answer)

Posted on Jan 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need wiring diagram for the spark plugs on a 2001 ford Windstar V-6;3.8L


1-4-2-5-3-6


Cylinder numbering:

  • Windshield side
    1--2--3
    4--5--6
    Frt. Of vehicle




Coil numbering:
    • --4 PIN--
      ----------------
      --1--- 2--- 3--
      ----------------
      --5--- 6--- 4--

Feb 12, 2015 | 2001 Ford Windstar

2 Answers

Spark plug wire diagram for 2005 mazda 6


2.3L 4 cylinder? After removing the plastic engine cover, look at the top of the ignition coil.

changesparkplugs003.jpg
It should be numbered 1 through 4.

This is plug number 1 on the engine:

changesparkplugs004.jpg
Just wire them 1, 2, 3 and 4 to the corresponding numbers on the ignition coil.

best wishes

Jan 01, 2011 | Mazda MAZDA6 Cars & Trucks

1 Answer

How do I install a distributer on 1998 vortec engine. old distributer missing


Hi: To Install the Distributor Correctly, 1st thing to do is Remove your #1 Spark Plug assuming it will turn over have someone Turn the Key Off and On in Short Intervals.Either put a Compression Gauge in the #1 Spark Plug HoleOr the Old Fashion Way Works as well just put your Finger in the #1 Plug Hole.As your Helper Cranks the Engine On -Off On -Off.Not A Continuous Crank.When You Feel Air Pressure or See gauge Come up.TYhats when your Engine is a The compression Stroke.Now you Can Drop the New Distributor in its Hole.NOTE: You'll need a Spark Plug and Timing Diagram to See the Position your Distributor ROTOR Line it up to where the Diagram Shows your #1 Spark Plug Wire Will go in the Distributor Cap.If the Distributor Rotor is Not n That Position Your goning to Get Either Back Firing engine May Not Even Stsrt, To This Is Crucial. After The Know that you have The Distributor Droppped The Right position you'll need to Put Gap your Plugs at the Correct Specs, With All Plugs in Now You'll need to Put New Plug Wires on .And They MUST be in the correct order.Sitting inside your Vehicle #1 Plug is the Front Plug on the Drivers Side Next is #3 plug Next is #5 and Your Back Plug is Number 7,On the other side Passenger Front Plug is #2 next #4 Next is #6 and the Back is #8 Assuming you know have your Distributor Dropped in The Proper Position, Put the #1 Spark Plug Wire on the Front Spark Plug (Drivers Side) The Spark Plug Firing Order in Your Engine is 1-8-4-3-6-5-7-2 Clockwise So the Next hole after you have #1 Plug and Wire on And Distributor In Correct Position on COMPRESSION STOKE, Going Clockwise you next wire will be your #8 Position in The Cap And it wil go to the Back Spark Plug on The Rear Spark Plug on Passenger Side. NOTE: Drivers Side Spark Plugs on the Drivers Side Front to Back are Your Odd Numbers 1-3-5-7 Pasenger Side is Your Even Numbers From The Front is #2-4-6-8 Is The Rear PLug .

Heres a Diagram of your Spark plug Positions

Front of Engine
1 2
3 4
5 6
7 8

Hope This Will Get You Going. Let me know The Quality of Help and Solution I've Given You By Voting on It.And May Can Also Send a Testamony
From d_hubbs

Jun 03, 2010 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

2002 ford f150 4.2l wiring diagram


The COIL PACK TOWERS are numbered : coil----3---4 pack---2---6 plug----1---5 ----------------------------------------------------------------- The engine cylinders / spark plugs are numbered : passenger side , front to rear , 1 , 2 , 3 -----drivers side , front to rear , 4 , 5 , 6 ------------------------------------------------------------------- The spark plug firing order is ( 1 -4 - 2 - 5 - 3 - 6 )

Apr 07, 2010 | 2004 Ford F150

1 Answer

Spark plug wiring diagram


If u can't see the diagram go to the link, just match up the numbers on the coil to the engine cylinder numbers.

http://autorepair.about.com/library/firing_orders/bl-fo-5630.htm


b0edffd.gif

Apr 05, 2010 | 1997 Pontiac Trans Sport

1 Answer

I need a diagram for a spark plug wires on a 99'


start with the serpentine belt side of the car (passenger) the first plug hole will be #1 then 2-4 as you work your way to the drivers side as Im guessing this is a 4 cylinder. The coil pack on the top of the engine has all the plug wires coming out of it and should be numbered 1-4 go accordingly from there.

Jan 04, 2010 | 1999 Chevrolet Cavalier

1 Answer

Where can I find a spark plug wiring diagram for 1997 3.1l engine


Normally the firing order will be stamped on the top of the intake manifold also the number one plug will be the front one on the drivers side of the car. On the top of the distributor cap you should see a number one that is where the number one plug wire goes follow the firing order on the manifold and go clock wise on the distributor cap

Mar 18, 2009 | 1997 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

680 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...