The power window on the drivers side is the only window that works. Where and what do I check for? The truck is a 1994 Chev s10 blazer 4 door.

OK you just simply pull on them the light is built like a fuse just pull it out
Experience 2003 s10

usually Under carpet .water, remove the left foot step look Under carpet follow the orange wire and the plug too.for corroded wires

hope it helps

Could be, or a wiring problem in the harness. I would check the harness for power and ground with a meter.

Should be 1-2-3-4-5-6.
The odd cylinders are on the passenger side.

should be a couple of screws and maybe bolts behind door trim and inside body mouldings

you may just have a bad connection under the lock button under switch panel on your drivers door. check electrical plug in at door lock switch by removing that panel from driver door.it may be that you have to replace that door lock switch .thers only one fuse for door locks and if pass side works, it's not blown.

It shoule just pop off. there might be a screw or two if you have door handles and window knobs.

I had the same problem - driver side fine, passenger side front not working/slow or the back seat. You need to replace the window motor on the passenger side. Yes, there are two motors. It's pretty simple if you are handy with some tools. The hardest part is getting the 4 mounts that hold the window motor to the door off. The are factory riveted to the door, so I had to grind the outsides off and tap them out. Just watch the spring lever that holds the window bar for going up and down. I didn't pay attention and it snapped back - nearly broke my thumb.

Dani-Lynn

you should have 2 ecm fuses under the dash in the fuse box check these one of them is probably blown I have had 2 s10 that blow this fuse occasionally