Question about 1991 Chevrolet Beretta

1 Answer

Window off track - 1991 Chevrolet Beretta

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

On mine, the plastic T shaped guide broke. It should be on the top rear of the glass. Its part of the whole channel on the back of the glass. Took it to an auto glass shop. About $50 for the job.

Posted on Dec 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to I fix a window that won't stay on its track


remove the door panel and inside the door at the bottom of the track you will find a bolt that adjusts the window track position
put the window down as far as possible and adjust the track back tight against the glass and tension up the nut

Jun 23, 2015 | Cars & Trucks

2 Answers

How do i get it back on track


remove innder door panel and carefully put it back on track

Jun 08, 2015 | 1993 Chrysler Imperial

2 Answers

Driver window want go up but it will go down


maybe have the inverted wires remove the door wndw control and check the lines perhaps are inverted

Jun 15, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

How to put window on passenger side back on track


take the door panel off... put the window in down position... now you should be able to work the window up with your hands and you will be able to see inside the door where the tracks are and where the window needs to go... just line it up in the tracks and let it come down into place... you will need some good adhesive or silicon in the bottom track which holds the window in place and keeps it from being able to get out of the tracks ...put the adhesive in the bottom track before you push the window all the way down into the bottom track... roll up the window all the way but do not roll it down again until the adhesive has had time to dry fully... replace door panel

Mar 25, 2011 | 1995 Oldsmobile Cutlass Ciera

2 Answers

1991 oldsmobile cutlass supreme drivers side window keeps coming out of track, how do I fix


Hi,
generally the door panel has to come off. With the panel removed you can see the tracks. There is an adjustment for each track, and you can observe the action of the window in the track as you operate the window. slacken both track adjustment bolts if fitted, operate the window untill fully up, tighten each adj bolt and operate the window through the cycle. Make any further adjustments as needed. When correct install the door panel, and recheck the operation of the window.

Good luck.

Jan 31, 2011 | 1991 Oldsmobile Cutlass Supreme

1 Answer

How to replace power window motor for 2003 dodge


That's unusual for a window motor to go bad, however the plastic track breaks causing the window to become inoperative. If you hear the window motor working, then the plastic geared strip is probably broken. It would be cost effective to you to first find out whether the plastic track is broken for now Chrysler sells a "generic" window track where you cut the plastic track to fit Your Vehicle. Should this be the case, then remove the door panel (a Haynes Manual would come in handy), and take out one pin in the plastic track, while supporting the Window! (smile) and remove the old track and re-install the new track.

A little secret here...buy some Mopar Speedometer Grease while buying the Window Track and grease the metal rail that the plastic track rides on. The Speedometer grease is NOT temperature sensitive, so it works well in Summer & Winter Temperatures.

Should it truly be your Window Motor, Chrysler sells a re-build kit for the Window Motor which has the gears and grease needed to replace the worn out ones in the head of the Window Motor rather than paying for a "Brand New" window motor. All of this (the plastic window track AND the Window Motor Kit), will be under $100.

I hope this helps you,
Let me know if this resolves your problem.

"00 Buck"

"Still living on the Right Side of Dirt..."

Jun 04, 2010 | 2005 Dodge Grand Caravan

2 Answers

I have a 06 saturn ion. my window will go up


towards the back of the door is a short track that runs left to right. there should be a nut either loose or missing on this track. put loctite on the stud, then put the nut back on. do this AFTER the window is back on track.

Apr 22, 2009 | 2006 Saturn ION

1 Answer

Why does my window come off track in my 91 accord?


Could be the tracks have slipped so the window isn't guided well any more or they stick in one track and get cocked as they move up and down. You can try lubricating the window tracks with Armor All (use a Q-tip). It might be necessary to remove the interior door panel to make sure the window tracks aren't loose. There is screw at the bottom of each track that allows some adjustment. If you go to this extent, it might be worth it to remove the glass (just two screws hold it to the regulator mechanism), clean the edges and lubricate the whole length of the track.

Jan 22, 2009 | 1991 Honda Accord

1 Answer

Window is off track






1. remove door panel, door latch handle and window crank unless it is electric, then remove electric control panel , usually on top of arm rest.
2, Remove insulation sound barrier (plastic sheet)
3. Inspect window for damage. If none is found, notice where the window normally slides up and down in what is called tracks. There is felt material inside the tracks.
4. Also look to see if the window has dropped out of the two crossed arms that have white plastic rollers on them. Be careful handling these arms because they are very sharp.
5. Look for small tabs holding track to door. Usually top and bottom. Loosen these screws slightly until you can move them back widening the distance between both tracks so that you will be able to slide the window back into the tracks.
6.Once the window is back in track, move the loosened track back up so its just touching the window, then retighten the screws.
7. Test window operation.
8. If the window comes off tracks again, window regular is causing problem and should be replaced.


Hope this helps.


If you would like to correspond further with me on this or any other issue, please feel free to do so.
Bill
ASE Master Technician

Nov 26, 2008 | 1999 Chevrolet Malibu

1 Answer

FRONT DOOR WINDOW


Yes. I have fixed my driver side window several times. The window went all the way down and came off the track, usually because the window automatically went all the way down. The first step was to take the interior side of the door off: (1) I unscrewed the screws around the door and pull the plastic screws out. (2) I disconnected the thin metal rod that connects the door handle to the door frame to be able to pull the interior part of the door away from the metal frame of the door. (3) I unscrewed the speaker to see where the window meets the rubber track. (4) I kept the electrical wires connected so that I could use the electric window button to lower and raise the window. (5) I lowered the window down below the rubber track and loosened the screw holding the rubber track to the door. (6) I manually adjusted the rubber track around the window glass and pressed the electric window button up slowly, making sure the glass stayed on the track. (7) I put everything back in place, screwed in the screws, etc. Be careful not to let the window go all the way down, because it seems to fall off the track at that point. Hope this helps!

Nov 08, 2008 | 1992 Honda Accord

Not finding what you are looking for?
1991 Chevrolet Beretta Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...