How long will it take to replace a starter on a 1998 nissan sentra se 2.0

Question edited for clarity.
Question moved to model category.

'95-'99 Nissan Sentra Fuse Box Diagram

https://knigaproavto.ru > shemy > 720-1995-1999-nissa...

Oct 27, 2018 - Fuse Panel Diagram Nissan Sentra Base, XE, GXE, SE and GLE (B14; 1995, 1996, 1997, 1998, 1999)

Hello Dave Devol,

Totally FREE circuit Drawings & Technical Service Bulletins
(TSBs) are available on the BBB Industries website...

Registration is required... (These are REAL documents)...
BBB Industries Premium Alternators Starters Power Steering Products
The only problem... Every time you return from the
DRAWINGS you are in the Technical Service Bulletins...

and must switch back to "WIRING"... but FREE... helps.

I hope I have.

Carnac the Magnificent

NISSAN SENTRA
http://alarmsellout.com/support/diagrams/vehicle/NISSAN%20SENTRA%201989-2005.pdf
http://www.ertyu.org/steven_nikkel/neonfsm/2000/EPL_8W.pdf

original sizes:

Sentra S = P195/60R15
Sentra SE-R = P195/55R16
Sentra SE-R spec V = 215/45ZR17

look for a bolt that goes from the trans side , usually tucked inboard and hard to get at

The starter on 4th generation (1995-1999) Nissan Sentras is very easy to locate and replace. It is a mostly-black cylinder, about 9 or 10" long and 3" thick, that sits on the front center of the engine. It is held on by 2 bolts, and has 2 wires connected. The 2 bolts come off easily, one of the wires simply comes unplugged easily, and the other has a small bolt holding it on.

Replacement may involve removing a bracket that holds the throttle (gas pedal) in a certain position, because there may not be enough room to work with that bracket in place. Removing and replacing that bracket (which is held onto the engine block by 2 bolts), does not affect the operation of the car.

If this is the first time the starter is having issues, replacement can be put off for a couple weeks by taking a small hammer (or something similar) and hitting the starter. Don't hit it too hard, but don't be too gentle. It might take several hits to get it to work. This is only a temporary solution. The starter WILL have to be replaced eventually.

Good luck (remember rated this post).

lOOK BEHIND THE GLOVE COMPARTMENT. Compartmet is probabily plastic and all you have to do is push in real hard to get them past dash board.

YOU HAVE TO REMOVE AIR INTAKE DUCT AND THE AIR FILTER HOUSING TO GET TO STARTER.