Question about 1994 Nissan Altima

1 Answer

Name of a part for nissan altima that appears to be a cross member in the back of the car attached to the drive train

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,911 Answers

A nissan dealer parts guy will show you an illustrated parts breakdown for free, or you could buy one on eBay for about 5 bucks. then you will know the name, the part number, the minutes of labor required to replace it, the dealer cost for the part, and most likely the other models and years the part can be found on, as you are going to be looking in junkyards for the part.

Posted on Apr 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi can anyone help. Can the engine cross member be taken off from the vehicle on a Nissan 1400 van. Many Thanks


Yes, you will need a special tool to support the engine and transmission if you are planning on leaving them in the vehicle when you remove the cross member.

Jun 26, 2017 | Nissan Cars & Trucks

1 Answer

How do i remover the transmission cross member form my 2005 nissan pathfinder le


remove the rear transmission mounts
jack the rear of the transmission up and knock the cross member forward or rewards or at and angel between the chassis rails

Nov 08, 2015 | Nissan Pathfinder Cars & Trucks

1 Answer

Could it be the third member


You have a front wheel drive transaxle,no third member or axle

Nothing in the back that drives the car

May have a bad wheel hub bearing

Apr 04, 2014 | 2003 Nissan Altima

2 Answers

I jus brought and 1995 nissan altima. One of the radiator fans does work and I was wondeing if that could make the car shake? It only shakes midly but when i turn on the ac it shakes bad.


If the air conditioner is overcharged it can cause this to happen. Also that fan will need
to be replaced because it helps the condenser for the air conditioner to cool the air.
someone may have overcharged the a/c to try and compensate for it.
The lack of cooling will cause overheating of the engine without that fan replaced because it is also the radiator fan.
Hope this is useful.

Jul 23, 2011 | 1995 Nissan Altima

1 Answer

How do i replace a starter in a 2003 gmc envoy xl


It was a huge pain doing this without instructions. Here is what I learned from trial and error.
Disconnect the battery, of course
To access the starter, you will need to remove the lower right exhaust.
To accomplish that, place a hydraulic jack under the 4wd transfer case and remove the cross-member (4 vertical bolts in the mount, 2 horizontal bolts on each side, and 4 vertical bolts on each side underneath hold up the cross member). Lower the drive train a bit so you can reach around the transmission to unplug the 2 right-side O2 sensors (to see what the plug looks like, look at the rear left-side of the cross-member).
Cut the exhaust in half (in the middle of the vehicle), remove the bolts from the muffler, and the right manifold. You may also want to loosen the left manifold bolts. (make sure you have extensions, a breaker bar, and some penetrating oil). You may need to raise the drive train again to get the section of the manifold out. Once that is out of the way, take the 2 bolts out of the starter, and the sockets to remove the wires should be 8mm, and a deep 13mm. You may need a special folding ratchet to get to the other side of the starter.
To put the exhaust back together again, cut about a half inch more from the place you cut the exhaust and piece it together with a 2-1/2" coupler and clamps from Autozone.

Jan 24, 2010 | 2003 GMC Envoy Xl

1 Answer

I need to replace the transmission mount on a '94 1500 4.3L, 4X4. Which is easier, support the transmission and remove the cross member or release the engine mount bolts and raise the drive train? Tks


Supporting the transmission while removing the cross-member is easier. You will have the engine mount holding the whole thing in precise place, while you deal with the crossmember, and the transmission.

Comparing: if you release the engine mount bolts and jack up the drive-train, the whole thing would shift, and you could have trouble when the cross-member fails to go up well enough.

On the other hand, if the cross-member bolts fail to release due to "home-mechanic" syndrome, you have only the first option.

Dec 03, 2009 | 1994 GMC Sierra

1 Answer

'97 nissan altima, brake lights not working, wire


Lets keep it simple if the wiring harness is in good condition lets not look at that... first check your fuse if the fuse is good... check for power... if you have power coming and going from the fuse then check your brake switch ( located under the dash) attached to brake pedal. Please make sure your light bulbs are both good also. If your brake light switch is good and you have tried everything else it is either going to be in your 4 way switch or wiring harness

Aug 23, 2009 | 1995 Nissan Altima

1 Answer

Headlight Aiming/Adjustment


On the sides of the Radiator cross member. Look straight down. Should be a silver colored phillips head screw

May 10, 2009 | 2004 Nissan Altima

Not finding what you are looking for?
1994 Nissan Altima Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...