Question about 1995 Dodge Ram

1 Answer

Have a 95 Dodge Ram 2500 with a 360 gas engine. When it idles it wants to quit or revs up and is now doing the same thing while under a load

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, try changing your TPS (throttle positioning sensor) its located on the intake area (look where the throttle cable hooks to the engine)

There is a possibility of a fuel pressure regulator problem, also a faulty Idle Air Control motor (IAC) could cause the problem.

Posted on Apr 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load


Have you checked for a broken valve spring. Repaired a dodge engine with the same running issue as you have described and it was a broken intake valve spring.

Feb 22, 2015 | 2005 Dodge Ram 1500

1 Answer

1998 dodge ram without 02 sensor howwill it run


If you run the engine without an o2 sensor your emissions and fuel management systems will not work correctly.First thing to do if the engine revs high is to take the idle air control valve off and clean the carbon out of it and the throttle body using a non-chlronated brake cleaner.Then reset the computer by disconnecting the ground on the battery for 30 seconds or pull the ECM fuse or with a code reader.If the problem exists do the same with the mass air flow sensor.Let me know the results.

Jan 25, 2012 | 1998 Dodge Ram

1 Answer

2001 dodge intrepid stalls when warm and i,m not in the gas pedal. Why?


there could be a couple of things causing the engine to stall, most common would be a large vacuum leak, check all vacuum hoses under the hood paying close Attn. to the large hose going to the power brake booster,but the most common thing to cause a idle stall is a idle control motor some times it is called an idle air motor.

Feb 27, 2011 | 2004 Dodge Ram 1500

1 Answer

When i start 2001 dodge caravan the engine revs is 750-850.is this normal?????then when go on R engine revs goes 450-600. is this normal??? when go D revs goes 500-600 end push gas drives normal what the...


the idle is controlled by the computer and the idle speed motor if the idle is too low the first thing you should do is check for a vacume leak as this will directly effect the idle or revs as you say

Nov 20, 2010 | 2001 Dodge Caravan

1 Answer

I have a 1995 dodge ram 1500 that when i start it revs up to about 1800 rpm then goes right down and quits. I might have to start it several times before it stays running....any suggestions?


Have you checked the engine codes? On your 95 ou can by turning the enigne switch on and off 3 times quickly and then back on. Do not start engine. Then count the flashes to get any codes out of the computer. You can find the codes by searching the internet easly.

Apr 06, 2010 | 1995 Dodge Ram

1 Answer

I have a '98 Dodge Ram 1500 with a 4.7l engine, the engine will not rev above 2900 rpm while the transmission is in neutral or in gear, there is no check engine light on, what are some things that I can...


All late model vehicles have built in Rev Limiters to prevent catastrophic destruction from no load over speed of the engine. Check with your dealer Service Manager to find out what RPM your engine is governed to.

Fastest Robe

Oct 19, 2009 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Idle Rev Limit in 3.5L engine


yes this is normal. most newer cars are equipped with rev limiters so people cant over rev the engines without a load on it. the shaking is from the computer cutting off the ignition repeatedly when you reach the max rpm.

May 12, 2009 | 2004 Dodge Intrepid

1 Answer

Car dies at idle


my truck dies at idle when i turnmy wheels

May 07, 2009 | 2005 Dodge Ram 1500

1 Answer

1997 Dodge Ram 360 5.9 won't idle in gear


Remove IAC motor/valve on side of throttle body that regulates idle especially under load conditions, and clean it & the port good with throttle body cleaner & re-try. If it cures it for a while, then does it again, replace it with new one.

Dec 28, 2008 | 2004 Dodge Ram 1500

2 Answers

Stalling issue


check for vacuum hose leak, listen for hissing sound a can a carb spray may assist you in finding this by spraying the hoses and watch for change in idle, this may not show a code if it not a constant problem. under load its ok when it tries to idle the vacuum leak will stall the motor..

Nov 19, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...