Question about 1996 Chrysler Town & Country

1 Answer

The engine wont crank, the alarm set light stays on, you get 16 beeps, the services engine soon light flickers and the auto shut down and fuel pump relays under the bonnet make a clicking noise, they are cycling on and off, I have read a lot about the 21 pin plus and earth wire bunrning out, I have checked these and they are ok, Also I have tried banging the dash, no joy, please help.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, the "check engine" light on the Chrysler means that the engine electronic controller has observed a problem and has stored it as a coded number in its memory.

Which is the summary of all the problems you are encountering with the car. Once you get the code and interpreted, it identify the main cause of the problem...

Posted on Apr 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1993 nissan sentra 1.6 wont run and check engine light wont turn on,bulb is ok


Could be any of several things. If the crank sensor is marginal and not sending pulses, the fuel pump is shut off. This is for safety. The pump is energized for a few seconds as key is turned in preparation for starting then engine must rotate normally to keep the pump on. If it stops, in a few seconds the fuel is cut off.

Aug 17, 2012 | 1993 Nissan Sentra 4 Door

1 Answer

Changed fuel pump. Fuel pump does not come on and it's not the relay. What could the problem be? Was driving down the road and the engine shut down, but still turns over, just won't crank because...


do you have ignition fire? does the check engine/service engine soon light come on when when you turn the key on? can a scan tool communicate with the ECM? there are several things to check if you have no power to the fuel pump because the fuel pump relay is controlled by the ECM.

Jul 30, 2011 | 1998 Chevrolet S-10 Pickup

1 Answer

I have 2004 nissan titan with 110,000 miles and my service engine soon light came on. I had it checked and someone said it had something to do with the fuel area


actually could be many reasons, dont want to scare you but there are several sensors that control this grey area, Oxygen,temp,crank,mas,knock sensors. dirty air cleaner, dirty oil (oil sensor) the light will only stay lit if the computer has stored a code, so i suggest getting a scan done to narrow the possibility of causes. What sucks about this is it cost $80-100.00 for a complete engine diagnostic, (fuel pres,timing,air fuel,cat,misfires,etc..) But first,if you take the car to a auto-zone or O'reillys,maybe a napa they will perform a basic code test and hopefully give you a basic or solution to the problem. does the car still run okay? if so have them clear the code,maybe you got some bad gas or something that triggered this. Unless the car is running unusual, or you can hear, feel a problem don't be to alarmed of that light starring at you. Check all fluids,clear code which will shut light off and try again. Hows the fuel mpg holding up.

Jan 12, 2011 | 2004 Nissan Titan

1 Answer

During the summer time it will cut off sounds like it is loosing fuel pressure will turn over, but wont start back up until at least an hour later. Drives perfect during the winter time no problems,...


What causes this is ussually the oxygen sensor. It works when the engine heats up and if its no good, it will run your engine lean or even shut it down. check them and replace them. They should be done every 2 years.

Jan 06, 2011 | 1991 Mercury Topaz 4 Door

1 Answer

2001 Jeep Cherokee cranks find but as soon as it warms up it shuts down. Thoughts (Crankshaft Position Sensor, Auto Shut Off, Leak Detection Pump Pressure Switch, Coil.) I've eliminated fuel pump, have...


the egr valve is closed when the engine is cold.
when the engine is warmed up it opens
if closed when warm the engine dies out
check that item out next

Aug 10, 2010 | 2001 Jeep Cherokee

1 Answer

Service engine soon light on 1998 buick regal gs


It is most likely a crank sensor!!!!!!! i am 99.9999% positive that this is the culprit. I am a mechanic and this is the first thing i would check with your description.

Mar 06, 2010 | 1998 Buick Regal

2 Answers

Throttle problems. as soon as you start the car it revs up to 4 RPM's and wont go down


Your idle needs to be tuned down, could also be an injector relay or fuel pump / injector pump relay

Apr 13, 2009 | 1995 Saturn Sl

1 Answer

2000 Ford Expedition wont start


On the engine there is a tube that supplies fuel to the fuel injectors, on that tube there is a valve, like a metal tire valve, this is the fuel pressure test port, you will need a special guage to check the pressure that screws onto that valve, Kragen and other parts stores sell this test kit, it is very inexpensive, about $20.00, but cheaper than having a shop do it for you, if you do the test and you have no pressure while cranking the engine then your fuel pump is bad, the pump is in the gas tank, a big job and dangerous due to chance of fire if you are not cautious.

Oct 14, 2008 | 2000 Ford Expedition

1 Answer

1994 geo tracker fuel problem


The fuel pump has 2 sources of power, when you crank the engine power to the pump is supplied through the cranking circuit of the ignition switch, after it starts the power comes from the run circuit, you most likely have an issue with the ignition switch.

Aug 22, 2008 | 1992 Geo Tracker

Not finding what you are looking for?
1996 Chrysler Town & Country Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...