Question about 2005 Ford Mustang

1 Answer

Well my battery of my mustang wint down and i had to chage the battery and my drivers window when it goes up it bouces bacj down to a 1/5 down and i want to know how to restore it.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 71 Answers

NOTICE: Make sure no obstructions are present in the window system when carrying out this procedure.
NOTE: A battery disconnect does not require this procedure to be carried out unless the battery was disconnected while the window was operating.
NOTE: Excessive bounce-back (bounce-back that occurs with no obstructions present) may indicate a non-initialized window motor.
NOTE: Carry-out the de-initialization of the motor before initializing the motor.
NOTE: The motor will only operate in the 9-16 volt range. If the voltage drops below 9 volts, the window will not function correctly or may stop moving. If the voltage drops below 9 volts while the motor is operating, the motor will become de-initialized and will need to be initialized.
NOTE: The front window motors must be initialized whenever: a new window regulator and motor is installed, a new window glass is installed, a glass top run removal and installation or when carrying out any operation in which grease or lubricants are applied to the window system. A new front window motor is in a proportional up/down mode until initialized.
NOTE: The convertible rear window motors do NOT need to be initialized as they do not have one-touch up or one-touch down functions.
NOTE: All front window components (window glass, window regulator, window motor and glass top run) must be installed/tightened and adjusted to specification before carrying out this procedure.
NOTE: If this procedure is only partially completed, the front window motor remains non-initialized and only the proportional up/down functions operate. A non-initialized window motor may allow one-touch down operation, but does NOT allow one-touch up operation.

De-initialization then re-initialization

The motor can be de-initialized in 2 ways:

Disconnect the battery cable from the battery while the window is operating.

Remove the window motor fuse while the window is operating.

After the motor has been de-initialized, the initialization procedure must be carried out.

Make sure there are no obstructions present in the window system when carrying out this procedure. The door MUST be closed during this procedure (for convertibles, the top and quarter glass must be in the closed and up position), in order for the door window motor to initialize.

The windows must be in the full open position for this procedure to operate correctly.

Press and hold the window control switch in the UP position at the second detent until the window glass stalls into the glass top run for at least 2 seconds.

Once the top run is reached, hold the window control switch in the DOWN position at the second detent until the window glass stalls at the bottom of its travel for at least 2 seconds.

Cycle the window glass an additional 5 times to set the window soft stop for the down position.

Test for correct window operation by carrying one-touch up feature.

Good luck, if for any reason you can't give four thumbs up, please ask for more information. Thanks!

Posted on Apr 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 ford mustang windows go down by there self


Sounds like Smart Junction Box is defective. It's common on that gen mustang and causes alot of odd problems. Make sure there's no water leaking onto it.

Mar 19, 2013 | 2006 Ford Mustang

1 Answer

1998 mustang drivers power window is knocking as it goes up


Remove the inner door panel and check the slides inside that door that holds the window pane in place. If that isn't it, watch the window as it goes up with the panel off. See if you can see something slipping or misaligned.

Apr 27, 2012 | 1998 Ford Mustang

2 Answers

I have a 2005 mustang with windows when windows are up and you open the door it goes down a little then you shut the door it goes up.Problem: some times it stops working and wont go up all the way or wont...


go to www.allfordmustangs.com for solutions to this problem. You have to retrain the memory in the window. http://www.allfordmustangs.com/forums/2005-2010-v6-mustang-tech/94724-2005-mustang-power-windows-problem.html. This link should get you the help that you need and the reasons why it happens and how to solve it. It happened to me and this information was very helpful. I hope that it helps you

Feb 15, 2011 | 2005 Ford Mustang

1 Answer

1993 mustang 5.0 lx conv rear power window does not go up or down


More than likely it is going to be the switch on the drivers side door. The "master switch" if you will for all of the windows. It is possible that the ground connection came loose from the motor, or there is simply a short in the wiring. Nine times out of ten it is just a problem with the switch. Personally I have a 1995 Mustang GT and my rear drivers side window would not go down. I replaced the switch "it will have controls for all four windows" and now it works fine.

Jul 08, 2010 | 1993 Ford Mustang

1 Answer

Driver side window on 2004 mustang stopped working


the window switches in the door can offten go bad just from sticky fingers. some times the are known to just stop working all of a sudden. it is also posible that the motor has gone bad, or more likely a bad conection at the motor or switch. the door switches on the mustangs are not the most sturdy switches. the tend to break loose and move around. u can test the motor by simply runing 12volts the the terminals on it. depending on witch terminal has power and witch has ground determins if the windo goes up or down. also check with volt meter or test light that there is power to the switch, just turn the key on and ground the test light and plug in the terminal that goes to that switch.

Apr 24, 2010 | 2004 Ford Mustang

1 Answer

I have a 2004 Pontiac Sunfire. The battery to my


first you should double check to make sure the batteries are installed correctly ,then get the new car manual out of the glove box ,and check for the reprogram procedure for your remote . every car manufacture has there own procedure , example,I have 03 mustang mach 1 the procedure goes something like this.turn key to on position..put drivers side window up then down open and close driver door then turn lights on and off then radio on off and so on

Jan 05, 2010 | 2004 Pontiac Sunfire

1 Answer

2002 ford mustang


window regulator sound bad. Very common problem in Fords. Motor is trying to grab on the nylon strap that makes the window go up and down but the teeth on the strap break off .

Apr 23, 2009 | 2002 Ford Mustang

1 Answer

Power windows


Try to only roll one at a time up or down if you push more than 1 button at a time it will put a strain on the battery also try getting your battery tested to see if a cell is out. good luck!

Sep 11, 2008 | 2002 Ford Mustang

Not finding what you are looking for?
2005 Ford Mustang Logo

224 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...