Question about Chevrolet V10

1 Answer

I have a 1987 chevy v10 and it shuts off when the map sensor gets hooked up

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 638 Answers

If the engine shuts off, like you said it did when you connect the map sensor, i would take the sensor to a auto part store and have it tested, " this sounds like you have a defective map sensor.

Posted on Apr 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987 reliant le 2.5 my trouble codes are , 1.2 , 1.3, 5.5 what does this mean?


Been a long time since I have seen one of these on the road............. I used to own one.

Code 1.2 means that the battery has been disconnected recenty (or died)
Code 5.5 means it is the end of the codes.

However Code 13, or 1.3 as you state............. is a MAP sensor code. These vehicles are notorious for MAP sensor Issues.

First inspect the vacuum hose for cracks or breaks, I suggest replacing it anyway because the car will barely run without it. If the vacuum hose does not help, make sure the sensor is actually getting vacuum from the engine in-case it is clogged. If it is them remove the electrical connector from the MAP sensor with the key ON but the Engine OFF. Use a volt meter to check that one of the pins has about 12 volts, another should have 5 volts, and the last should have Ground. if these are ok then you will need a new MAP sensor.

Oct 19, 2014 | 1987 Plymouth Reliant

1 Answer

Need to know where the vacuum line goes when it comes out of the map sensor on a 1987 chevy blazer


From the map sensor to vacuum port on the front of the TBI unit somewhere near the fuel inlet and outlet lines

Sep 28, 2013 | 1987 Chevrolet S-10 Pickup

1 Answer

I have a 87 Suburban V10 I have change temp sensor, new throttle body, map sensor, spark plugs. wires, and still can't figure it out. Went to pass someone and it started flooding itself and would not stay...


Change your fuel filter. Replace the distributor cap and rotor. If you have the HEI ignition, they are really bad about burning through the igniton rotor.

Dec 19, 2010 | 1987 Chevrolet Suburban

1 Answer

I have a 2001 dodge 2500 v10 gas. When started it runs rough regardless of temp. Code says mixture is too rich. The problem goes away if engine rmps are held between 3 and 4 thousand for about a minute and...


I commend you on your tenacity. I guess the code is P0172. So you have metered air due the the MAP and IAT in combination and good engine coolant signal but still too rich and runs rough. It all points to a leaky fuel pressure regulator valve.

Jun 24, 2010 | Cars & Trucks

1 Answer

My chevy S 10 1987 is giving me a code its 34


The MAP sensor. Voltage from the MAP sensor is too low. Could be the MAP sensor is bad. Also check for any vacuum leaks.

Mar 17, 2010 | 1987 Chevrolet S-10 Pickup

1 Answer

I need a vacuum diagram for a 1987 chevy 305 with tbi


NAPA IS A GOOD PLACE FOR HARD TO FIND PARTS

Jan 28, 2010 | 1987 Chevrolet V10

2 Answers

1987 chevy S10 engine idle problem


relace the throtle air idle valve.The temp switch will allso cause this problem.

Jul 19, 2009 | 1987 Chevrolet S-10 Pickup

2 Answers

1987 chevy engine problem


you have to reset base idle see manual at library for procedure

Jul 19, 2009 | 1987 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...