Question about 2004 Nissan Murano
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2004 mazda 3 stalls off idle
i found out from dealer there was a service bulitan for this problem. mazda reprogram the ecm for idle speed contorol . problem solved.
Posted on Jan 28, 2009
SOURCE: 05 murano runs rotten
check the air ducts that are clamped on between the air filter and the intake, sounds like air is getting leaking in. make sure the air box is on right and the clamps are tight
Posted on Apr 17, 2009
Check the oil pressure switch. If it has three wires, the third one is for the fuel pump. If the switch is bad no power will be sent to the fuel pump. The switch is used for initial starts for when oil pressure has been amended the switch turns on the fuel pump circuit
Posted on May 23, 2009
maybe your iac valve is not working? it takes place of a choke or temp sender to computer could be bad which controls t I.A.C. known as the idle control valve,do you have any codes?
Posted on Sep 01, 2009
sounds like it has lost its learned idle value.will it keep running if you keep your foot on the gas pedal?have you had any work done recently that the battery had to be diconnected for?if it has higher mileage carbon deposits may have built up aruond throttle plate to the point that the computer can no longer compensate for the restriction of air flow at idle.if the answer is yes to any of these questions i would recommend having idle air volume learn procedure done and cleaning throttle plate and bore.
Posted on Mar 16, 2011
Tips for a great answer:
Mar 06, 2014 | Volkswagen Beetle Cars & Trucks
Engine stall or RPM fluctuates
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Sep 13, 2012 | Cars & Trucks
Here are the most common causes of idle surge, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake
Sep 28, 2017 | 1999 Mercury Villager
Mar 09, 2010 | 2000 Ford Taurus
Sep 01, 2009 | 1995 GMC Safari
Jun 03, 2009 | 2003 Chevrolet S-10
Apr 13, 2009 | Ford F-150 Cars & Trucks
Apr 06, 2009 | 1995 Ford Escort
Jan 30, 2009 | 2004 Saturn VUE
Sep 12, 2008 | 1990 Buick Century
327 people viewed this question
Usually answered in minutes!