Question about 1998 Toyota Camry

Open Question

Transaxle removal on 1998 toyota camry - 1998 Toyota Camry

Posted by on

  • John Hicks
    John Hicks Apr 11, 2011

    not enough info left side or right side

×

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 65 Answers

SOURCE: 1998 toyota

There is a pin that you have to push in on the bottom of the lock cylinder housing.It is recessed in a hole.You have to turn the key to acc or on to get it to push in.Once you push it in you can pull the key and lock cylinder out.

Posted on Dec 02, 2008

  • 318 Answers

SOURCE: 1998 toyota camry , 2 codes, p0171. + p1133

P0171 lean code. Clean the maf sensor. A f sensor is inthe exhaust pipe.

Posted on Oct 27, 2009

  • 216 Answers

SOURCE: 1994 Camry: 1998 Toyota camry power window fell in door...

your problem is damage window regulator, you can change it by removing the trimboard first to give way in removing the old window regulator assembly.

Posted on May 06, 2010

  • 1374 Answers

SOURCE: 1998 Camry: Toyota 1998 camry After I replace two rear struts...

You may have dinged , pinched or dirtied a wheel / speed sensor. reinspect your work carefully you'll find it.

Posted on May 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse controls the backup lights?


Fuses complete a circuit,like a straight piece
of wire
Replacing a fuse won't fix a thing
Check all fuses
You need an owners manual for location,
once you find the correct fuse panel
Not likely you have a fuse issue
Check the back up switch somewhere around
transaxle

Jul 24, 2013 | 1998 Toyota Camry

1 Answer

My 1998 toyota camry wont start


remove the distributor cap and check for corrosion on the points or carbon tracking lines inside the cap...most likely needs a full tune up being plugs, wires, cap and rotor

May 03, 2013 | 1998 Toyota Camry

1 Answer

1998 toyota camry won't reverse and hesitating in drive


This could be a fault with the shift valve, hopefully just requiring cleaning. This is accessible with the trans pan removed, best done on a hoist.

Dec 30, 2012 | 1996 Toyota Camry

1 Answer

How to remove a 1998 Toyota Camry CE transmission


Pretty long and involved procedure for a not too difficult job.
I wouldn't attempt it myself, without a repair manual for guidance.
A Haynes manual for your car would be my choice. Some prefer Chilton's. They cost about $25. at parts stores.Any repair manual would have a step-by-step directions for transaxle removal. Libraries also have good reference materials on car repairs.
Alldata/DIY has an excellent on-line repair service with very detailed guidance and procedure and troubleshooting-the whole 9 yards. Cost for a 1 year subscription is 26.95 for one car, with discounts for 2 or more vehicles. It's like having the factory service manual with an expert over your shoulder giving tips and advice for the DIY'er.

Dec 05, 2011 | 1998 Toyota Camry

1 Answer

Can I replace the trans-axle through an access on the outside of the transmission? Or is it necessary to remove the transmission in order to change the trans-axle on a 1998 Camry?


the trans axle is the tranny...but if you meen the c.v axles you can take off the axle nut ..then remove the tie rod and lower ball joint and change the axle shaft with out tranny removal.. the tranny is called a transaxle on a front wheel drive car cause the differential and the tranny is one unit where as on rear drive car you have the tranny and then a rear diff connected bt a drive shaft where there is 3 seprate units

Feb 21, 2011 | 1998 Toyota Camry

1 Answer

1994 Camry: 1998 Toyota camry power window fell in door...


your problem is damage window regulator, you can change it by removing the trimboard first to give way in removing the old window regulator assembly.

May 06, 2010 | 1994 Toyota Camry

1 Answer

Replacing a rear seat belt in a 1998 Toyota Camry


if its centre belt remove rear seat to undo bolt out side one remove cover on upper belt to expose bolt

Jun 03, 2009 | 1998 Toyota Camry

1 Answer

Removal and installation of an auto trans in 2002 toyota camry


  1. Before servicing the vehicle, refer to the Precautions section.
  2. Drain the transaxle fluid.
  3. Remove or disconnect the following:

    Negative battery cable. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding Battery Air cleaner assembly Throttle cable from the throttle body Cruise control actuator cover and connector, if equipped Ground wire Starter Speed sensor connectors, direct clutch speed sensor, and the park/neutral position switch connector on the transaxle Solenoid connector on the transaxle Shift control cable Oil cooler hoses Front side transaxle mounting bolts Front engine mounting bolts Oil cooler line mounting bolts from the front frame Upper transaxle to engine mounting bolts

    0900c15280197a59.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Tie the steering rack to the engine support fixture components, as shown-Avalon and Camry
    Front exhaust pipe Engine side covers and undercovers Both halfshafts Front side engine mounting nut Rear side engine mounting bolts (remove hole plugs) Left side transaxle mounting bolts Steering gear housing Front frame assembly Rear end plate mounting bolts Torque converter cover Torque converter retaining bolts Remaining transaxle mounting bolts Transaxle

Apr 09, 2009 | 2002 Toyota Camry

2 Answers

Engine removal for toyota camry


its so easy just remove the engine mouts with a cherry picker holding the engine by the lift claws, then just remove the transaxle by a couple bolts then remove all other wiring and hosing and lift it out simple

Jul 27, 2008 | Toyota Camry Cars & Trucks

Not finding what you are looking for?
1998 Toyota Camry Logo

Related Topics:

235 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...