Question about Honda Accord

1 Answer

1993 Honda accord. The oil is gushing out where the oil filter housing meets the engine block.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 158 Answers

Sachemjoeqo, There is a rubber gasket between the housing and the block which hardens and cracks over time that needs to be replaced. The only problem here is that it is not the easiest thing to get at. If you are doing this yourself, put the front wheels up on ramps and be sure to block the rear wheels. Remove the oil filter and then the housing, be sure to clean the block and the housing before reassembly. Good luck with this.

Posted on Apr 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 honda accord heater hose diagram


I have a 1993 honda accord ex that leaking water behind engine near my oil filter it was leaking water above it How do I fix the hose show me how

Nov 29, 2011 | 1991 Honda Accord

1 Answer

1993 Accord,is there a O ring between the block & the oil filter flange?


Yes make sure to grease it with some unused oil when you put the new oil filter on

Jan 29, 2011 | Honda Accord Cars & Trucks

2 Answers

Looks like the oil is leaking out right above the


oil filter screws onto an adapter housing which also has the pressure sending unit on it (above oil filter). This adapter housing bolts to the block with 3 bolts. if oil appears to be leaking from where the adapter housing meets the block (especially at the rear side of engine near bottom), then you need to replace the siamese o-rings between the adapter housing and the block ($12 part at dealer). remove lowest 12mm bolt and loosen top 2 12 mm bolts(top 2 bolts won't come out unless you drop the engine down, but loosening 1 inch is all you need), replace o-rings and retighten bolts. be careful not to get dirt/grit between block and adapter. just finished doing this to son's 95 2.7 v6 which was leaving an 8" puddle of oil after idling for only 1 minute-worked perfect

Feb 24, 2010 | 1995 Honda Accord

2 Answers

Where is the oil pressure sending unit on a 1993 jeep grand


on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor, mounted in engine block.
on the v8 Under hood, center, rear engine area, passenger side of distributor, mounted in block.

Feb 09, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Oil filter base plate


it does have an O ring buts its irregularly shaped. it is usually held on by 3 bolts(mine was). and the top most bolt was very close to my oil pressure sensor....(had to take it out to avoid breaking it) i needed a very short ratchet wrench and get it out. Make sure you get the ring from a Honda Dealership if you can.(i have bad luck with aftermarket parts on my Hondas).The reason why mine was spraying is because the baseplate was actually cracked. so i also had to buy a new one ( yes they have them too) O-ring 12.00 bucks baseplate was 39.00 bucks for me, might be a bit more for yours since your Honda is a little newer (mine was an 89 accord) oil filter baseplate or mountplate are some terms (so you were right on) hope this helps.

Mar 08, 2009 | 1993 Honda Accord

2 Answers

Where & how to install thermostat in honda accord 1992


some one removed it replace it, the how to do is in the box.
leroy

Dec 17, 2008 | 1992 Cadillac DeVille

2 Answers

Oil leaks from the oil filter adapter


If it is not the suggested gasket that is leaking then it is the oil pressure switch located exactly above the oil filter adapter. The black plastic housing could have developed a crack and oil will ooze downward and drip off the bottom of the adapter. I had this problem and changing the oil pressure switch took care of it.

Dec 17, 2008 | 1993 Honda Accord

2 Answers

Location of oil filter


Rear of motor under intake manifold acessable from under vehicle between fire wall and engine.

Dec 04, 2008 | Honda Accord Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...