Question about 1995 GMC Sierra

Open Question

Postive(+) reverse light location and color of the wire

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 Chevy Uplander and I'm trying to connect a reverse backup camera to my car and I do not know which wire is positive for the reverse light bulb


open up the rear bulb compartment cover
and note the color wires running into the reverse light bulb holder

a hand full of fuses as you
use a LED test light or voltmeter to find the right wire

and use those color wires as your power /earth for the reverse camera

or you need the rear loom wiring diagram for that 2006 chev

Oct 13, 2016 | Cars & Trucks

2 Answers

I have a 1994 plytmouth gran voyager mini van sometimes it wont turn over at all then a little while later it will start until today i get a clicking in the starter relay sometimes if i put...


yes replace neutral safety switch. located on transmission on front left corner, its the one that is screwed in at an angle just above the pan

Nov 29, 2010 | 1994 Plymouth Voyager

1 Answer

Need to know how to hot wire ignition.what color wires do i use?


1991 Ford F150

Vehicle Battery Positive Wire (+): Yellow
Vehicle Battery Positive Wire Location: Ignition Switch Harness
Vehicle Ignition Wire (+): Red/Light Green
Vehicle Ignition Wire Location: Ignition Switch Harness
Vehicle Second Ignition Wire (+): N/A
Vehicle Second Ignition Wire Location: N/A
Vehicle Accessory Wire (+): Gray/Yellow
Vehicle Accessory Wire Location: Ignition Switch Harness
Vehicle Second Accessory Wire (+): N/A
Vehicle Second Accessory Wire Location: N/A
Automobile Engine Starter Wire (+): Red/Light Blue
Automobile Engine Starter Wire Location: Ignition Switch Harness
Automobile Second Engine Starter Wire (-): N/A
Automobile Second Engine Starter Wire Location: N/A
Factory Anti-Theft System: None
Factory Anti-Theft System Type: None
Car Key Sense Wire (-): Black/Pink
Car Key Sense Wire Location: At Steering Column Harness
Car Neutral Safety Wire (+): N/A
Car Neutral Safety Wire Location: N/A
Car Tachometer Wire (-): Tan/Yellow
Car Tachometer Wire Location: At Ignition Switch Control Module in Driver Fender Well
Car Speed Sense Wire: Gray/Black
Car Speed Sense Wire Location: Pin #3 at PCM Mounted on the Firewall
Car Parking Lights Wire (+): Brown
Car Parking Lights Wire Location: At Headlight Switch or Driver Side Kick Panel
Car Brake Lights Wire (+): Green
Car Brake Lights Wire Location: At Brake Switch Above the Pedal
Car Reverse Lights Wire (+): Black/Pink
Car Reverse Lights Wire Location: At Switch on Transmission
Car Horn Wire (-): Blue
Car Horn Wire Location: At Steering Column Harness

Sorry friend, this is as far as i can go to tel you how to hot wire the ignition. But with the color codes you should be able to figure it out, Good luck and keep me posted.

Jan 23, 2010 | 1991 Ford F150

1 Answer

Reverse light wire code or color?


PLEASE UNDERSTAND that if you mess with any of the lighting on this vehicle it could cause the control module for the lighting system to malfunction and go out and this part the last time I replaced one was$970.00.

Sep 10, 2009 | 2004 Volkswagen Touareg

1 Answer

My revirse lights do not work


Really dont need to know color of wire for this system is simple. On the switch (left rear corner on transmission) there are three wires. one wire is power, one allows it to start in park or neutral and the other is for the reverse lights. If I remember correctly the two outer terminals operate the reverse lights. Find the power lead and jump to each of the other two to determine which is for the reverse lights. Likely you will find that the switch is bad and there is no wiring problem. Make sure that reverse lights have good grounds as well.

Aug 16, 2009 | 1987 Dodge Ram Wagon B250

2 Answers

HOW TO INSTALL A EXTRA REVERSING LIGHT TO ILLUMINATE TOW BALL ON MY CARAVAN AT NIGHT.I HAVE A REVERSING CAMERA FITTED BUT IN BAD LIGHT IT IS USLESS.


connect a new light on to the same circuit as the reversing light, take the postive off the reversing light, the earth goes to ground on the new light

Aug 10, 2009 | 2009 Toyota Land Cruiser

1 Answer

I have a 6 p0le from the truck to a 7 pole on the camper how do i wire it so the backup lights work? its a 91 camper special


usually the trailer plug isnt wired for backup lights,i guess you will have to wire it manually,check the color of your wire to the backup lights of your truck,locate that wire underneath the back bumper and splice a wire to it to hook to your plug to the trailer.make sure the reverse wire from your trailer matches up with the terminal at your truck

May 08, 2009 | 1991 Chevrolet C/K 2500

1 Answer

Need to replace starter im not mechanical incline. i know basic


Get a chilton manual online if you a DIYer and it will save you time and money..Basic step by step-Remove postive batt cable. locate starter, obtain new starter to see location of mounting bolts,remove starter mounting bolts,remove wires firrst if accessable if not starter will lower when mount bolts out ,then remove wires noting where they go. hookup wires and replace in reverse. note:some can be hard to get to-always handy to refer to a manual Good luck..oh replace positive cable when aal is tight and right...

Jan 20, 2009 | 1990 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...