Question about Dodge Charger

Open Question

2006 dodge charger 3.5l. Remove and replace starter

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 330 Answers

SOURCE: 2006 dodge charger with hemi

1. check the battery first

usually the battery run down.

Posted on Jul 06, 2008

emissionwiz
  • 75817 Answers

SOURCE: 2006 Dodge Charger

this is not normal if you are not an aggressive driver, if you really drive the car hard then yes it is normal, since it is an R/T I will assume you are the latter. Rotors get damaged from heat of hard braking and warp making the brake pedal pulsate or the front end shake or both when the brakes are applied, is this your issue? if so take it easy on the brakes, make less aggressive stops. You could go to aftermarket HD brakes (rotors, pads), check on line for these kinds of parts, many companies sell them.

Posted on Oct 08, 2008

  • 61 Answers

SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L

In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!

Posted on Jul 25, 2009

  • 1 Answer

SOURCE: cannot remove rear rotor

you can also spray a good amount of W-4 or any kind of rust solvent where the disc sits on the hub. Let it stay for a while make sure it is soaked, make sure the car is in Neutral not in park!! What you would want to do then is hammer with a 4LBS plastic mallet from the inside out of the rotor by rotating it in three to four different positions. Repeat this process a couple of times and it will come off. Make sure there is no locking washer on the wheel bolts, if so you will have to cut them off. Trust me i just changed mine two weeks ago and it worked fine!

Posted on Aug 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace starter on 20058 dodge charger


remove positive battery cable jack up car place a jack stand under frame(safety first) remove heat shield covering solenoid(if there) 2 bolts hold starter in place(usually 15mm) remove battery cable from solenoid(usually 13mm) remove ignition wire from solenoid(can be a 10 or an 8 mm) then reverse process to install

May 18, 2014 | 2008 Dodge Charger

2 Answers

2006 charger 2.7L won't crank. Replaced battery. No oil in crankcase


Was it running with no oil? No click at starter or anything?

Mar 04, 2014 | 2006 Dodge Charger

1 Answer

Also, 2006 Dodge charger base 3.5L. I replaced rear pads and rotors today. I am doing the front in the morning. Is there anything different I should know? -Thanks


Very simple. Just bleed system when done and make sure to remove the brake fluid cap before pressing in the caliper pistion. Good luck

Oct 18, 2013 | 2006 Dodge Charger

1 Answer

Where is the flywheel on a 2006 dodge charger


fine the starter. it turn the flywheel

Aug 25, 2013 | 2006 Dodge Charger

1 Answer

Where is the starter located on a 2006 dodge charger rt


You can try the way to find a starter. Look where the engine ends and the ****** starts, that I mean where they are both connectd, look in the area, you will be able to find it.
_________________
AK500 key programmer

Sep 11, 2012 | 2006 Dodge Charger RT

2 Answers

2006 Dodge Charger will not start, battery and starter is good, dash lights up.


If the security system is not on - a mechanic would check for voltage at the starter, the neutral safety switch, and the key switch.

Jul 31, 2012 | 2006 Dodge Charger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

625 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...