Question about 2006 Chevrolet HHR

1 Answer

Starts car cranks only with remote when you put key ib ignition car quits

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

Sounds like there is a problem with the remote start system, either the "brain box" for this system has gone bad, or someone connected it to the vehicle incorrectly

Posted on Aug 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Remote Start Ford Exp 2003


try another key, if you install another key with ignition in the on position for 3 seconds warning light off, then turn off ignition switch, then start engine.if engine still dont start and the pats warning light keep flashing and dont turn off in 3 seconds.you need have vechicle pats system scan at dealership, you need diagnostic equipment to trouble shoot the PATS SYSTEMS.many things will cause you problems like fault to ecm to the immobilizer control module,could have worn transponder on key or faulty read coil in the ignition switch lock cylinder.

Aug 25, 2012 | Ford Explorer Cars & Trucks

1 Answer

Why won't my 2008 Chrysler Aspen start?


You have 2 issue going on. Its not seeing a valid key,and it is starting with the remote.Your remote entry key did it happen to get wet? Or moisture get in? Lock the vehicle up using the key. enter the vehicle using the key fob.After the vehicle unlocks you have 60 seconds to enter the vehicle insert the key in the ignition start it up.Your remote start up is out of step.

Mar 10, 2012 | 2008 Chrysler Aspen

1 Answer

No power to startet when key is turned check relays they r goood can put power to starter and it will crank any idear


will your car start if you put ignition key in run postion and then put remote power to the starter to crank engine? If it will you probably have an issue with the electrical portion of your ignition switch. Check to see if you have power to the high voltage side of your starter relays. If not check for a bad fuse. If so check to see if low side powers up when key is turned. If so it means you are gettintg current from the switch. So keep checking for power all the way to the starter. If not check and replace the ignition switch.

Dec 21, 2011 | Rolls Royce Silver Spur Cars & Trucks

1 Answer

I have a 1996 BMW 318TI and when I turn ignition, the engine dosen't turn, but when i put a remote starter the engine turns, but no spark fire from spark. I need a solution to fix this quick!


Does the key have a alarm on it if it does youll need to replace the battery in the key.When the key is put in the transponder sends a signal to give spark and it does.then it starts. If you say the key doesnt have a alarm try this when the key is turn to the ACC position do you hear the pump. now if you crank it with the remote does the pump turn on? If yes you can do this go to the crank sensor pull on the harness(crank sensor has a tendency to get loose) does the crank move if it does youll need to tighten it up with the proper gap. if it doest solve it do this. close the door with the battery at a proper charge put the key in the door unlock it get in put the key in ignition now does it crank. If no you have a alarm problem.

Apr 23, 2011 | 1996 BMW 318

1 Answer

I have a 2005 Ford Taurus SE and the key doesn't work now. I put the key in the ignition and try to start it but it doesn't crank. All the lights come on on the dash but it doesn't start. I put my new...


the chip in the key has gone bad . this can happen real easy .....at the checkout counter in most stores there is a device under the counter that when you buy something the checker drags it across to deactavate a small chip so you can leave the store ....... this device can KILL THE CHIP IN YOUR KEY so keep keys clear of it ......this key must be replaced it cannot be reprogramed

Jan 28, 2009 | 2005 Ford Taurus

3 Answers

Key Does not Work.


Ok, If it is the Factory Key, It should have the Plastic Finger grip at the Top. This Finger Grip has a Transponder Chip inside that Tells the Ignition that the Key is the Correct Key for this car, Go ahead and Start. These Transponders do Stop working Sometimes. If you will take the Key to the Dealer they can Reprogram the Key to work for you. But, It has to be the Factory key for this. If you have had a Key made, The key will not have the Chip inside it and will only work on the Doors. Please Rate my Response, I need all the Help That I can Get! Thanks!

Jan 28, 2009 | 2005 Ford Taurus

5 Answers

1999 Chevy S-10, how can I bypass the Security Fuel shut off sytem?


the way that i was told how to do a quick fix for is to hold the key in the electrical start and the actual start up of the engine and hold it there tell the security light is solid and then turn off the truck then bring it back to that point and let it blink until it turns off then you can start the truck.

Jul 11, 2008 | 1999 Chevrolet S-10 Pickup

Not finding what you are looking for?
2006 Chevrolet HHR Logo

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...