Question about 1993 Volkswagen Jetta

Open Question

Bosch 0 261 203 058 ECU on 93 volkswagen jetta III GL 2.0 auto trans made in mexico VW ECU #037 906 258E need to know which pin connects to vehicle speed sensor, a good wiring diagram would be most helpful

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fossilruins
  • 114 Answers

SOURCE: how to replace a coolant temp sensor on a 2001 vw jetta 2.0

here is a picture of where it's located on your jetta:

5cedee0.gif

Posted on Jun 21, 2008

Ad
MrScary66613
  • 1990 Answers

SOURCE: Engine Control Unit(ECU)

The ECU is a Direct Link to the Onboard Computer. You may need to get the Computer Replaced or at Least have a Mechanic run a Diagnostics Check on it. The reason it is acting this way is Because you are just Clearing the Trouble Codes by removing the ECU for a while. It is still sending a Fatal Error after Driven for a While.

Posted on Jan 21, 2009

  • 9 Answers

SOURCE: transmission fluid level check 02 jetta tdi auto

VW didn't put a "dipstick" on the trans for whatever reason. You technically have to use the VW Vag-Com scanner to properly check the trans fluid level as VW says it has to be checked at a specific temperature. But there is a "shade-tree" workaround. Start the car and leave the engine running the throughout the entire procedure. You have to get the trans fluid warm-a little under normal operating temp. 95F-104F is what you want-you can attain this after letting the car idle for 8 or so minutes. Continuing, leave the trans in park, and make sure you are on as level of a surface as possible. Then loosen the allen plug on the bottom of the trans pan. You will then see another plug. Remove this plug. Fluid should just trickle out of the hole if it is at the proper level. If it trickles out, you are good. If it doesn't you need to add fluid. Add VW spec ATF through the fill port.The fill port on the top front of the trans is capped off by a red cap and is very visible. Very carefully pry the cap off and then wiggle the plug out. I'd highly suggest having a spare red cap on hand-VW dealer has them. Then you can pour fluid into the trans. Add a little bit at at time, and all the while watching for the fluid to tricke out of the trans plug hole. When it trickles out, replace the inner plug and then the outer plug. That's it. Recheck after driving the car for a few miles. FYI- A flud and filter swap on the the VW auto trans takes 3 liters, so keep that in perspective. I hope this helps you out.

Posted on Apr 14, 2009

  • 257 Answers

SOURCE: Code P2185 2005 VW Jetta 2.5 5cyl

There are two coolant temp sensors. One by the oil filler tube and one near the bottom radiator hose near the radiator.
When you flushed the coolant did you replace with VW rated G12 coloant? Very Important! - You can't use over the counter coolant - it'll cause sludge in your system. You have to use G12...

Hope this helps!
Please rate/vote! Thanx!

Posted on Jul 18, 2009

  • 297 Answers

SOURCE: I have a 1996 VW Jetta, odomoter and speedometer

Either you have a broken wire some where from the speed sensor to the cluster or you have connector at fault, the one which hookup the dash cluster to the main wire bundel. Check the connector, maybe a pushed back pin !!

Posted on Aug 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What tool do I use to put trans mission fluid in my 2001 Vw Jetta


2001 Volkswagen Jetta GL Sedan (9M2) L4-2.0L (AEG)


Vehicle » Maintenance » Fluids » Fluid - A/T » Service and Repair » 5 Speed 09A Transmission
  • 5 SPEED 09A TRANSMISSION
ATF, Replacing
  • Remove sound insulation tray.
  • Place drip tray under transmission.

  • Remove drain plug (arrow) in transmission housing.
  • Drain ATF.
  • ***** in drain plug with new seal and tighten to 45 Nm .
If ATF needs to be topped up, then only ATF with Part No. G 052 990 A2 may be used.

Mar 12, 2016 | Cars & Trucks

1 Answer

How to remove power stering light on 2008 volkswagen


Power Steering light coming on,it can be due to error code stored in ecu.The vehicle needs to be scanned.

For more help.Click the link below:----VW Jetta :Yellow Power Steering Light?
http://howtobyme.blogspot.in/2012/06/vw-jetta-yellow-power-steering-light.html

------------------
This will help.
thanks.

Jun 05, 2012 | 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

TIRE SIZE FOR JETTA 2003 G.L 2


2003 VW Jetta GL 2.0

If the vehicle is running with the standard factory 15 inch (diameter) by 6 inch (wide) wheels, the tire size used with this wheel fitment was 195/65/15.

The sizes on the tires you have fitted now are found on the side wall of each tire.

Dec 10, 2010 | 2003 Volkswagen Jetta TDI

1 Answer

How do you clear the codes in a 1994 Jetta III GL (OBDI) without the scanner?


remove the battery terminal for about an hour, when you reconnect put key in and turn engine of a few times engine ecu should reset, but only if there are no actual faults. ( rate me thanks )

Aug 30, 2010 | 1994 Volkswagen Jetta

1 Answer

Does a 1992 1.8L vw jetta GL have an interference engine?


My manual for '93-'98 models calls for a timing belt replacement every 60K, and the engines are the same for earlier models, VW didn't do much different to them during that time.

Feb 28, 2009 | 1992 Volkswagen Jetta

2 Answers

1995 jetta GL Locks in Gear.


check the torque converter

Sep 14, 2008 | 1995 Volkswagen Jetta

Not finding what you are looking for?
1993 Volkswagen Jetta Logo

Related Topics:

307 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...