Question about Jeep Wrangler

1 Answer

I recently put my 98 jeep wrangler on a computer and the computer said i had a random misfire on the #6 cyl. What do i need to check or replace to solve this problem.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 38 Answers

Replace all the spark plugs and wires and reset the code. If code starts coming back i would look into the fuel injectors or worse a burned valve. Hope this helps!

Posted on Apr 10, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

03jeep lbertyrandom missfire cyl 2 4 6check engine light flashing


Check Engine Light/Misfire Due to Intake Valve Locks ...

repairpal.com > Problems > Jeep > Liberty
Jeep Liberty Check Engine Light/Misfire Due to Intake Valve Locks/Valves. ...Misfire cyc 4 and random cyc misfires, changed coil packs and plugs... sounds as if rod ... Light came on again (misfire on cylinder 4) - switched coil from 4 to 2. Light ...

Jeep Liberty Questions - Cylinder Misfire code - CarGurus

www.cargurus.com > Questions > Jeep > Liberty

CarGurusMay 27, 2009 - #4 misfire new plugs and coil pack on #4 light came back on after 300 miles if ... How come it stopped misfiring for 2-3 months, and now is back? ... I have a 2005 Jeep Liberty 6 cylinder, engine light came on scaned the codes ...

Liberty Cylinder Misfire / Computer issue? - JeepForum.com


Nov 28, 2015 | Cars & Trucks

1 Answer

Sport Wrangler 6 cyl. Engine lite flashing. Diagnostic tool lists code PO305. I looked it up and it states misfire in cyl #3 & 5. How do I fix this?


Check the plugs, wires and coil pack for these two cylinders. Most lilkely it is the coil pack, they work for 2 cyclinders at a time. cylinder motors use 3 and 8 cyl moters use 4 of these. If your und=sure where the coil pack is, follow it backwards from the spark plugs.

Jul 08, 2011 | 2002 Jeep Wrangler

1 Answer

97 jeep 4.0 random misfires or back fires. Installed dist, dist cap, wires,and plugs. Also replace computer.


have you checked timing ? can be injectors bad or in fuel system . i think it could be a injector bad.

Dec 11, 2010 | 1998 Jeep Wrangler

1 Answer

1994 jeep wrangler 6 cyl 5 spd no start


have u ck out the ignition switch [not the key & tumblers],, or the neutral safety switch to see if u have power ,,also seen broken wire at solenoid on starter too,,hope it helped,,

Apr 05, 2010 | 1994 Jeep Wrangler

3 Answers

98 jeep wrangler 4.0 6 cyl auto spits and sputters under load


Hi JHWalker
I would try doing the fuel pump filter or fuel pump itself if they are one unit.

Hope this help you.

Matt

Sep 18, 2009 | 1992 Jeep Wrangler

1 Answer

Missing factory throttle linkages on 1990 YJ jeep. Need Diagram


Go to any scrapyard and you can get the entire setup for next to nothing...and you can see how it's hooked up!!!

Jul 07, 2009 | 1990 Jeep Wrangler

1 Answer

98 jeep wrangler 2.5L #4 misfire


check fuel for pressur and quantati to fuel rail posable fuel pump or regulator

Jun 09, 2009 | 1998 Jeep Wrangler

2 Answers

Runs rough, misses, sometimes then clears up.


You have a cylinder misfire. You need to check the distributor, wires, and pull the plugs because something is not firing the fuel mixture in one or more of your cylinders at timew. you can do the plugs yourself for the most part. I dont know how the 6 cyl looks in the engine compartment of the wrangler, but from my experience with a 96 XJ, number 6 cylinder is very difficult to get to because of the interior air intake vents. if all the plugs seem fine, you may want to take it into a shop for a distrubutor and wire check

Jan 24, 2009 | 1994 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...