Question about 1989 Dodge D150

1 Answer

How to put on a Oil Pump on a 89 dodge d150 - 1989 Dodge D150

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

If its a v8 its similar to the chevys. need to drop and steering linkage that is in the way of removing the oil pan. drain oil and drop pan. you will see a screen which is attached to the oil pump. the easiest way to remove this is a good flat head screwdriver and a rubber mallet or dead blow hammer. there is a lip on the screen that you can set the screw driver on. be very careful not to damage the screen unless you plan on replacing it. take note on where the screen is angled. this is important. you can measure with a steel rule or tape measure and measure from the screen to block or crank. remember measurement. its a tight fit so it may take some persuasion to get it out. once out remove th bolts holding the pump on. take your new pump and remove the cover plate that will expose the gears. hand pack the gears with a good assembly grease. then just reverse the steps. do not forget to angle the screen to the measurement you had.

Posted on Apr 10, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil leak on 1991 Dodge d150


You could possibly have a bad rear main crank seal.

Mar 26, 2014 | Dodge D150 Cars & Trucks

1 Answer

89 DODGE D 150 318


could be your coil is bad when it heats up it shorts out.

Sep 12, 2012 | 1989 Dodge D150

1 Answer

I have an 89 dodge d 50 pick up and there is a loud ticking in the engine my buddy says its a possible that its a valve tapping does anyone know where I can find a diagram of the valves so I can figure out...


You say D50 do you mean D150 if it is a V8 one lifter is making noise. Lifters are pumped up with oil so they act like a solid piece of metal if there is a little ware in the drive train the lifter can compensate. The lifter has a little dirt in it so it will not fill with oil.Change your oil and filter with good oil and add something to clean the lifter like sea foam.If it keeps making noise find out what side and which end of the valve cover. Remove valve cover have someone start the engine touch the top or the rocker arms by the push rods and you will feel the loose one. Unbolt rocker arm assembly pull out push rod run a magnet down the hole and pull the lifter out. If it won't come out because you didn't change the oil enough and there is a ridge around the bottom buy a tool or rent that goes down the hole and spreads to lock into the lifter slide the hammer bar up the tool it should come out. If you were really really bad at changing the oil the lifter could be mushroomed out on the bottom or the cam wore a hole in the lifter then you have to remove the intake manifold to get it out. Take the new lifter put it into a can of oil and push down on the top a few times to fill it with oil then drop it in and put back together

Nov 24, 2011 | 1989 Dodge D150

1 Answer

What kind of oil to use for a 1987 Dodge D150 Slant 6


You can use any oil you want. Just make sure that if you don't know what oil is in it currently that you drain the oil out and change the oil filter. Personally, I like the Chevron RPM oils and have two vehicles with over 200,000 miles that says they are good.

Aug 16, 2011 | 1986 Dodge D150

1 Answer

What transmission would be in a 89 dodge d150 with 318 EFI 3 speed auto trans?


Usually it is a 727 TorqueFlight or an A904 depending on engine type and output.

Jan 30, 2011 | 1989 Dodge D150

1 Answer

89 dodge d159 318 will not start unless spay ether or gas into carb, starts immediately then burns off ether an stalls. not getting fuel to TBI


sound like you have either a clogged fuel filter or a bad fuel pump
start with the fuel filter first keep it simple first
if that don't work for you then pull your fuel line off and cycle the key and see if the pump is putting out fuel
if you don't get fuel then change the fuel pump
hope I could help
leave some feedback if you could
good luck

Jan 23, 2011 | 1989 Dodge D150

1 Answer

Have 89 d150 just put 318 with 430 lift cam magnum heads 1.6 rockers witch i think bumped cam to about 480 lift.disconected the computer **** and made it carberated. still using electric fuel pump and...


You might just try bumping up the fuel pressure to 12PSi.
you useing a double pumper you need at least that.
I might need more info but sounds like a cool ride.

Dec 02, 2010 | 1989 Dodge D150

1 Answer

What is the firing order on a 89 dodge v6 3.9 liter and where is number one on the roter


For the 1988 thru 1996 Dodge 3.9L (238 cubic inch) V6:

Firing Order:

1 - 6 - 5 - 4 - 3 - 2

Cylinders:
........(back).......
|..6..|........|..5..|
|..4..|........|..3..|
|..2..|........|..1..|
........(front)

Distributor:
...................[.] clip
..........5
..6
........................4
1
.....................3
...........2
[.]-clip

Aug 12, 2010 | 1989 Dodge D150

1 Answer

My 1987 dodge ram d150 ran fine now it wong go over 30 miles an hour run strong up to 30 mph and the starts jerking and if i put my foot in the gas more it will die


I had the same problem with my 88 d150 the first time it was the vacum lines and the second time it was the fuel line leaking so check both alos make sure ur fuel pump is working and check ur fuel filter it might be clugged

Nov 10, 2009 | 1987 Dodge D150

Not finding what you are looking for?
Cars & Trucks Logo

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...