Question about 1993 Toyota Camry V6

1 Answer

Temp gage reads cold in 1993 camrey - 1993 Toyota Camry V6

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

More than likely have a bad thermostat. easiest way to check if that is problem is let the engine run for at least 5-10 min. after that grab the upper radiator hose with your hand. be cautious because if the thermostat is working properly this hose can be very hot. if it does not feel hot and has no pressure inside hose (you can feel like a garden hose: difference between on and off) then you need to replace the thermostat and gasket or seal. if you do have a hot and pressurized hose than you have a bad temperature sending unit. replace the part. good luck!!!

Posted on Apr 10, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Overheating gage when stop & go -2004 chevy tahoe


natural for engine temp to rise in Traffic - Until Themostat opens ) cooling fan sensor kicks on fan . But Antifreeze is not just a Cold weather item . Coolant is Absolutely Necessary for Hot Days . You must be full to recovery bottle setting of cold when checked prior to start up . Coolant for your make / model is Reddish - Pink colour and should have a reading of -25 thats negative 25 degrees the Lower the Better even - 50 .. Why ?? - 50 is 50 %% antifreeze / Coolant Concentrate MIX Gives Hot weather cooling Ability or very cold weather starting / winter HEAT .

Mar 14, 2014 | 2004 Chevrolet Tahoe

1 Answer

Transmission gets hot and temp gage works backworks


with a scan tool read data of transmission look for trans,temp.
if it said the same thing as the temp gauge in cluster
temp sensor inside transmission send info to PCM then pcm send message to cluster

Oct 15, 2013 | 1993 GMC Sierra K1500

1 Answer

Heater runs hot then goes cold


Do you have a temperature gage in your instrument cluster? When the temp goes cold, does the temp gage rise? Check your coolant level both in the radiator and the coolant recovery tank under the hood, and fill as necessary. If that is OK, then check your serpentine belt for wear and/or slippage around the water pump. Lastly, if you have a temp gage and are noticing fluctuations in the reading, you may need to replace your cooling system thermostat. Good luck.

Oct 04, 2013 | 2002 Chevrolet Silverado 1500

1 Answer

When I start the engine of my ford E150 v8, the temp guage goes immediatly to the warm range, when its cold. Is this the temp sensor? Is there a way I can figure out if this is the problem?


The easiest way to start diagnosing is disconnect temp. sensor connector and connect it to the good known sensor. If gage stays where it was, then this is not the sensor. Next step is to have electrical diagram of this model and see how exactly your gage is connected. It can be reading from ECM signal, or directly from that sensor. If it is direct reading, than it can be faulty gage or dashboard controller. In case it connected to ECM it can be incorrect ECM output (which very unusual).

May 02, 2013 | Cars & Trucks

1 Answer

95 dodge caravan warm when idles, cold when drivesd


Did you bled the air out of the cooling system? Do that and I bet it cures the complaint.

Oct 09, 2012 | 1993 Dodge Caravan

2 Answers

Temp gage on my 1998 explorer does not work. any ideas?


Hi and welcome to FixYa!

It can be a faulty temp sensor that's why it doesn't work. There are two locations to look at, it can be on the lower part of the radiator or it can be on the engine block. You will need to remove the connector then twist the temp sensor counter clockwise then replace. Once replaced you'll be good.

Hope this helps and thank you for using FixYa! Have a good one!

Mar 12, 2011 | 1998 Ford Explorer

1 Answer

I have a 1993 Acura Ledgend. For some reason my heater does not continue to blow hot air, it does for a few minutes and then begain to blow cold air. It does this often now. It works and then it blows cold...


first check to see that you coolant level is full, check it after the engine has cooled down,so there is no pressure in the system. otherwise you possibly have a head gasket in the early stage of failure

Nov 30, 2009 | 1993 Acura Legend

1 Answer

95 toyota camery smells like overheating or oil burning even when engine is cold


Check radiator fluid level. Electric temp gages do not read temp unless there is water present, no water no hot temp reading.

Oct 18, 2009 | 2000 Pontiac Sunfire

1 Answer

Temp Gage


sounds pretty normal. its not overheating but if you still want to do anything try replacing the thermostat and see it it changes

Jan 28, 2009 | 1991 Mazda Protege

Not finding what you are looking for?
1993 Toyota Camry V6 Logo

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...