Question about 1992 Mitsubishi Mighty Max

1 Answer

Looking for the timing mark for a 1992 Mighty Max 2.4L. What is the degree set at with a timing light? Thank you in advance

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 334 Answers

Hello bojak80,

The basic timing is 5 deg. BTDC. Below is a picture of the timing mark. I hope this helps you.

Looking for the timing mark - netvan_74.png


Posted on Apr 09, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Mitsubishi Mighty Max 92 needs to be trouble shot. Started up after sitting for an extended period of time, what parts were affected. It dosnt want to shift or drive really

I recommend changing out your transmission fluid, make sure you replace the screen too. After a vehicle have set for a long period of time it s good to flush all the fluids if you did replace them prior to the vehicle being stored.

Dec 02, 2014 | 1992 Mitsubishi Mighty Max

1 Answer

How do I go about manually resetting the maintenance required light on my 2.4L 1992 Mitsubishi Mighty Max pickup truck?

When service to the emission control system has been completed slide the switch to the opposite position, turning off the warning light.
If the service was for the 120,000 mile interval remove the warning light bulb.

CAUTION: If the speedometer is to be replaced set the odometer to the same reading as the odometer being removed. (consult your local motor vehicle laws)


Aug 25, 2013 | 1992 Mitsubishi Mighty Max

2 Answers

How do I get the trouble shoot code to read out on my 95 mitsu mighty max through the check engine light?

put car in nuetral, apply e-brake, turn key on and off three times and it should start to flash the codes

Mar 10, 2011 | 1995 Mitsubishi Mighty Max

1 Answer

I need to replace the timing belt, but i need to see the iming marks locations

Try looking for a sticker on the underside of the hood. If it's a 2.6, it should be 8 degrees BTDC.

Jan 04, 2011 | 1987 Mitsubishi Mighty Max

1 Answer

I'm looking for a crankshft pulley. It has 3

dorman aftermaket parts ,just got one bout $90.00

Jul 02, 2010 | 1992 Mitsubishi Mighty Max

1 Answer


If it is the 3.0 liter V6 there is a notch in the timing belt crankshaft pulley which aligns with a small mark above in the casting at the 1:00 position or so. As for the cams, each sprocket has a dimple in it which aligns with a vetical mark pressed in to the back steel dust covers.

I hope this may have assited,

Apr 14, 2010 | 1989 Mitsubishi Mighty Max Macrocab

1 Answer

The cheack engine lights on, on my 1992 mits mighty max, how do u read ob1 codes? my harness wont read

Don't waste YOUR time. Let the experts do it for free.
PepBoys will read it for 88 Dollars. Autozone will do it for free.
Get moving!! Don't distroy an engine for a few minutes of travel time.

Oct 17, 2009 | 1987 Mitsubishi Mighty Max

1 Answer

Dodge ram50 1992 swap 2,4L to 2,6L


Yes, the engine mounts and bell housings are the same.
The swap should be straight forward, however be sure to swap all the vaccum controls and emission system from the 2.6L.

Have fun!
Cheers, Jay

Apr 29, 2009 | 1992 Dodge Power Ram 50

1 Answer

What is the ignition timing for a 1995 mitsubishi mighty max?

In your owners manual.
If not about 5 degrees on most cars.
You need a stob light and chalck to check running.
Vacuum and distributor working properly.

Mar 06, 2009 | 1995 Mitsubishi Mighty Max

1 Answer

Mitsubishi mighty max pick up 1992

Something keeps draining the battery in my 1992 Mighty Max pick-up. Does anybody have any suggestions?

Jun 25, 2008 | 1992 Mitsubishi Mighty Max

Not finding what you are looking for?
1992 Mitsubishi Mighty Max Logo

573 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides