Question about Peugeot Liberte

Open Question

How do I remove the rear bumper from a 2004 Peugeot 307?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 205 Answers

SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"

usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Posted on Sep 04, 2009

Ad
  • 583 Answers

SOURCE: Peugeot 307 diesel 307 - Unblock diesel filter

if it says the diesel filter, then that is what it means,a fuel filter.normal service requirement on any vehicle and can be done for small dollars at any garage

Posted on Dec 04, 2009

  • 279 Answers

SOURCE: have a peugeot 307 rear passenger door stays

you need to replace the central locking motor
this is quite common on the earlier 307

Posted on Dec 07, 2009

  • 3741 Answers

SOURCE: how to remove starter motor on peugeot 307 1.6hdi

The hard bit is getting to the starter to unscrew the bolts and getting enough room to remove it once loose. YOu will need to take off a number things from the top of the engine.

The starter is located at the front middle of the engine under the diesel filter.

You will be able get to two of the starter bolts from under the bonnet and the other from below.

You will need to loosen or remove the wiring from around the top of the engine to allow you to remove the starter once loose. (remember where all the plastic connectors reattach).

You should only attempt to do this if you are fairly confident with spanners and have a decent set. You will need 10mm, 11mm, 12mm, 14mm spanners and sockets. 8mm socket, 8mm Allen bolt (straight allen key), small torque.

It is not difficult to do the job just to get to the starter and get enough room to remove and replace. Takes about 4 careful hours start to finish for a none mechanic with car on jacks.

You should always disconnect the battery while removing any electrical/mechanical part from car for safety reasons.

This will help. Thanks please keep updated. please please do rate the solution positively .thank you for using fixya

Posted on Mar 18, 2010

  • 6 Answers

SOURCE: peugeot 307 1.6

peugeot and citreon cars do bite high generaly, it is hydaulic there is no adjustment. but it also depends on how high it is ?? does it slip if you slightly rest your foot on whilst driving?? they do have a problem with the bearings going through the cover as it is the same bearing as a HDI . but you woud notice this as a different problem. ie noise or vibration on pedal. call me for more info .. paul @ the clutch centre..01527 64440 07790438337

Posted on Mar 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Peugeot 407 saloon , need to remove hitch bracket. How to remove rear bumper panel? Jj


I have no idea because the installation varies with the product, I know this is not factory.

Dec 15, 2016 | Peugeot Cars & Trucks

1 Answer

How to take out rear bumper of peugot 307 cc 2003


open bootlid (trunk) remove boot rubber and inside plastic panel on the body not bootlid there should be fasteners then trace fasteners at both fender linings and remove all fasteners under the bumper next gently pull both sides of the bumper away from the fender it only moves about 10-20mm then slide bumper off the vehicle remember as the bumper comes off you still need to disconnect number plate light and parking distance sensors if your vehicle has also if it has disconnect reverse camera

Jan 28, 2016 | Peugeot 307 Cars & Trucks

2 Answers

Peugeot 307 1.6hdi temperature gauge indicating low


Thermostat is not working properly means water is circulating through radiator without even reaching engine's operating temperature.

Mar 08, 2015 | 2004 Peugeot 307 1.6

1 Answer

Peugeot 307 est. rear wiper removal


get a new 1 or check the breakers yards

Aug 26, 2014 | Peugeot Cars & Trucks

2 Answers

Peugeot 307 gearbox problem


sounds like the gearbox selector, by the way have you checked the gearbox oil to see if its low or contaminated

Aug 11, 2014 | 2004 Peugeot 307 1.6

1 Answer

Peugeot forum


it is to the left side of the crankshaft pulley you should see cable going
to it. no 83 is the sensor hope this helps
th?id=hn.608033512317060713&pid=15.1

May 22, 2014 | 2004 Peugeot 307 1.6

1 Answer

How to remove a door handle of a peugeot 307 caboriet/convertible


Remove the door panels and look for mounting screws inside the door.

Feb 26, 2014 | Peugeot 307 Cars & Trucks

1 Answer

How to change headlight on a peugeot 307


you must take the bumper off and then you will find 3 screws2 on bottom 1 on top of headlight

May 28, 2010 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

414 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...