Question about Mercury Tracer

Open Question

How do i remove a headlight assembly on a 1999 Mercury Tracer?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 117 Answers

SOURCE: Mercury Villager headlight assembly diagaram for removal

it is a bit of a time consuming job it would be best to get a diagram to see where everything goes as this will help you alot otherwise take to a mechanic.
cheers
any feedback left would be great

Posted on Jul 01, 2008

Mike258
  • 1498 Answers

SOURCE: serpentine belt for 1998 mercury tracer

Hey there MSM,

  • Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
  • Get the belt around all the pulleys except the A/C compressor or Alternator. The routing diagram is on one of the radiator supports.
  • The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
  • Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  • Slowly release the tension.
  • You're done
Mike

Posted on Dec 14, 2008

  • 1 Answer

SOURCE: 2003 Mercury Sable headlight bulb replacement

This problem is now resolved, thanks to a prior post by sableowner.

http://www.fixya.com/cars/t1479995-2001_merc_sable_headlight_replacement

The 2003 Sable has the same headlight assembly and removal/replacement instructions as the 2001 Sable. Once I had this information in hand, bulb replacement was easy.

Posted on Jan 13, 2009

  • 1 Answer

SOURCE: How do I remove Head Light assembly

Just found this site with your answer.
http://www.toyotanation.com/forum/showthread.php?t=269762

Posted on Jan 19, 2009

  • 187 Answers

SOURCE: rear brake drum removal 1992 mercury tracer

Yes. and than the drum will come off. You will find that it will not move at first so take a hammer and tap, not slam, around the edge of the drum to brake the rust. It you have difficulty removing the 2 screws don't strip the heads. Take your screw driver and put it in the slot than tip it at an angle and hit the end with a hammer to apply force sideways to the screw. This will, in most cases, brake the rust and permit the screw to turn.

Posted on May 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 mercury tracer o2 sensor removal


Replacement of oxygen sensors on a 1997 Mercury Tracer LS. Sell the Tracer and buy a Ford Focus, or 2010 Chevy Cobalt, or a new Chevy Cruze, or a Ford Fiesta. This solution is best if your Tracer has over 130,000 miles on it.

Feb 16, 2012 | 1997 Mercury Tracer

1 Answer

How do i change bulb in headlight on mercury tracer? 1991.


1. Open the hood and remove the screws holding the headlight assembly in place. These screws are located on the back side of the headlight assembly.

2. Slide the headlight assembly forward.


3. Unplug the electrical connector running to the headlight ballast.


4. Slide the new headlight assembly and bulb into place, connect the connector to the headlight ballast and secure the assembly with the factory screws.

Feb 24, 2011 | 1991 Mercury Tracer

1 Answer

Lights on the dashboard of a murcuri tracer 93 won't turn on


* check your fuses
*check them again
* if all the fuses are good , its gonna be a bad headlight switch , because generally all the bulbs wouldnt burn out at the same time. but if you can remove the dashboard panel you can check the bulbs. but chances are its the headlight switch ( if its not a BAD FUSE) but check the fuses real good.

Jul 31, 2010 | 1993 Mercury Tracer

1 Answer

How do you get the headlight cover off a 1999 Mercury Gran Marquis?


You don't remove the headlight cover. You remove the bulbs from behind the lens assembly. Simply unplug the connector and twist the bulb to remove it.

Jan 29, 2010 | 2003 Mercury Grand Marquis

1 Answer

Need wiring diagram for 1999 mercury tracer


I may have one. I'll look if interested. $10

Jan 09, 2010 | 1999 Mercury Tracer

1 Answer

I'm trying to remove the axle shafts on my 1999 mercury tracer and have encountered some difficulty. I've sucessfully done this many times before but this time is different. I can't get either shaft out to...


This can be a difficult job i suggest watching this video as it has tips and tricks to remove that hard to remove axle's Good Luck !1

We Are Here To Help !!

Donald Deane MCSE,ASE,CPO

Aug 25, 2017 | 1999 Mercury Tracer

2 Answers

Where is ecm box located on 99 tracer mercury


It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 phillips head screws

Jan 24, 2009 | 1999 Mercury Tracer

1 Answer

How do I install headlight switch on 95 mercury tracer?


  • Headlamps Inoperative
  • Fuse.
  • Headlamp switch.
  • Headlamp relay.
  • Circuit.
  • Bulbs.

Section 11-05: Steering Column Switches 1996 Escort, Tracer Workshop Manual
REMOVAL AND INSTALLATION Multi-Function Switch
Removal
  1. stf~us~en~file=ani_caut.gif~gen~ref.gif WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR AIR BAG DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY AIR BAG SYSTEM COMPONENTS.
    Disconnect the battery ground cable (14301) and wait one minute for the backup power supply to be depleted.
  1. Remove the steering wheel (3600). Refer to Section 11-04 for the removal procedure.
  1. Remove the four screws from the lower steering column shroud (3530).




  1. Remove the ignition switch lock cylinder illumination lamp socket from the lower steering column shroud.
  1. Remove the lower steering column shroud.
  1. Remove the upper steering column shroud.
  1. Disconnect the three multi-function switch electrical connectors.
  1. Remove the multi-function switch screws.
  1. Remove the multi-function switch electrical connectors and the multi-function switch (13K359).

Jan 16, 2009 | 1995 Mercury Tracer

1 Answer

Hi, I have a 99 mercury cougar and I need to change the headlights. I am having difficulty finding the electrical connector so that I can pull the headlight assembly out and change the lights. Where is...


Headlamp Bulb Removal
  1. Remove the headlamp assembly. For additional information, refer to Headlamp Assembly .

Headlamp Assembly Removal
  1. Remove the radiator grille.7feecfa.gif

Remove the headlamp assembly.
2b42ecf.gif
remove the cover/
  1. f76b11b.gif
3.
sxu~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Do not touch the glass of the bulb with your fingers.
Remove the headlamp bulb (low beam bulb shown). 79891b8.gif

Jan 10, 2009 | 1999 Mercury Cougar

1 Answer

1993 mercury tracer


To replace the headlight on a 1993 Tracer you must turn the black plastic retainer ring counter clockwise and then pull back gently. The ring and bulb should then slide out toward the engine.
Carefully grab the sides of the plug and pull the bulb out.
When replacing the bulb make sure not to touch the glass part or it will cause the bulb to burn out sooner. Place the black ring back over the bulb with the open end towards the glass part of the bulb. Fit the wiring onto the back of the bulb and insert the bulb back into the reflector. The black plastic ring has notches that fit over protrusions. Turn the black ring clockwise and your done. Test the headlight. Happy Driving

Oct 08, 2008 | 1993 Mercury Tracer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...