Question about Chrysler Crossfire

1 Answer

Just bought a 2006 Crossfire. The area where the (Trip Milage) is, a beep then the Oil Logo with the word HI comes on once a day at least. The Manual says the Oil has too much and the oil pan needs to be drained or damage can occur?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 430 Answers

Yes its mentioned correct in manual.The HI indication comes on when there is about 1 quart too much oil. Get the excess oil drained.----------- CHECKING ENGINE OIL LEVEL:-------- A sensor in the oil pan allows oil level to be checked
without opening the hood. It provides an accurate measurement of oil level, whereas the low engine oil level indicator warns that oil level is definitely too low. With the vehicle parked on a level surface, the engine is warmed up and shut off for approximately five minutes.When the ignition switch is turned to the ON/RUN position, an ISO oil level icon appears in the trip odometer window and a "clock" icon in the cumulative odometer display. Pressing the knob to the left of the speedometer twice within one second displays one of the following messages:
• OK
• -1.0 Q (-1.0L)
• -1.5 Q (-1.5L)
• -2.0 Q (-2.0L)
• HI
The indicated amount of oil must be added to the engine
if the message -2.0 Q (-2.0L) blinks and a signal sounds.
The HI message indicates that the excess oil must be
removed from the pan to avoid possible engine or
catalytic converter damage. If the ISO oil level icon and
"clock" icon remain on when attempting to check oil
level and no message follows, or if the low engine oil
level warning lamp comes on, a malfunction in the
engine oil level system is indicated. A conveniently
located dipstick allows manual checking of the oil level.
If no leaks are noted, continue to drive to the nearest
service station where the engine oil should be topped to
the "full" mark on the dipstick with an approved oil.--------------------

Posted on Apr 09, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1 beep every five minutes, i have no oil ***** light on ever.


Is it the oil warning? Beeps can come from a number of areas. My door closed warning would beep when I braked. Seat belt intermittent, even your speed warning setting beeping once when over setting got me once. I didn't even know I had set it.

If the oil light comes on before starting, (as do all warning lights) and doesn't show up on the beep, it probably is not the source of the beep.

Cheers

Dave

Oct 24, 2014 | 2006 Ford Explorer Eddie Bauer 4x4

1 Answer

How do i check oil on mercedes cls 320 2006


Hi claude?
There is no deepstick for the engine oil. You can check your oil level from the steering wheel controls. Turn the ignition on, do not start the engine. press the page button till the milage and the trip miles are displaied. press the arrow button up or down till it comes up with engine oil level check, and wait till the engine has meassured the oil level.
If you want to change the oil, you need to measure how much oil comes out of the engine and put the same amount back in.

May 22, 2011 | Mercedes-Benz CLS-Class Cars & Trucks

1 Answer

I just bought a used tdi jetta 2006 at what milage should the timing belt be replaced??? always owned trucks never had to worry about this before


I would look in the owners manual, but I would say every 90K miles. Be sure to use VW spec oil. Very important to use the correct oil.

Nov 15, 2010 | Volkswagen Jetta Cars & Trucks

3 Answers

How do i reset oil change ligth on 2006 hummer h3 after oil change thanks from moises


To reset your maintenance reminder system (even if the light hasn’t come on yet), you’ll need to turn your key to on (but don’t start!) and make sure your odometer is on TRIP A. Then key off. Press and hold the Odometer/Trip button. While holding down on the button, key the ignition to on (Don’t start the engine!) The display panel will count down from “------“ to “-“Continue pressing the button until the Trip A is displayed. After this step, you are done.

Sep 30, 2009 | 2006 Hummer H3

1 Answer

My car has the oil light on


First - did you use the correct viscosity - SAE spec ?
Using a thiner oil can affect oil pressures.
Presuming that you did, and oil levels are ok, then I would check if this is a standard service light come one. They are programmed to light after a certain milage since the last change - and this seems likely if you have just done it (before light came on to remind you)

Try resetting it. This works for most models -
Turn ignition on - so you get display/ lights etc.
Set trip meter to show milage.
Turn ignition off.
Press trip meter button - and keep pressing it while turning ignition to on again.
Light should blink and go out.
Take finger off trip meter.
Depending on model - you may get some figures - 1200 , 800 , etc. This alows you to change service interval if you want - but if not - then just turn ignition off again.
Light should stay off.

If this doesn't solve it, I'll look for specific info of how to do it - or start checking other possible causes to check.

Aug 11, 2009 | 2006 GMC Envoy Xl

2 Answers

2006 Town and Country, While driving the warning lights came on (air bag, oil presure, low fuel, check engine, etc...) Speedometer stopped working, fule gauge went to Empty (had just filled the tank 11...


1)check the ignition switch is not loose.those things normally come on before starting.unless2) you have a main ground broken somewhere.rodents eat the wiring harness to build a nest and cause mayhem...i have seen that a few times .check the fusebox under the hood on the drivers side

Jul 04, 2009 | 2005 Chrysler Town & Country

1 Answer

How do i reset my kilometer gauge after changing oil or does it reset to 0 automaticly


Resetting Oil Service Light on your 2002 - 2006 MINI Cooper and Cooper S, and 2007 - 2008 MINI Convertibles:

1) Press and hold the trip button
2) Insert key and turn to position 1
3) Watch for RESET to appear
4) Release the button, then press & hold it again
5) Wait for the RESET to flash
6) Release the button, and then press & release (once only)
7) Service interval should then be reset to next interval
If that didn't work, try this:
1. Push the Trip Button
2. Turn ignition key to position 1 and 51A will appear to left of mileage
3. Release trip button
4. Wait 3 seconds
5. Push trip button
6. Wait (5-8 seconds) for RST to appear in left corner
7. Release trip button
8. Push trip button
9. 15000 will appear as new service interval
10. Release trip button

Or this:
1. Press and hold the trip odometer button.
2. Insert car key and turn it to the fi rst position (not the second position).
3. You will see 51A come up in the trip odometer area.
4. Release, then press and hold again.
5. Watch for the word “RST” to appear on the Odometer indicator.
6. Release, then press and hold again.
7. Wait for the “RST” message to fl ash.
8. Release, and then press & release (once only).

Apr 12, 2009 | 2003 Mini Cooper

1 Answer

RESETTING THE TRIP METER


Press the info button until you see Trip A or Trip B. Once you are looking at the Trip meter you want to reset, press and HOLD the info button. After 3 seconds, the dashboard will beep and the Trip meter will reset to zero.

Nov 18, 2008 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Oil changing


Will be in the owner's manual. Usually recommended every 5,000 miles.

Jul 22, 2008 | 2006 Toyota Matrix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

543 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...