Question about 1999 Plymouth Voyager

1 Answer

Runs very rich, replaced spark plugs, wires and coil cap

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

Check fuel pressure regulator

Posted on Apr 09, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an Acura tl 98 its missing fire #4 what could be?


Misfires are caused by fuel delivery problems, injectors or too rich or weak. Spark issues, coil, wires, spark plugs or the cap and roter.
I could also be a loss of compression. First thing to check is the easiest... spark plugs, spark and cap and roter. Also the cheapest.

Jan 23, 2012 | 1998 Acura TL

1 Answer

On a 1992 chevy 1500- 350 engine, I can not get this thing to get a spark- i have replaced the plugs and wire, distributor cap and rotor, but you still don't even get a spark, it's getting fuel... Please...


Hi, Hope I can help you.
I do not know how you have checked for spark, but lets start from the beginning.
Lets start with an ignition systems check.
1. I want you to remove the high voltage coil wire. ( That's the wire in the center of the distributor cap.) Using a good pair of insulated pliers. I want you to hold it about 1/4 inch from a good engine ground. Now you will need a bit of help from a partner. Get them to turn the key and crank the engine. You should see a bright blue and well defined spark. Ok, If you have spark I want you to slowly move the coil wire away from the engine ground. As you do this I want you to pay attention to the coil tower. (The coil tower is where the other end of the coil wire is attached.) What your looking for is arcing and sparking at the coil tower. If this happens then you need to replace the coil with a new one. If this does not happen then your coil is working fine, and we will have to move on.
Note if you do not get spark from the coil wire replace the coil.

2. Ok if you have spark now we have find out if the spark is making it to the spark plugs. How are we going to do this? By checking the rotor, distributor cap, spark plug wires and spark plugs.First lets remove the distributor cap. This will allow use to inspected the rotor and the distributor cap. What your looking for is, cracks, carbon tracks and wear at the tip of the rotor. On the distributor ,look inside the cap for cracks, carbon tracks and wear on the terminals. If you find any of this replace the distributor cap and rotor. ( Note if you have any doubt of the condition of the rotor or the cap replace them.) Next lets check your spark plug wires. Lets pull off one of the spark plug wires from the spark plug side. Now inspect the wire connection for a white crusty powder. If you find crust replace your wires. Now you should check all of them the same way, but if even one has corrosion replace them all. You are going to have to inspect the wire its self . Going down the whole length of the wire. Holes cracks burn Marks and other damage. Once again if you find any damage replace them all.
I hope this will help you and good luck to all the read this FixYa
leave feedback thank you

Feb 21, 2011 | 1992 Chevrolet C1500

1 Answer

What are all of the parts needed for a tuneup for my 95 quests


Spark plugs, spark plug wires, distributor cap, and distributor rotor. If you replace all of these you would be doing what is called a major tune-up.

A regular tune-up would be just replacing the spark plugs.

You can check the integrity of the plug wires and distributor cap by spraying them with water while the engine is running. If the engine runs ruff, stall, or you see spark arcing from either the wires or the distributor cap than they will need to be replaced.

The distributor rotor always gets replaced when you replace the distributor cap.

You can also spray the coil with soapy water to see if it is leaking as well.

Oct 02, 2010 | 1995 Nissan Quest

1 Answer

1994 Caprice Classic 5.7 running rich, chugging bad w/power loss. Replaced distributor cap, rotor, plugs, wires and coil. Runs better but not good.


Check the ignition timing. Sounds like it is running retarded ignition. Make sure the new parts you have replaced are the exact fitment for you vehicle and that they are fitted correctly. I had a nasty habit of fitting HT leads half on the spark plug and made the car run bad.

Vote for me if this helps you.

Jun 24, 2010 | Chevrolet Caprice Classic Cars & Trucks

4 Answers

I want to replace spark plugs (8) and wires on my '84 GMC pickup


get a 20 dollar haynes or chiltons manuel and find the module and coil. always change the ignition module and coil every 4 no more than -5 years to be safe.

Feb 10, 2010 | GMC Sierra 2500 Cars & Trucks

2 Answers

Weak spark from dist cap to plugs. spark from coil primary is as it should be. Plugs were carbon fouled from rich condition. this is a 92 bronco 5.8 windsor motor.changed out plugs,cap,rotor,and remote tfi...


The engine is definitely in an over rich fuel condition if you are blowing black smoke. I would suspect a bad 02 sensor, but the flooding condition you describe at starting could be other things. I would check the codes and proceed from there.

Jul 13, 2009 | 1992 Ford Bronco

3 Answers

Spark from coil but not from plugs


Hello;
Take the distributor cap off, and turn the engine over. Does the rotor turn? Then pull the #1 spark plug and with your finger over the spark plug hole , tap the engine over to top dead center. See where the rotor is pointing. Also check to ensure your points are opening and closing. With an ohm meter make sure you have continuity through the carbon for the coil in the cap. Hope it helps.
Thanks;
Rich
RPM Northwest

Mar 31, 2009 | Volvo 240 Cars & Trucks

Not finding what you are looking for?
1999 Plymouth Voyager Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...