Question about GMC Yukon

1 Answer

I have a 1995 GMC Yukon, last weekend my blower motor cut out than back on and since than I have not been getting any heat. I fluched the heater core, replaced the lines to the heater sore, sut the lines out for the rear heater core, still no heat. I have checked the temp going in and coming out of the heater sore, 20 degree difference. The t-stat seems to be workin fine. Checked the upper rad hose that goes to the t-stat its at 180 and the lower is around 155 to 160. I havwe forced the temp blend door to hot and still nothin. Please help I am driving myself bonkers trying to figure it out.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 4,977 Answers

If you have 20 degrees difference that is quite a bit of a difference.i would say that the heater core is plugging up,remember the fan blowing air across the core is cooling the temp more and with a 20 degree difference its alot.you can try to run CLR through it a couple of times to see if it will help flush out more dirt.sometimes flushing just doesn`t do it.

Posted on Apr 08, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 Yukon Denali no longer blows air from the front Front air vents


Do you know how to do automotive electrical testing ? Videos on youtube showing how to do it . Does your Yukon have manual or automatic Heater/AC system ? Could be the blower motor is bad , blower motor control module (if automatic ) Do you hear the blower motor running ? 2005 Chevrolet Tahoe Blower Not Working Chevy GMC same thing

Dec 04, 2016 | 2003 GMC Yukon Denali

1 Answer

GMC 2004 Envoy blows heat even with blower off ... Why ?


The relay in your blower motor is stuck on, there is a TSB for this issue. Replace the blower motor resistor and you'll be back in business.
How does the resistor get power if the fuse is pulled?
Replacing the resistor will cure both problems. TSB is a technical service bullitin seen below
Subject:HVAC Blower Motor May Run Continuously After Vehicle is Turned Off (Replace Blower Resistor Relay)Models:2004 Chevrolet Avalanche, Silverado, Suburban, Tahoe, TrailBlazer, TrailBlazer EXT2004 GMC Envoy, Envoy XL, Sierra, Yukon, Yukon XLwith Manual Control HVAC (RPO CJ3)Built Prior to August, 2003

Jun 04, 2013 | Cars & Trucks

1 Answer

05 YUKON REAR HEAT NOT WORKING


Rear heat not working ? The blower motor isn't working ? No air coming from the rear vent's ? Is it just a yukon or XL or denali ? What size engine ? 4.8 , 5.3 or 6.0 l Manual or automatic climate control ? Does the blower motor work on any speed ? The front an rear heater system are seperate , have there own electrical circuits . Could have a couple of different systems ,could have a control processor or relay's an a resistor block . Do you know how to test automotive electrical circuit's using a wiring diagram and a DVOM - digital volt ohm meter ? Plus to get at the rear heater-A/C unit you would need to take the right rear trim panel off .
2003 Tahoe No Rear Heat Fix Suburban Yukon XL Repair

Dec 08, 2017 | 2005 GMC Yukon

1 Answer

How do you remove the cover of the heater motor on a 1997 GMC yukon


Remove or disconnect:
Negative battery cable.
Instrument panel (I/P) compartment.
Front screw from right door sill plate.
Right hinge pillar trim panel.
Electrical connectors from ECM, as necessary.
Electrical connectors from blower motor, as necessary.
Bolt from right lower I/P support.
Blower motor cover.
Blower motor cooling tube.
Blower motor flange screws.
Blower motor.

Dec 04, 2010 | 1997 GMC Yukon

1 Answer

How to troubleshoot the electrical air conditioning system 2000 GMC Yukon Denali. I put in new resistor, relay and dealer blower motor and it still doesn't do anything. Air conditioning control switch...


The compressor on the air conditioner in my 2000 GMC Yukon XL went out last summer. Had it and the whole line replaced at a local air conditioning shop last fall. Used it little before cold weather. Warm weather this spring and no cold air. We could hear the compressor trying to kick in. The shop told us that the control console was bad and had to be replaced. They told us the part was on back order and did not know if they would be abel to get one any time soon. We took the Yukon into the local GM dealership. They told us that the high side fitting was bad and that the freon was very low and that they would have to deal with that first to check the system. Called back to the air conditioning shop and they said they had a console come in and they would put it in and check the high side fitting. I now have cold air and questions. Bought Yukon in 2005 used, had always had problem of not switching to cold air once the heater has been used. We were told changing the console should fix that. It has not changed. I feel like the console angle was a scam, that the system was just low on freon. Each shop was blaming the other for trying to scam me. And what can fix the heat to cold issue? If anyone has answers I would sure appreciate the knowledge.

Jul 02, 2010 | 2000 GMC Yukon Denali

1 Answer

Heater in 1993 Yukon quit working


check fuse first,
switch second,
blower motor resistor third,
blower motor last

Dec 27, 2009 | 1993 GMC Yukon

1 Answer

How do you change a blower motor


FOR THE YUKON FAMILY THE BLOWER MOTER IS ON THE RIGHT SIDE OF THE CAB PULL BACK THE PLASTIC COVER OR CUT IT OFF REMOVE THE 3 OR 4 SCREWS THAT HOLD IT IN PLACE CUT THE WIRE TO IT AND THEN REMOVE IT THE NEW BLOWER WILL HAVE TO BE WIRE TO THE WIRE THAT YOU CUT AND THEN SCREW THE BOLTS BACK AND YOU ARE DONE .........

Oct 01, 2009 | 1995 GMC Yukon

1 Answer

Fan blower stopped working on my 2006 yukon denali xl


check fuse,blower motor relay and blower resister(mounted in blower box) and blower motor

Jun 28, 2009 | 2006 GMC Yukon Xl Denali

2 Answers

GMC Yukon AC/Heater Blower


This is the problem with blower resistance in car change the blower motor resistor in the car ...


Good luck ...

Feb 23, 2009 | 2006 GMC Yukon

2 Answers

Heating problem


check under the passenger side at the air intake to see if it is pluged with some thing it might be behind the glove box when your looking there see if there is a cabin air filter behind the glove box in the black case there will be a slide out panel if there is

Dec 10, 2008 | 1995 GMC Yukon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...