Question about 1988 Chevrolet Cavalier Z24

1 Answer

At operational temp car stalls while stopping. new iac new plugs.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 75 Answers

If it's an automatic, it could be the torque converter solenoid. Symptoms are stalling when coming to a stop after reaching speeds of 40mph and above. If it restarts immediately then stalls after putting in gear, that's what it is.

Posted on Apr 13, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Durango Stalling


You may be experiencing a throttle body sensor problem or compression loss when engine comes up to temperature

Nov 15, 2015 | 2003 Dodge Durango

1 Answer

92 explorer stalls at stop light


I would suspect first the IAC especially from the age, I have a 94 that had similar issues and the IAC replaced cured them, here is a forum you might want to search IAC etc on:


http://www.explorerforum.com/forums/showthread.php?t=182050

If you decide to try to replace the IAC--two bolts and one plug and usully right at the top on the driver side where the throttle body is and a new one on EBAY cost me 31 with shipping.

Dec 18, 2012 | 1992 Ford Explorer

1 Answer

91 cutlas ciera 3.3l v6 backfires then stalls but starts back up


SOUNDS LIKE THE IGNITION MODULE OR COIL PACKS HEATING UP

Sep 12, 2012 | 1991 Oldsmobile Cutlass Ciera

1 Answer

My 1995 mustang 5.0 bucks and stalls. evap problem?


im having a sim issue guys.. my 95 auto. once it hits running temp it dies. checked at that temp no spark.. did the coil plugs wires dist.cap n rotor fpr purge sensor and egr sensor.

Feb 05, 2012 | Ford Mustang Cars & Trucks

3 Answers

Rough Idle when cold runs seems to run ok hot but still almost stalls when you turn on AC and you are at a stop also noticed that the volt meter reads 9v with the AC and the lights on with the AC and...


mcdevito75 here, Sounds like a faulty voltage regulator, it"s 1 unit with the alternator, change the alternator, also the alt. supplies juice to the ignition switch, distributor abd plugs, thus a rough idle due to bad alternator.

Jun 19, 2010 | 1994 GMC Suburban

1 Answer

2001 Chrysler Concorde lxi randomly stalling while slowly dow to stop or turn. Will usually crank back. This car will sit and idle for ever but when you drive it for 10-15 minutes and slow down to stop or...


Check the fuel filter on car for a restriction. Check the air filter for a restriction(dirty). also check the IAC valve (idle/air/control) located on the side of the throttle body. To check the iac valve, start the engine and disconnect the electrical plug from the iac. Listen for a change in the idle of the engine. then reconnect the plug to the iac valve and turn on the a/c and listen for the engine idle speed to change. If not then replace the iac valve. Hope this will help you.

May 12, 2010 | Cars & Trucks

1 Answer

91 GMC G2500 5.7L 350 Stalling when warm


You should try looking at the transmission fluide, it must be short. If it is, you should go buy a transmission fluid. And make sure you car pipes has no leak.

Jan 11, 2010 | GMC G2500 Cars & Trucks

1 Answer

Idled high, replace IAC and PCV, now idles low and stalls


On modern day cars the parts that get fitted need to be adapted to the ECM using a decent diagnostic machine. I bet that this was not done and the car is now suffering as a result.
Something to try is resetting the ECU, simply disconnect battery for 10 minutes, reconnect, then start car from cold *without touching gas pedal* and leave idling until the rad fan comes on (this resets all the base idle settings) then take it for a drive - hopefully will solve the problem

Nov 18, 2009 | 1990 Dodge Caravan

1 Answer

1995 saturn stalls when stopped in gear replaced temp sensor changed plugs,idles fine when in park.


I'd concentrate on IAC (idle air control) valve/motor . Removing it & cleaning with throttle body cleaner & port it comes out of, will sometimes cure problem, but if it happens again, replace it.

Jul 20, 2009 | 2001 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

260 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...