Question about 2000 Honda Accord

1 Answer

Problem starting my car

At times my car won't start with the first turn of the key but it will start after the second, third or more turns...what can this be? main relay,solenoid, or something more major?

Posted by on

  • shashankpal Aug 09, 2008

    today morning the car would not start i tried for 5-6 times , left it for 5mins then tried again it started with no problem. but evening again it gave me same problem and started after 5-6 tries. what can be the issue???

    i did my checks found , One thing , the car barely had coolant left. i topped it up with honda antifreeze. assumed that this was problem. but still gave me the same problem.

    Any help????

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 208 Answers

You have been initiated into the faulty main relay club. Check some of the other posts about this problem; it can be complicated. Also look under 1997 Honda Civic. The main relay is also a problem for them.

Posted on Aug 17, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my starter motor not engaging until the second or third time I turn the ignition?


-Starter Worn out internal contact.
-It's time to replace new one or rebuild.

Good luck

Mai

Sep 16, 2014 | 1997 Toyota 4Runner

1 Answer

My 2004 expedition will start it just takes 2-3 time turning the key, holding each time for a second or two?


try this turn key on but not to start position a couple times on third time try to start. if starts up your fuel pressure is droping off after shut down . ie fuel pressure regulater , leaking injector, fuel pump check valve ect

Aug 03, 2014 | Cars & Trucks

1 Answer

2004 cavalier won't start, need to reset anti-theft


the way i reset the antitheft is to put the key in the ignition and turn it on till all the dash lights come on but dont start it let it sit 15 minutes turn the key off and turn it on again till all the lights come on again repeat this procedure three times after the third time turn the key off for about 5 seconds and then your car should start hope this helps.

Mar 30, 2013 | 2004 Chevrolet Cavalier

1 Answer

Car won't start and arms alarm when I turn the ignition


Dead battery armed the security system. Remove the battery cable let the system reset. Charge the battery. Use the key to unlock the door instead of the keyless entry. This resets the alarm once the battery is charged.

Nov 01, 2012 | Volkswagen Cars & Trucks

1 Answer

When i start my car up and end up slowing down or at a stop, my car suddenly turns off?


Hi Reylene, Take the vehicle for a diagnostic scan and have the engine tuned. regards John

Dec 16, 2011 | 2001 Oldsmobile Aurora

1 Answer

Replaced stock bcm with used. Was reprogramming with the method of turning key to start position (vehicle won't start) then leaving it in the on postition for approx 10 minutes until the theft lock...


A used body control can be used in a vehicle other than the vehicle it was installed in. the body control module when first installed is programmed with the vehicle vin number. the vin number can not be changed was it was written to the BCM. the oprions can be always change in the BCM but not the VIN number. basically the used bcm you have installed has the vin number from the vehicle was installed in, now the vin number in the used BCM doesnt match all the other control modules

Jun 07, 2011 | Chevrolet Equinox Cars & Trucks

1 Answer

MY 98 FORD EXPLORER CRANKS BUT DOES NOT TURN OVER. I HAVE POWER BUT MY VEHICLE WON'T START


You mean that the starter is turning (cranks) the engine but the engine won't start? Be sure it is getting fuel. Turn the key to the on position and you should hear the fuel pump in the fuel tank run for a few seconds. If so that is good. If the fuel is being delivered then possibly you have no spark which usually is the electronic ignition module. The only way to test it is to replace it. Your timing chain or belt could be broken or "jumped" as the third possibility. I am leaning toward ignition module being bad as they just die without warning and nothing can revive them.

May 18, 2011 | 1998 Ford Explorer

1 Answer

Put a new lock switch in securty light is on does not start


With a new switch comes a new key. Gm has a relearn procedure. You must do this 3 times. Turn the key on, engine off, wait ten minutes, turn the key off for 5 seconds. After the third time start the car. remember to turn the key off after the third time or you will have to start over. just a note , if you have daytime running lights , pull the fuse or relay to save the battery. It would be marked DRL

May 07, 2011 | 1993 Buick LeSabre

1 Answer

I have a 2001 saturn sw and replace the ign and the secuirty light flashs and eng will not crank.i dissconnected the battery over night and still the same. thanks steve


Hello: Try this procedure, Turn key on attempt to start engine leave key on, the security light should be blinking, wait 10 minutes. The security light should be off. Turn key off for 10 seconds, turn key back on (DO NOT ATTEMPT TO START) wait another 10 minutes. Turn key off for 10 seconds. Do the procedure again as in step 2. At the end of the third time turn key off then ten seconds later attempt to start the car. It should start.

Nov 25, 2010 | 2001 Saturn SL

1 Answer

Batt went dead /recharged now security light stays on when ing is


You need to reprogram the security system. Hook up a battery charger. Turn the key on, the security light should flash. Leave the key on until the light stops flahing.(11 minutes) Turn the key off for 20 sec. Turn the key on, do the same thing a second time, turn the key off. Turn the key on. Do this a third time. After the third 11 minutes and the light is off, Start the truck.

Apr 08, 2009 | 1999 GMC Yukon

Not finding what you are looking for?
2000 Honda Accord Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

63456 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...