Question about Jeep Wrangler

1 Answer

I need to change the fuel pump on my 1994 jeep wrangler. I have siphoned the gas out of the tank. 1. Do I need to remove the hoses from the gas tank? 2. I can't find any diagrams for the location of the fuel pump or any videos that might help. If you know of any please share them with me.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,915 Answers

You need to drop the tank to get to the fuel pump-remove the filler neck first, then the straps-have a jack under the tank, remove the strap bolts and lower the tank (good to have help here), then you can disconnect the hoses and the electrical harness. the vehicle does not have to be raised to get the tank out, but it is a tight fit getting it out. there is a large plastic ring that holds the fuel pump in the tank, it needs to be tapped in a counterclockwise direction to get the pump and sender out, remove it carefully so as not to damage the sender unit. as a little extra bonus, if you want to have a higher capacity tank, there is a plastic tube located in the tank where the filler goes, just cut about 5-6 inches off it (it's plastic, use a razor blade) from the inside, the hole from the fuel pump gives enough room to do this. this is just a physical job, not hard to do just requires a little determination. make sure when you install the new pump it is sealed tight, install a new gasket when you do this swap.

Posted on Apr 08, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How To Drain Fuel Tank On 2005 Jeep Liberty Gas Tank


same as most cars like this....
the FSM book covers that.
it says to use drain a hose on the filler hose. (most cars)
and use siphon hose, or hand pump to hand pump it dry.

the dealer has 2 ways, using their scan tool , they open the system and turn on the fuel pump until dry. (fuel hoses to a bucket? after depressurizing steps, in the FSM stated.)
or they use a PRO grade, fuel draining system. that does this.

at home, you have 2 choices. a hose with siphon hose bulb.
or hot wire the pump. (risky making sparks with fuel; no?)

Oct 19, 2015 | Jeep Cars & Trucks

1 Answer

How can i empty gas out of my jeep so i can change the fuel pump?


gas or Diesel , ok gas.
why do that, the tank has and access cover.
see FSM ,, it shows these facts or alldata.com


siphon hose it out.
some filler necks at bottom near tank have check valve
making this very impossible
did you read the FSM on pump out ?

step 1, floor pan at rear
2: remove cover, and....

Aug 23, 2014 | 2002 Jeep Liberty

1 Answer

2005 dodge ram 1500 repair


remove a fuel hose under the car from the pump and siphon the fuel out of the tank

Apr 06, 2014 | 2005 Dodge Ram 1500

1 Answer

How do you remove the fuel pump on a 1990 Chevy Lumina APV?


The fuel pump is in the gas tank. Drive off or siphon out as much gas as you can. You will need to remove the filler hose. Drop the tank and remove the fuel lines on the top of the tank, Turn the ring counter clock wise that holds the siphon and pump in. Once the ring is loose, lift the the siphon and pump assembly out of the tank. The pump is on the bottom of the siphon. Replace, then reverse the process.

Jun 10, 2012 | 1990 Chevrolet Lumina APV

1 Answer

Please how change the gas pump to my jeep cheroque limited 94,v8


This is very easy you first need to disconnect the battery. remove as much fuel as you can from the fuel tank. you will need help to lower the tank down to a little to remove the fuel hoses and wires. after you have the tank on the ground take a screw driver and small hammer to remove the fuel sending unit locking ring. remove the sending unit be carefull not to bend the float remove the pump and reverse the same process

May 20, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Install a gas tank in a 94 toyota corolla


Raise the car.

Loosen the fuel filler neck rubber hose clamp. Remove hose from tank. Insert tubing into tank and siphon out all fuel.

Undo the brake line bracket blots and move brake lines out of the way.

Undo the exhaust to muffler flange bolts. Exercise extra care if they appear rusted as they will shear off.

Remove rear seat and undo fuel pump cover. Undo fuel pump bolts.
'
Disconnect the fuel and return lines.

Support tank with a jack. Undo tank strap bolts. Remove straps.

Lower tank and remove fuel pump.

Drop tank and slide out over exhaust.





Nov 02, 2009 | 1994 Toyota Corolla

1 Answer

1994 Jeep Wrangler hard to keep running


The fuel pump is located in the gas tank and the filter is right in front of the tank on the inside of the frame. I have never worked on that particular throttle body, but if it has a throttle position sensor, that could be what your problem is.

Jun 08, 2009 | 1994 Jeep Wrangler

2 Answers

Changing a fuel filter and fuel pump on 1994 Beretta


The fuel pump is inside the gas tank. The filter is next to the tank in-line of the fuel hose.

Feb 15, 2009 | 1994 Chevrolet Beretta

1 Answer

How to replace a jeep tj fuel tank?


I would be really careful with doing this repair as this is very dangerous. You need to relieve the fuel pressure by pulling the fuel pump fuse and starting the truck. Drain the tank with a siphon pump. Remove any exhaust or other parts that are in the way, loosen the straps and support the tank with a floor jack and a block of wood. There are several hoses, and a few wire connectors to disconnect and you may want to replace those hoses while you're down there. Once you put the new tank in, reconnect the electrical and hoses, raise the tank and strap it back up. Put anything else back together you took off the truck.
Personally, I would take this in to get fixed as this is dangerous work (I did mention that). I you do this anyway, use your head and buy a proper container to hold the gas in , as well as jackstands and a class "B" fire extinguisher. Disconnect the battery and don't smoke or use a drop light under the car, and I will not accept responsibility for this.

Dec 26, 2008 | 1983 Jeep CJ7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...