Question about 1995 Toyota Tercel

1 Answer

When the car starting and try to put on overdrive the engine stopped

Posted by on

  • herdezen Apr 08, 2011

    thanks for the solution #1,but the problem happen when the motor fan coming too and when I try running it through all gears. And the engine no stopped inmediately,becuase if push down the ecelerator the engine still running...

  • herdezen Apr 08, 2011

    thanks,but the problem happen when the motor fan colming too.And when I try running it all gears. And if I push the acelerator down the engine still running. I know the problem is electric but:WHERE?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,187 Answers

This could be several reasons why the car would stop. The solenoid may be bad (the electrical part that makes you change gears) or the speed sensor on the transmission. It could be electrical or mechanical in nature.

Have you tried running it through all gears without switching to over drive if it happens? Is your idle low or erratic or rough?

Does the car stall immediately or only at certain rpm or speed when you are on overdrive?

Thanks

Posted on Apr 08, 2011

  • Nicolo Carlo Parazo Apr 08, 2011

    THis may be an issue with a wiring. is this the fan for the air con or the radiator? . each of these fans has wires and sockets at one end. Try removing the one that coincides with the problem. I should warn you to do this test in a short while to prevent the engine from heating. If that did not work, put the socket back. Check the relays and the boxes. Terminals may have gone bad. If it i the wiring you will have to trace the wires from the relays and check for bad wires. Same goes with the wire on the shift selector inside the car.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Lexus not shifting into overdrive


Sorry dealer only ,sounds like a fault with electronics ,but i have no idea as please remember that when i studied motor vehicle technology the cars were made of metal ,had long stroke engines ,3 speed manual gearboxes and radios made with valves in them ,

Jan 13, 2015 | Lexus ES 300 Cars & Trucks

1 Answer

1993 cutless cierra, when driving, all is fine, then when you come to a stop sign, or a light, the engine cuts off. It will start immediately, but when you put it into gear, it cuts off. had to have it...


sounds like the lockup converter is not releasing when you stop, like stopping with a stick shift and not pushing in the clutch. lockup solenoid most likely. Could just disconnect the lockup sol. (won't lock up at all) or replace the solenoid.

Mar 17, 2017 | 1993 Oldsmobile Cutlass Ciera

1 Answer

93 Lumina 6cyl 3.1 engine shaking @ overdrive gear


check your camshaft and crankshaft sensors. When defective, it may cause stalls, misfires, loss of power. Also have check the engine for vacuum leaks. Hopefully this helps!!

Apr 14, 2010 | 1993 Chevrolet Lumina

2 Answers

The car starts but cuts off immediately and when the car comes to a stop it shuts off again.


"93 chevy lumina, starts good and will run for a little bit and then shuts off. or when i put it into gear it will shut off also. i have replaced the spark plugs,has new filters and used an injector cleaner. i hope you can help me figure out what is wrong with it. thanks

Nov 20, 2009 | 1993 Chevrolet Lumina

2 Answers

Hi,i have a 2004 hyundai accent.i noticed recently that when i drive on the free way with overdrive off, the car starts to get hot.it seems normal and i cant seem to have clue why this would happen.all...


When overdrive is off, your engine works harder to keep up the freeway speed. It could spin an extra 800 to 1200 rpm just to stay at the same speed as when od is on. This generates alot of heat. If you have one of the smaller engines it may just be your engine is working that hard. Or it may be you thermostat is goin out. When a thermostat goes bad it starts to open and close less when it gets hot, until it stops opening at all. This is when an engine overheats. If yours is starting to go, you may only notice it when od is off, and you are going down the freeway, because your engine is working so much harder at that time, than any other time you are driving it.

Sep 01, 2009 | Hyundai Accent Cars & Trucks

1 Answer

Auto transmission slips then grabs


first thing i would try is changing the transmission fluid out and filter, i beleive its almost 8 quarts. use a full quart of lucas transmission additive with the new fluid. if this doesn't help, the transmission will either need replaced or rebuilt

May 24, 2009 | 1996 Ford Probe

3 Answers

I have a 92GL, somestimes it will not shift into high gear(Drive 3 or what ever the top gear is). Somestimes it works fine. Car has 218000 miles on it. Any ideas to what might be causing this and/or the...


My car just had the same problem and i bought a over-drive bypass plate from IPD and now it works just fine, just put it on yesterday. My overdrive solenoid was the problem. So, instead of paying $160 for a new one, i paid $40 for the bypass plate. I drive a 91 Volvo 940 Turbo with over 250K miles and now i have my overdrive back. I think if your overdrive relay was bad, the shift light would come on on the dashboard. So it may just be your solenoid. Go to http://www.ipdusa.com/Volvo-940960/Transmission-&-Drive-Train/Automatic-Transmission/Automatic-Over-Drive-Solenoid-Bypass-Kit/p-136-278-676-1031/

May 04, 2009 | 1994 Volvo 940

1 Answer

Shifting


Try putting the trans in 3rd gear when going up hills.It's trying to get into overdrive & doesn't have enough power to maintain overdrive so it is kicking in & out of gear trying to keep up with the engine.your owners manual should tell you about being in overdrive while going up hils.Good luck,
ChevRev

Mar 20, 2009 | 1999 Chevrolet Venture

Not finding what you are looking for?
1995 Toyota Tercel Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...