Question about Isuzu Rodeo

1 Answer

I change the oil in my isuzu redeo and now it reves up high

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 44 Answers

Technically, there is no connection between an oil change and the vehicle's rpm settings. However, a disconnected vacuum line could affect engine idle. Even a loose oil filler cap can introduce air into the crankcase and pcv inlets. Please make sure that no vacuum hoses are cracked and/or disconnected. Try to "backtrack" and make certain that all electrical connectors to the idle air control motor and throttle position sensor were not loosened accidentally. Finally. check the accelerator cable linkage to the throttle body to make sure that the cable is not hung up.


I hope this helped,

Have a great day !!!

Posted on Apr 08, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New holland ts 120 oil pressure to high where is the pressure relieve valve situated? the oil pump is in the dif.


There is no relief valve on the oil pump.
The valve is on a housing near the oil filter
Normal pressure with HOT oil is 15 to 20 PSI at tick over and around 60 PSI when the engine is reved up
Note oil pressure can be as high as 90 psi with engine oil cold and engine reved up

Dec 12, 2016 | Cars & Trucks

1 Answer

LOCATION OF THE FLASHER ON 1997 ISUZU RODEO


The Yugo of Japan.
turns signals or warning light
it must not click now so you can't find it.

look for it here;?
alldata.com

www.scantool.net/software/alldata-diy-1-month-subscription.html

or buy a used FSM off ebay?
http://www.ebay.com/sch/i.html?_odkw=1997+isuzu+redeo+service+manaul&_from=R40&_osacat=0&_from=R40&_trksid=m570.l1313&_nkw=1997+isuzu+redeo+service+manaul&_sacat=0

get while still can , an not turned to DUST.?

Dec 30, 2014 | Isuzu Cars & Trucks

1 Answer

Why cant my car reach top speed. the reves also can not pass 1.5


sounds like you are either not getting enough fuel , re-prime the fuel filter, ck the air filter , take it out for a run and see if it makes a differance , a air filter will do this for sure, even new ones , oil filter should have no affect on the running of it at all ,either air or fuel problem with is ,

Sep 15, 2014 | Cars & Trucks

1 Answer

Wzz


There's a dot on the cam and a mark on the head turn the cam over with a ratchet and socket it should pop into place be sure to line up both cams one on each head and the bottom on the crank there's a mark on the pulley for the belt you should buy the timing belt kit it comes with new idler pulleys and you should also change the water pump while your in there it runs off the timing belt the new timing belt I put on had dots on it to help line up the timing marks

Apr 26, 2014 | 2001 Isuzu Rodeo

1 Answer

1998 isuzu redeo codes


This code means that the Oxygen sensor shows no activity. Check for exhaust leaks and intake air leaks test fuel pressure check fuel filter (plugged) all ok replace sensor oh bank 1 sensor 1

Apr 07, 2014 | Isuzu Rodeo Cars & Trucks

1 Answer

Automatic transmission takes to long to change gears, rev's going up to high before changing to the next gear. What could be the problem?


trans oil low level,oil presure to low or oil presure to high1st ajust the cable for trans or the bens front cluch.

Jun 04, 2012 | Isuzu Pickup Cars & Trucks

1 Answer

I HAVE A 1997 ISUZU REDEO IT SOME TIMES JUST CUTS OFF GOING DOWN THE ROAD FOR A SECOND THEN TAKES OFF AGAIN ONLY AFTER IT GETS HOT I HAVE CHANGED THE FUEL PUMP FLITER SPARK PLUGS AND WIRES


There is a component mounted to the front of the throttle body called an IAC (Idle Air Control) valve. It is held on by (2) screws and has an electrical connector plugged into it. That unit can clog up with carbon deposits and cause the car to idle incorrectly. Sometimes the car may idle high (in the 2500 RPM range), other times it may stall out when you come to a stop. If you take it out, be careful not to drop the O-Ring that goes around it.

You can take it off and brush clean it with kerosene (DO NOT submerge it or pull on the spring loaded pintle). See if it helps to correct the issue.

Autozone carries the replacement part for about $50. Changing it definitely improves symptoms of car surges, stall outs, and hard to start conditions.

Best regards,
Steve

May 25, 2011 | 1997 Isuzu Rodeo

1 Answer

Where is the transmission dipstick on 1995 Isuzu redeo?


There is no transmission dipstick. You have to both check and add fluid to these vehicles from underneath the vehicle. Find the transmission fluid pan and you will find two plugs. The lower plug will drain the pan and the upper one you can add fluid or check the fluid level. You will know that the level is correct when the plug is out and fluid barely leaks out of the hole. You don't want a lot coming out because you don't want to overfill. In order to get it into the hole you have to be some sort of tube to attach to the top of the bottle. They sell these types of tubes at your auto part store and they just screw on. It is very awkward, but you can actually put the bottle high enough to get the fluid in if you put it right to the left of the pan. The first time I did this on mine it was a pain but once you figure it out you will be good to go. Let me know if you have any other questions about your vehicle. Thanks for rating my response and for using FixYa!

Sep 05, 2009 | 1991 Isuzu Rodeo

1 Answer

98 isuzu redeo


check distribudor

Feb 06, 2009 | 1997 Pontiac Grand Am

1 Answer

Rear Axle Removal


rate me solved...this is all I can find...

figure 1

d164665.jpg

figure 2
c12dde8.jpg

defeae4.jpg

Jun 27, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...