Question about Ford Expedition

2 Answers

WHERE IS THE BLOWER MOTOR RESISTOR LOCATED ON A 2006 EDDIE BAUER EXPEDITOIN? mY A/C AND HEAT WILL ONLY BLOW ON THE HIGH SETTING. IT HAS CLIMATE CONTROL AND DUAL CONTROL FOR THE DRIVER AND PASSENGER SIDE.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 594 Answers

Located up stream from blower motor usually screwed in

Posted on Apr 08, 2011

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 373 Answers

I found this wiring schematic at: http://www.f150online.com/forums/articles-how-tos/385953-replace-04-08-fan-blower-motor-resistor-emtc-hvac-3.html
It looks like it is located under the dash on the passenger side, and appears to be pretty close to the blower motor. The resistor or controller is different if you have a climate control system vs. a manual temperature control.
Here is a possible picture of the climate control module:
WHERE IS THE BLOWER MOTOR - fs20301.jpg
121889953

Posted on Apr 08, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2009 Nissan Quest I can't turn the heat off. Just stays on a high level of blowing out heat .


If you have a fan that has different speed settings (1234, or low med high etc) and the only one that works is high - then the blower resistor pack has failed. If you have a climate control unit (where you just pick a temp you want) then the fan is controlled by the heating system and it sets fan speed. If you have climate control style try lowering the temp to a lower setting (current temp in vehicle) and see if fan slows down. If not then climate control unit or fan resistor bad. If dial type and you get nothing on lower settings (only high works like mentioned above) you need to change blower resistor. It is located under dash near the fan itself. Look for small unit bolted in duct near fan with wire plug going to it.

Feb 23, 2015 | Nissan Cars & Trucks

1 Answer

2007 ford expedition eddie bauer blower stuck on high


pull that switch from dash board and check the plug. make sure you have no burned or melted wires. maybe just the switch

Feb 02, 2013 | 2007 Ford Explorer Eddie Bauer

1 Answer

Why wont my a/c or heater fan come on?


When the blower works only on the high setting its usually a bad blower resistor which is right near the blower motor. now you say it would always blow high regardless of the fan speed setting that would indicate probably the climate control unit or a connector problem somewhere. finally it not working at all may be the climate control unit or connection went bad even further. it might have a blown fuse or a bad blower motor in addition to the climate control unit or connector problem .check for power and ground at the blower motor. the power is supplied from fuses and may have a relay also. the ground is supplied from the climate control unit and goes through the resistor to control the fan speed. good luck

Oct 30, 2011 | 1997 Lincoln Continental

1 Answer

Let's say when i want to use my a/c or heater at times the blower doesn't blow. so i leave the blower on a certain level,(usually high so i know when it kicks on) then it will work and other times mainly...


U need to replace the blower motor speed control resistor, it is located near the blower motor plugged into the air ducting for cooling of the resistor, it is held in by two screws

Oct 25, 2010 | Ford Explorer Cars & Trucks

1 Answer

My 99 Eddie Bauer Expedition blows cold air when


the heater is a long plastic box and the mixer door is inside of the box. The stepping motor controls the door.

Apr 15, 2017 | 1999 Ford Expedition

1 Answer

Blower motor resistor


Two bolts a little neck twisting 5 mins...
Look under the dash follow the wiring from the blower any two of them will lead you to the resistor. It's in the air box about.

Jul 27, 2009 | 2006 Toyota Tacoma

2 Answers

Blower motor 1995 ford explorer


if ur blower only came on the high fan speed i say it was ur blower resistor , but ur blower aint working at all so i would replace the blowerand the resistor cause they eventualy good out with when then the blower problems

Oct 27, 2008 | 1995 Ford Explorer

2 Answers

2002 Dodge Durango


blower motor resistor maybe why it only blows on high

Jun 25, 2008 | 2002 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

681 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...