Question about 1999 GMC Suburban

Open Question

How do you remove the valve cover on a 1999 gmc suburban? The ac unit prevents removal, What should I do

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: 1994 GMC Suburban front hub / bearing removal

Knock the wheel studs through the assy.

Posted on Jun 09, 2008

Ad
  • 101 Answers

SOURCE: removing valve cover toyota camry

You need to pull the plug wires up and out of their tubes. They can get stuck so twist them left and right to help loosen them first. The plugs are in the tubes. Use a 5/8 plug socket to remove them. Around the tubes you will see large flat nuts. You will need to remove all 4 of these. Also on the top timing belt cover there are 2 10mm head bolts you will need to back out at least 1/2 way for 2 reasons. 1 to free up the wire harness that crosses there and the bolts extend over the valve cover blocking its removal. Then with a screwdriver pry up the metal washers and rubber seals that were under the large flat nuts. The pcv valve needs to be pried out of the valve cover in the center and then the cover will come off.
Reverse to install.

Posted on Apr 20, 2009

  • 1986 Answers

SOURCE: 1986 gmc suburban door panel removal

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 335 Answers

SOURCE: 1999 chevrolet suburban: door panel removal

hello here is the instructions for removing the door panel.

  • Remove the door handle bezel.
  • Remove the window handle,.
  • Remove the power accessory switch panel.
  • Remove the trim panel upper extension
  • Remove the trim panel screws.




  • Remove the courtesy light,
  • Remove door panel screws.
  • Remove the trim panel from the door, carefully sliding the trim panel up to release the retainers from the door.
  • Remove the speaker wire.
  • 3470484.gif

    Posted on Jun 19, 2010

    roniecon
    • 6918 Answers

    SOURCE: have a 1999 GMC Suburban

    There is a actuator motor not working .The actuator motor moves the temp door,it is located on the bottom of the blower box,under the dash ,in the middle,it is a flat box,with three screws holding it on,change this out and the problem will be fixed.If this was at all helpful,please rate thank you.

    Posted on Aug 16, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    I have 2 air conditioner controls in my suburban do i have to charge 2 different a/c lines


    negative even though there are two air conditioning controls inside your suburban is still only one AC unit

    Jun 25, 2014 | 1999 GMC Suburban

    1 Answer

    Our front ac is not working and back is cold in our 1999 GMC suburban, we tried putting freon and it didn't work


    Dual zone front/rear ac systems have 2 evaporator cores. And 2 orifice tubes, which are just inline
    filters. Either your front evaporator core or orifice tube is probably stopped up.

    Sometimes you can get to the evaporator cores without removing them from the vehicle, and clean it.
    Evaporator cores do get stopped up sometimes, because the blower motor pulls in air with dust and debris from outside, and the air is cooled when it passes through the evaporator core.

    But evaporator cores are a nightmare to replace, you usually have to remove lots of stuff under the dash and lots of stuff under the hood to remove them.

    Aug 12, 2011 | 1999 GMC Suburban

    1 Answer

    How do you access the fuel pump for a 1999 GMC Suburban.


    you will have to drop the fuel tank to get access to the pump.you will have to remove all gas and vapour lines as well as electrical wires(plugs)as you drop the tank.its best to do this job with as little fuel in the tank as possible.you will have to support the tank with a jack and remove the tank straps then lower the tank.remove the sending unit lock ring and remove the unit form the tank,then you can see how to replace the pump.

    Jul 30, 2011 | 1999 GMC Suburban

    2 Answers

    How do you replace the fuel pump in a 1999 GMC 1/2 2WD Suburban?


    you need to remove the gas tank then remove lock ring on top of tank then the pump assy will come out

    Feb 10, 2010 | 1999 GMC Suburban

    2 Answers

    1999 GMC Surburban 5.7. Head gasket leaking on passenger side. Need step by step info on how to repair


    Buy a Chiltons or Clymers manual at your local parts store...it will have what you need
    Also there are special tools you will need for this job, make sure you have them.

    Sep 03, 2009 | 1999 GMC Suburban

    1 Answer

    Need to replace A/C compressor and hoses on 1999 GMC suburban C1500 5.8L V8 w/rear A/C. How do I do it and how much oil do I put in the new compressor?


    Oiling in ac system is complicated.

    why is the compresser being changed.

    What I normally do is remove the receiver / dryer (which MUST reread > MUST be replaced when the system is opened) cut it open, check for chemical issues with litmus strip.

    Typically, there is about one ounce in the reciever/dryer. If it is down to 1/2 ounce, for example, THE WHOLE system is down 50%.

    The easiest way to get it right is to remove the expansion valve and flush the system, then all all new oil.

    Really, this process shoudl be handled by a shop, with the right equipment to evacuate the moisture from the system.

    If you are trying to save money, mount the new compressor and do not install the the reciever /dryer until immediately before the system gets evacated.

    Sep 01, 2009 | 1999 GMC Suburban

    1 Answer

    1999 GMC Suburban. no sound from radio


    there is a plug at the back of the radio connecting it to the vehicle wiring loom. If you can get at thes plug, either from below or by removing the radio unit, make sure the plug is tight and secure. I can't think that the amp has gone or you would have lost all sound, so this is more than likely the problem.

    Jul 11, 2009 | 1999 GMC Suburban

    2 Answers

    I can't find the rear ac expansion valve on my 95 chevy suburban?


    Remove two trim panels from just inside back window and just inside rear side door passenger side. They run down from the head liner. Remove seat belt bolt ( TORX HEAD ) also. Remove lower half of trim from just inside rear side door. You should see screws holding weel cover in place. The top under glass just lifts up slightly to remove entire cover. Just a few more screws and you can hinge the top cover of the duct and fan. You will now see the top half of the rear condenser and if you look down beside it you will see the expansion valve. This about as close as you will get to changing the valve though because the freon lines running to the condenser will be stuck so solidly you would have to destroy the lines on either side of the nut to seperate them. You cannot reach the valve without lifting the condenser from its tray and you cannot lift the condenser without removing the lines from it!!! Good luck!!!

    Jun 06, 2009 | 1995 Chevrolet Suburban

    1 Answer

    Location for the PCV valve for a ''99 Suburban, with a 5.7 engine.


    It should look like this...maybe black now but, this is your pcv valve:

    44ddf5f.jpg

    Shouold be coming off of a black hose from your valve cover to your air cleaner (Positive Crankcase Ventilation valve).

    Mar 23, 2009 | 1999 GMC Suburban

    Not finding what you are looking for?
    1999 GMC Suburban Logo

    Related Topics:

    70 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top GMC Experts

    yadayada
    yadayada

    Level 3 Expert

    76846 Answers

    Freddy

    Level 3 Expert

    1311 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Are you a GMC Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...