-if the smoke came out after more than 5mins maybe when your try to drain the water (that has coolant) some of it spill on your cars engine or headers, this will cause a white smoke becasue of the heat that your engine generate the water evaporates
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
check for fluid leaks at hoses , pipes and brake callipers and cylinder units. Pull the vacuum hose off the booster and check for brake fluid in the hose. (wet). Repair the fault-replace calliper leaks, replace wheel cylinders , replace brake lines and replace the brake booster.
Fill with brake fluid and bleed out starting at the longest line first and finishing at the shortest.
I had my 2000 Concorde act up after washing the engine. Water at the spark plugs would let it start, but when the engine got warm the water vaporized and caused the miss. Check around the plugs, wires, and coil/s for moisture.
my 2003 sentra does the same thing and I have come to learn from other sentra drivers that its just something the sentra does. I have noticed that it will crank right away if you have the air/heat off and you press the break when cranking. Sometimes it even helps to continualsy pump the break to make sure it stay cranked.
The thermostat is located under the thermostat housing, which is on the engine, and what the upper radiator hose connects to. To remove the thermostat, you should : 1) start with a cool engine, 2) drain the coolant 3) disconnect upper radiator hose 4) unbolt thermostat housing. To install, reverse the process, but make sure you have a new gasket for the housing, and clean up the mating surfaces on both the housing and the engine.
Fuel injection systems remain under pressure after the engine has
been turned OFF. Properly relieve fuel pressure before disconnecting any
fuel lines. Also observe all safety practices outlined earlier in the
Fuel System Safety Precautions. Failure to do so may result in fire or
Following proper procedures, relieve fuel system residual
Disconnect the negative battery cable.
Drain the fuel tank.
Remove the rear seat cushion.
Remove the inspection cover.
Disconnect the fuel gauge and the fuel pump electrical harness
At the fuel filler door, disconnect the fuel filler tube from the
Raise and support the vehicle safely.
Disconnect the ventilation hoses.
Disconnect the fuel outlet, return and evaporation hoses, at the
front of the tank and plug the open fuel lines.
If equipped, remove the tank protector.
Support the tank, remove the fuel tank mounting bolts, and lower
the tank from the vehicle.
To install: If the sending unit or the fuel pump are removed, a new O-ring must
Install the fuel tank to vehicle and torque the mounting bolts to
20-26 ft. lbs. (27-37 Nm). If removed, install the fuel tank protector.
Connect all the fuel lines and ventilation hoses.
Lower the vehicle and connect the filler tube to the vehicle body.
Connect the fuel gauge and fuel pump electrical connections.
Install the inspection cover and rear seat cushion.
Pour fuel back into fuel tank.
Connect the negative battery cable.
Start engine and check for fuel leaks.
Fig. 5: Exploded view of the fuel tank components-1988-90 4WD
Fig. 6: Exploded view of the fuel tank components-1991-94
Fig. 7: Exploded view of the fuel tank components-1995-96
Hope this help (remember rated and comment this) TY for using Fixya.