Question about 2000 Chevrolet Tahoe

1 Answer

Where is the exhaust pressure sensor on tahoe 2000

Posted by on

  • Dave  C
    Dave C Apr 07, 2011

    It doesn't have a "pressure" sensor, are you sure you're not looking for the oxygen sensor?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

There isnt one... on any car... u talkin about a oxygen sensor?

Posted on Apr 07, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 tahoe o2 sensor, installed new o2 sensor but engine light stays on. code says bad


which sensor was replaced
there are 2 sensors involved
one after the cat converter and one in the exhaust manifold /pipe before the cat converter
the code will read the same for both

Apr 01, 2017 | 2007 Chevrolet Tahoe

Tip

?JCB FAULT CODES LIST


P0087 (flashing code 227) shared sump low pressure fault (for pump without pressure supply)
The main fault symptoms
• Engine severe vibration.
• idling unstable
• Output Fall
• exhaust smoke
• It may be too large output
P0088 (flashing code 118) shared the tank pressure is abnormally high (first or second stage)
The main fault symptoms
• Engine severe vibration
• idle instability
• Output Fall
• channeling gas engine failure
• exhaust smoke
• It may be too large output
P0089 (flashing code 151) shared the tank pressure failure (for pump pressure supply is too large)
The main fault symptoms
• Engine severe vibration
• idle instability
• Output Fall
• channeling gas engine failure
• exhaust smoke
• It may be too large output
P0090 (flashing code 247) SCV drive system open, + B short circuit or shorted to ground
The main fault symptoms
• Depending on the open / short situations, there may be an engine stall and / or launch
Machine channeling gas.
• exhaust smoke
• Output is too large
P0107 (flashing code 71) atmospheric pressure sensor circuit input low (open or shorted to ground)
The main fault symptoms
Due to spare the equivalent altitude 2000 m (6562 ft)
• exhaust smoke at high altitude.
• insufficient output at low altitude
P0108 (flashing code 71) atmospheric pressure sensor circuit input high (+ 5V shorted)
The main fault symptoms
Due to spare the equivalent altitude 2000 m (6562 ft)
• The high altitude exhaust smoke
• lack of low altitude output
P0112 (flashing code 22) intake air temperature sensor fault (low voltage fault, earth fault, short circuit)
The main fault symptoms
• When cold starting, may exhaust white smoke.

More here http://truckmanual.weebly.com/jcb-fault-codes.html

on Dec 20, 2016 | Cars & Trucks

1 Answer

Location of transmission sensor on a 2000 chevy tahoe


There is one sensor and several solenoids. The temperature sensor is the only sensor. The rest are solenoids. To replace the temp sensor, you have to remove or replace the valve body, depending on your expertise.

Oct 22, 2014 | 2000 Chevrolet Tahoe

1 Answer

Where can I get diagram of unerneath 1999chevrolet tahoe


Follow the exhaust pipe back from the engine. Somewhere along the way you'll find a device attached to the exhaust pipe with wires coming out of it & connecting to the wiring harness. That'd be an oxygen sensor. Find two - the rearmost one will be the one you're looking for..

Aug 02, 2014 | 1999 Chevrolet Tahoe

1 Answer

On a 2001 Tahoe what are the problems that can occur with low voltage on the fuel tank pressure sensor?


the fuel tank pressure sensor has nothing to do with driveability only emission. this code could be caused by a melted connector on top of fuel tank that is not uncommon in gm trucks in the 90-2000's

Jun 05, 2011 | 2001 Chevrolet Tahoe

2 Answers

My truck (2000 tahoe 2wd) feels like it is losing power


Hello chowhound196: My name is Roger and I will help you. First I would change the fuel filter. If you still encounter problems I would check the fuel pump pressure. You did not state what engine is in your truck . So for a 4.8 0r 5.3 v-8 engine the pressure should be 55-62 psi. key on engine off. on a 5.7 engine the pressure should be 60-66 psi. Any pressure less will cause the engine to loose power to a will not start problem.There is always the possibility that the exhaust converter may cause a problem or the computer could cause a problem. A quick check for codes or a check engine lamp on would be cause to check the ecm for codes. Should you need further help please just ask.Please rate the answer. This way I know it was helpful Thank You for using Fix Ya. Roger

May 15, 2010 | 2000 Chevrolet Tahoe

1 Answer

My service engine soon light came on displayin po170. i have a mitsubishi galant 2000. how do i fix this problem


PO170 is a fuel trim malufunction. On a V6 this applies to the rear cylinder head. Lots of possibilities as fu"el trim" refers to the volume air flow sensor, fuel injector, fuel pressure, engine coolant senor, air intake sensor, barometric pressure sensor, oxygen sensor, intake air leaks, or cracks in the exhaust manifold

Mar 03, 2010 | 2000 Mitsubishi Galant

1 Answer

Where are the oxygen sensors on my 2004 tahoe and installation


There are 4 o2 sensors.They are all on the exhaust system.There is one on the left side exhaust manifold pipe and one on the right exhaust manifold pipe.Then there is one in front of the catalytic converter and one in back of the converter.It would be better if you had the codes that they got because there can be other problems that can cause an o2 sensor to fail.Also I have never had all 4 sensors go bad at one time.You could have other problems.Vacuum leaks,plugged air filter,bad connections,or bad grounds.These vehicles are also good for intake gaskets being bad.Hope this helps.Good luck.

Jan 19, 2010 | 2004 Chevrolet Tahoe

1 Answer

Locating & replacing the MAP sensor in a 2000 Saturn SL-1


CODE PO133 IS HO2S - 11 BANK 1 SENSOR 1 SLOW RESPONSE CONDITIONS. POSSIBLE CAUSES THE EXHAUST LEAK PRESENT IN THE EXHAUST MANIFOLD OR PIPES.FUEL SYSTEM IS TOO RICH.FUEL PRESSURE TOO HIGH FUEL PRESSURE REGULATOR LEAKING OR ONE OR MORE FUEL INJECTORS.STICKING LEAKING.HO2S ELEMENT IS SILICON WATER OR FUEL CONTAMINATED OR IT FAILED.TP SENSOR ELEMENT BROKEN.CAN CAUSE FALSE ACCELERATION EVENT.OR THE PCM HAS FAILED.

Jan 12, 2010 | 2000 Saturn SL

1 Answer

Disgnostic code meaning


P0404 Exhaust Gas Recirculation Control Circuit Range/Performance
P0405 Exhaust Gas Recirculation Sensor “A” Circuit Low


It sounds like you have a failure of the EGR valve.

Sep 28, 2008 | 2000 Chevrolet Tahoe

Not finding what you are looking for?
2000 Chevrolet Tahoe Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...