Question about 2006 Jeep Commander

Open Question

How do i install front cv axle on a 2006 jeep commander

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 77202 Answers

SOURCE: Installing a cv joint axle

The trans side of the axle has a round spring clip on the drive splines it just snaps in and out of the transmission, they can be very difficult to remove, esp. the first time they are taken out, takes allot of brute strength. I would suggest you push the axle in, it will move inboard a little, then try to pull back in a snapping motion, another thing the axle need to be in as straight a line as possible.

Posted on Jul 28, 2008

Ad
greg_margo
  • 1959 Answers

SOURCE: Jeep Commander Rear Brake Pad Installation

Per Chilton Auto repair manual:

Removal & Installation

  1. Raise and safely support the vehicle.
  2. Remove the rear wheel.
  3. Siphon a small amount of brake fluid from the master cylinder reservoir.
  4. Insert a small prybar through the caliper opening and pry the caliper cover (using the outboard brake pad) to bottom the piston in the caliper bore.
  5. Remove the caliper slide bolts.
  6. Remove the caliper from the anchor.

    WARNING Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
  7. Remove the brake pads from the caliper.
To install:
  1. Install the brake pads onto the caliper.
  2. Lubricate the slide pin bolts with grease provided with the brake pads, or suitable silicon grease equivalent.
  3. Install the caliper on the anchor and tighten the slide pin bolts to 18 ft. lbs. (25 Nm).
  4. Install the rear wheel.
  5. Lower the vehicle.
  6. Pump the brake pedal several times until a firm pedal is obtained in order to properly seat the pads.
  7. Refill the brake fluid reservoir to the proper level.

Posted on May 17, 2009

germcelchar
  • 389 Answers

SOURCE: how do i remove cv axle for a 98 isuzu trooper

Go to my profile I have just explained how to change a cv boot on a Trooper. The axle needs to be taken out to change the boot so the same solution. What you call an axle I have refered to as a drive (short for driveshaft) It takes a lot of explaining so save me a lot of writing if you read the solution I gave for changing the CV boot. Cheer's

Posted on Sep 28, 2009

  • 10 Answers

SOURCE: installing cv axle on a 2004 impala

remove the tire, remove caliper and rotor remove 35mm nut and push cv joint into trans and remove

Posted on Dec 24, 2009

  • 645 Answers

SOURCE: ac/heater fan switch problem on a 2006 jeep commander

next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.

Posted on Feb 13, 2010

Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removal cv axle 2006 commander driver side


With vehicle on ground, loosen axle bolt then raise front end and secure on jack stands. Remove tires and other components which will give you access to axle.

Dec 19, 2016 | Cars & Trucks

1 Answer

Front outer cv boot does not fit axle. 2006 Impala 3.9.


You should be able to get a universal CV boot. Obviously, you would have to check the dimensions before buying it.

Have a look on Ebay. A supplier of CV boots should be able to sort one out for you.

impala cv boot

Mar 29, 2016 | 2006 Chevrolet Impala

1 Answer

How to replace 2006 ford escape left front axle shaft


How to Replace a CV Axle on a Ford Escape / Mazda ...

? 9:41
https://www.youtube.com/watch?v=_JxagNLBlQ4
Aug 29, 2013 - Uploaded by klowny1969
Axle nut should be torqued to spec..in the ford escape its around 205-220 lbs ft How To Change An Axle On A Front Wheel Drive Car ! SUBSCRIBE ! ... How to Replace a Front Axle Half Shaft - Duration: 14:37. ... Alternator replacement 2005 2006 Ford Escape 3.0L DOHC All Wheel Drive - Duration: 13:15.

Front axle replacement Ford Escape 2003 Right front CV ...

? 8:46
https://www.youtube.com/watch?v=JQK8SPj6Qsk
Mar 29, 2014 - Uploaded by Fixing cars and stuff
Front axle replacement Ford Escape 2003 Right front CV axle install remove replace This Channel provides ...

Feb 03, 2016 | Ford Cars & Trucks

2 Answers

Jeep Commander Problems 2006 jeep commander makes grinding noises on left front side.comes and goes emission light comes on and goes out.


Check wheel bearings for condition and adjustment as the disc may be touching the brake calipers.

Oct 26, 2013 | Cars & Trucks

1 Answer

Can you conver front axel u joint type to a cv joint type on an 95 jeep grand charokee lorado


I owned a 93 GC 4x4 and I did replace my front axles with CV joint axles. The new axles came with CV joints, with a rubber boot and all so yes you can.

Sep 09, 2012 | 1995 Jeep Grand Cherokee

1 Answer

1996 Jeep Grand Cherokee Laredo 4X4 4.0L. Just recently bought and there's a popping noise in the front and when turning sharply it's like the wheels lock and the jeep refuses to move and it's also...


sounds like a bad cv joint in one (or both) of the front axles. is the popping sound more prevalent when in reverse, with the wheel turned? if so, i'd assume that it is a bad cv joint and one or both front axles will need to be replaced.

Feb 05, 2010 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
2006 Jeep Commander Logo

Related Topics:

999 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...